2016 Hyundai Creta body

7-36
Maintenance
Recommended engine coolant
• Use only soft (distilled) water in thecoolant mixture.
• The engine in your vehicle has alu minum engine parts and must be
protected by an ethyleneglycol
based coolant to prevent corrosion
and freezing.
• DO NOT USE alcohol or methanol coolant or mix them with the spec
ified coolant.
• Do not use a solution that contains more than 60% antifreeze or less
than 35% antifreeze, which would
reduce the effectiveness of the
solution.
For mixture percentage, refer to the
following table.
Changing the coolant
We recommend that the coolant be
replaced by an authorized HYUNDAI
dealer.
Put a thick cloth or fabric around the
radiator cap before refilling the
coolant in order to prevent the
coolant from overflowing into engine
parts such as the alternator.
NOTICE
AmbientTemperature
Mixture Percentage (volume)
AntifreezeWater
15°C (5°F) 35 65
25°C (13°F) 40 60
35°C (31°F) 50 50
45°C (49°F) 60 40
•Do not use radiator coolant or
antifreeze in the washer fluid
reservoir.
•Radiator coolant can severely
obscure visibility when sprayed on
the windshield and may cause
loss of vehicle control or damage
to paint and body trim.
WARNING

7-38
Maintenance
Do not allow brake/clutch fluid to
contact the vehicle's body paint, as
paint damage will result.
Brake/clutch fluid, which has been
exposed to open air for an extended
time should never be used as its
quality cannot be guaranteed. It
should be properly disposed. Don't
put in the wrong kind of fluid. A few
drops of mineralbased oil, such as
engine oil, in your brake/clutch sys
tem can damage brake/clutch system
parts.
NOTICE
Brake/clutch fluid
When changing and adding
brake/clutch fluid, handle it care
fully. Do not let it come in contact
with your eyes. If brake/clutch fluid
come in contact with your eyes,
immediately flush them with a
large quantity of fresh tap water.
Have your eyes examined by a
doctor as soon as possible.
WARNING

7-39
7
Maintenance
WAShER FluId
Checking the washer fluid level
Check the fluid level in the washer
fluid reservoir and add fluid if neces
sary. Plain water may be used if
washer fluid is not available.
However, use washer solvent with
antifreeze characteristics in cold cli
mates to prevent freezing. Do not use engine coolant or
antifreeze in the washer fluid reser
voir.
Checking the parking brake
Check the stroke of the parking
brake by counting the number of
“clicks’’ heard while fully applying it
from the released position.
Also, the parking brake alone should
securely hold the vehicle on a fairly
steep grade. If the stroke is more or
less than specified, we recommend
that the system be inspected by an
authorized HYUNDAI dealer.
Stroke : 6~8 “clicks’’ at a force of 20
kg (44 lbs, 196 N).
NOTICE
OGS075007
OGS075008
•Engine coolant can severely
obscure visibility when sprayed
on the windshield and may
cause loss of vehicle control or
damage to paint and body trim.
•Windshield Washer fluid agents
contain some amounts of alco
hol and can be flammable under
certain circumstances. Do not
allow sparks or flame to contact
the washer fluid or the washer
fluid reservoir. Damage to the
vehicle or occupants could
occur.
•Windshield washer fluid is poi
sonous to humans and animals.
Do not drink and avoid contact
ing windshield washer fluid.
Serious injury or death could
occur.
WARNING
PARKING BRAKE

7-56
Maintenance
Wheel replacement
When replacing the metal wheels for
any reason, make sure the new
wheels are equivalent to the original
factory units in diameter, rim width
and offset.
Replacing tires
To reduce the chance or serious
or fatal injuries from an accident
caused by tire failure or loss of
vehicle control:
•Replace tires that are worn,
show uneven wear, or are dam
aged. Worn tires can cause loss
of braking effectiveness, steer
ing control, and traction.
•Do not drive your vehicle with
too little or too much pressure in
your tires. This can lead to
uneven wear and tire failure.
•When replacing tires, never mix
radial and biasply tires on the
same car. You must replace all
tires (including the spare) if mov
ing from radial to biasply tires.
(Continued)
(Continued)
WARNING •Using tires and wheel other than
the recommended sizes could
cause unusual handling charac
teristics and poor vehicle con
trol, resulting in a serious acci
dent.
•Wheels that do not meet
HYUNDAI's specifications may
fit poorly and result in damage to
the vehicle or unusual handling
and poor vehicle control.
•The ABS works by comparing
the speed of the wheels. Tire
size can affect wheel speed.
When replacing tires, all 4 tires
must use the same size original
ly supplied with the vehicle.
Using tires of a different size can
cause the ABS (Antilock Brake
System) and ESC (Electronic
Stability Control) to work irregu
larly. (if equipped)
A wheel that is not the correct size
may adversely affect wheel and
bearing life, braking and stopping
abilities, handling characteristics,
ground clearance, bodytotire
clearance, snow chain clearance,
speedometer and odometer cali
bration, headlight aim and bumper
height.
WARNING

