5
Lower Display Maintenance
Only use a microfiber cloth to clean the lower display.
For more information, refer to the “Appearance and care (section 7)” of your Owner’s Manual.
Fuel-filler Door
The fuel-filler door is located on the rear
passenger’s side of the vehicle.
Make sure that at least the driver’s door is unlocked.
Push and release the rear of the fuel-filler door (in
the middle) to open.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
Loose Fuel Cap
A LOOSE FUEL CAP warning message will appear in
the vehicle information display 1 when the
fuel-filler cap is not tightened correctly.
To tighten, turn the cap clockwise until a single click
is heard.
The warning message will extinguish when the
vehicle detects the fuel-filler cap is properly
tightened and the
or button 2 on the
steering wheel is pressed.
If the cap is not properly tightened, the Malfunction
Indicator Light
may illuminate.
For more information, refer to the “Instruments and controls (section 2)” and the “Pre-driving checks and adjustments (section
3)” of your Owner’s Manual.
1
2
Active Lane Control (if so equipped)
Active Lane Control slightly corrects front tire angles and steering whe\
el to rque, allowing
the driver to make fewer steering wheel corrections.
Active Lane Control is active when:
•
The vehicle is driven at speeds of approximately 45 mph (70 km/h) and \
above.
•
The Lane Departure Prevention and Active Lane Control systems are enable\
d in the
“Settings” menu.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
1967179_16b_Q50_US_QRG_012916.indd 51/29/16 1:52 PM
7
Clock Set/Adjustment
To adjust the time and the appearance of the clock on
the display:
1.
Press the
MENU button under the lower display.
2.
Touch the “Settings” key.
3.
Locate and touch the “Clock” key.
The following settings can be adjusted:
On-Screen Clock : Set the clock display to “ON” or “OFF”. When this item is \
on, the clock
display appears.
Daylight Savings Time: The application of Daylight Savings Time can be turned to “ON”, \
“OFF” or “AUTO”.
Clock Format (24h) : The clock can be set to 12-hour or 24-hour format. When the indicator \
light illuminates, the clock is set to the 24-hour format.
Time Zone : Adjust the time zone. Choose a time zone from the available list. Pres\
s the
button to return to the previous screen.
Offset Adjustment : The time can be adjusted forward or backward by minutes 1
and/or hours 2. The current clock time can be set up to a difference of 12 hours
and 59 minutes.
For more information, refer to the “Getting Started (section 2)” of your InTouch Owner’s Manual.
1
2
1967179_16b_Q50_US_QRG_012916.indd 71/29/16 1:52 PM
