2016 Hyundai Creta brake fluid

7-37
7
Maintenance
BRAKE/CluTCh FluId (IF EquIPPEd)
Checking the brake/clutch fluid
level
Check the fluid level in the reservoir
periodically. The fluid level should be
between MAX (Maximum) and MIN
(Minimum) marks on the side of the
reservoir. Before removing the reservoir cap
and adding brake/clutch fluid, clean
the area around the reservoir cap
thoroughly to prevent brake/clutch
fluid contamination. If the level is low,
add fluid to the MAX (Maximum)
level. The level will fall with accumu
lated mileage. This is a normal con
dition associated with the wear of the
brake linings and/or clutch disc (ifequipped).
If the fluid level is excessively low, we
recommend that the system be
checked by an authorized HYUNDAI
dealer.
Use only the specified brake/clutch
fluid. (Refer to “Recommended lubricants or capacities” in chapter 8.)
Information
Before removing the brake/clutch fil
ter cap, read the warning on the cap.
Information
Clean filler cap before removing. Use
only DOT3 or DOT4 brake/clutch
fluid from a sealed container.i
i
Loss of brake fluid
In the event the brake system
requires frequent additions of
fluid, we recommend that the sys
tem be inspected by an authorized
HYUNDAI dealer.
WARNING
OGS075006
OGS075006L
■ Right Hand Drive
■Left Hand Drive

7-38
Maintenance
Do not allow brake/clutch fluid to
contact the vehicle's body paint, as
paint damage will result.
Brake/clutch fluid, which has been
exposed to open air for an extended
time should never be used as its
quality cannot be guaranteed. It
should be properly disposed. Don't
put in the wrong kind of fluid. A few
drops of mineralbased oil, such as
engine oil, in your brake/clutch sys
tem can damage brake/clutch system
parts.
NOTICE
Brake/clutch fluid
When changing and adding
brake/clutch fluid, handle it care
fully. Do not let it come in contact
with your eyes. If brake/clutch fluid
come in contact with your eyes,
immediately flush them with a
large quantity of fresh tap water.
Have your eyes examined by a
doctor as soon as possible.
WARNING

7-39
7
Maintenance
WAShER FluId
Checking the washer fluid level
Check the fluid level in the washer
fluid reservoir and add fluid if neces
sary. Plain water may be used if
washer fluid is not available.
However, use washer solvent with
antifreeze characteristics in cold cli
mates to prevent freezing. Do not use engine coolant or
antifreeze in the washer fluid reser
voir.
Checking the parking brake
Check the stroke of the parking
brake by counting the number of
“clicks’’ heard while fully applying it
from the released position.
Also, the parking brake alone should
securely hold the vehicle on a fairly
steep grade. If the stroke is more or
less than specified, we recommend
that the system be inspected by an
authorized HYUNDAI dealer.
Stroke : 6~8 “clicks’’ at a force of 20
kg (44 lbs, 196 N).
NOTICE
OGS075007
OGS075008
•Engine coolant can severely
obscure visibility when sprayed
on the windshield and may
cause loss of vehicle control or
damage to paint and body trim.
•Windshield Washer fluid agents
contain some amounts of alco
hol and can be flammable under
certain circumstances. Do not
allow sparks or flame to contact
the washer fluid or the washer
fluid reservoir. Damage to the
vehicle or occupants could
occur.
•Windshield washer fluid is poi
sonous to humans and animals.
Do not drink and avoid contact
ing windshield washer fluid.
Serious injury or death could
occur.
WARNING
PARKING BRAKE

8-6
Specifications & Consumer information
LubricantVolumeClassification
Brake/Clutch fluid 0.7~0.8
l
(0.74~0.85 US qt.) FMVSS116 DOT3 or DOT4
Fuel55
l(58.12 US qt.)
*1
: Refer to the recommended SAE viscosity numbers on the next page.
* 2
: Engine oils labeled Energy Conserving Oil are now available. Along with other additional benefits, they contribute to fuel econ
omy by reducing the amount of fuel necessary to overcome engine friction. Often, these improvements are difficult to measure
in everyday driving, but in a year’s time, they can offer significant cost and energy savings.
* 3
: If the ACEA A5 engine oil is not available in your country, you are able to use API SM & ILSAC GF4 or above (Except Middle
East).
* 4
: If the ACEA B4 engine oil is not available in your country, you are able to use API CH4 or above.