7-69
7
Maintenance
Inner Compartment Fuse Panel
ITEMNameSymbolFuse RatingCircuit Protected
FUSE
RR HTD30ARear Defogger Relay, Rear Defogger
TURN15ABody Control Module
SPARE20A
DOOR LOCK20ADoor Lock/Unlock Relay, Door Actuator, Tail Gate Unlock Relay, Tail Gate Latch
PDM115ASmart Key Control Module
WASHER15AMulti Function Switch
A/CON10AAir Condition Module(Manual, Auto), Cluster Ionizer, Blower Relay
MODULE 502'8/(
10AElectronic chromic mirror, Head lamp leveling Switch, Head Lamp LH/RH
MODULE 402'8/(
10ASmart key Control Module, Body Control Module
SPARE20A
SPARE20A
PDM 22210ASmart Key Control Module
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)

7-70
Maintenance
ITEMNameSymbolFuse RatingCircuit Protected
FUSE
BRAKE
SWITCH10AStop Lamp Switch, Smart Key Control Module
HTD IND10AA/C Control Module (Manual, Auto), G4FC : ECU(MT), PCU(AT)
BLOWER110AAC Control Module (Auto)
REAR WIPER10ARear Wiper Motor, Rear Wiper Relay
SPARE10A
SPARE15A
MEMORY10ADigital Clock, Body Control Module, AC Control Module (Auto, Manual), Cluster,
Outside Mirror Folding , OBD
MULTIMEDIA20AAudio
SPARE10A
C_LIGHTER20ACigar lighter (Export only)
INTERIOR LP 10ARoom Lamp, MAP Lamp, Luggage Lamp
BLOWER SIGNAL210AAC Control Module (Manual)
SPARE20A
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)

7-71
7
Maintenance
ITEMNameSymbolFuse RatingCircuit Protected
FUSE
ACCACC10AAudio, Body Control Module, P/OUTLET Relay, Digital Clock, Smart Key Module,
Outside Mirror Switch
P/Seat 30APower Seat(Export only)
P/WINDOWRHRH25APower Window Main Switch RH(Front, Rear)
POWER
OUTLET POWER
OUTLET
FR20AFront Power Outlet
TCU15AM/T : Vehicle Speed Sensor, Back Up Lamp Fuse
A/T : Inhibitor Switch, TCU
MODULE 2MODULE
210ABody Control Module, Sports Mode Switch(A/T), Stop Switch (NC)
MODULE 3MODULE
310AA/C Control Module(Manual/Auto), Body Control Module(Static Bending LP Power),
ATM Lever Indicator (A/T)
MODULE 1MODULE
110ARear Parking Sensor
MDPS10AMDPS Unit
AIRBAG INDIND10AInstrumental Cluster
SAFETY
P/WINDOWSAFETY25ADriver Safety Power Window Module
P/WINDOW LHLH25APower Window Main Switch LH(Front Rear)
* G4FC : Gamma 1.6 (Gasoline), D4FC : UII 1.4 (Diesel), D4FB : UII 1.6 (Diesel)

7-85
7
Maintenance
Outside light
1. Open the tailgate
2. Loosen the light assembly retaining screws with a crosstip screw
driver.
3. Remove the rear combination light assembly from the body of the
vehicle. 4. Remove the socket from the
assembly by turning the socket
counterclockwise until the tabs on
the socket align with the slots on
the assembly.
5. Remove the bulb from the socket by pressing it in and rotating it
counterclockwise until the tabs on
the bulb align with the slots in the
socket. Pull the bulb out of the
socket.
Inside lamp
Backup light/Tail light
1. Turn off the engine.
2. Open the tailgate.
3. Remove the service cover using a flatblade screwdriver.
OGC074046
Stop/Tail
Turn signal
Back upTailOGC074026
OGC074027
OGC074028
OGC074029