2016 HONDA CIVIC COUPE steering wheel adjustment

4
Quick Reference Guide
Quick Reference Guide
Visual Index
❙Ignition Switch*
(P143)
❙ENGINE START/STOP Button *1
(P144)
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
❙Tire Pressure Monitoring System
(TPMS) Button*
(P440)
❙Information Display *
(P106)
❙System Indicators (P74)
❙Gauges (P105)
❙Collision Mitigation Braking System TM

(CMBS TM
) OFF Button *
(P456)
❙ (Vehicle Stability Assist (VSA ®)
System OFF) Button (P436)
❙Road Departure Mitigation (RDM)
Button*
(P425)
❙Navigation System *

() See the Navigation System Manual
❙Audio System (P195, 213)
❙Hazard Warning Button
❙Rear Window Defogger (P155)
❙Heated Door Mirror Button *
(P155)
❙Climate Control System (P179)
❙Seat Heater Buttons*
(P178)
❙Steering Wheel Adjustments (P156)
❙Driver Information Interface*
(P109)
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 4 ページ >0>.>/６年>0月>/>0日　金曜日　午後４時>/６分

15
Quick Reference Guide
Steering Wheel (P 156)
● To adjust, pull the adjustment lever
towards you, adjust to the desired
position, then lock the lever back in place.
Unlocking the Doors
from the Inside (P 126)
● Pull either door inner handle to unlock
and open it at the same time.Trunk (P 133)
● To unlock and open the trunk:
• Press the trunk release button on the
driver’s door.
• Press the trunk release button on the
remote transmitter or the smart entry
remote.
• Press the trunk release button *
on the
trunk lid.
Power Door Mirrors
(P 158) ● With the ignition switch in ON
(w*1
, move
the selector switch to L or R.
● Push the appropriate edge of the
adjustment switch to adjust the mirror.
Trunk Release Button
Selector Switch
Adjustment Switch
Power Windows (P 139)
● With the ignition switch in ON
(w*1
, open
and close the power windows.
● If the power window lock button is in the
off position, the passenger’s window can
be opened and closed with its own switch.
● If the power window lock button is in the
on position (indicator is on), the
passenger’s window switch is disabled.
*1:Models with the smart entry system have an ENGINE START/STOP button
instead of an ignition switch.
Power Window Lock Button
Window
Switch Indicator
*
Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 15 ページ >0>.>/６年>0月>/>0日　金 曜日　午後４時>/６分

152
uuOperating the Switches Around the Steering WheeluWipers and Washers
Controls
Wipers and WashersThe windshield wipers and washers can be
used when the ignition switch is in ON
(w*1
.
■ MIST
The wipers run at high speed until you release the lever. ■ Wiper switch (OFF, INT *
, LO, HI)
Change the wiper switch setting according to
the amount of rain.
■ AUTO *
2 Automatic Intermittent Wipers *
P. 153
■ Adjusting wiper operation *
Turn the adjustment ring to adjust the wiper
delay. ■ Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
then stop.
*1: Models with the smart entry system have an ENGINE START/STOP button instead of an
ignition switch.
■Windshield Wiper/Washer1Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get sc ratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in th is condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens. When the vehicle starts moving, the
wipers make a single sweep.
When the vehicle speeds up, the wiper operation’s shortest
delay setting ( ) and the LO setting become the same.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
The wiper motor may stop motor operation
temporarily to prevent an overload. Wiper operation
will return to normal within a few minutes, once the
circuit has returned to normal.
If the wiper stops operating due to any obstacle such as
the build-up of snow, park the vehicle in a safe place.
Rotate the wiper switch to OFF, and turn the ignition
switch to ACCESSORY (q or LOCK (0*1
, then
remove the obstacle.
Models with adjustment ring
All models
Intermittent Time Adjustment Ring *
MIST INT *
:
OFF LO
: Low speed wipe
HI : High speed wipe Pull to use washer.
Low speed with intermittent
Auto *
: Automatic intermittent
operation
Lower speed, fewer sweeps
Higher speed, more sweeps
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 152 ページ >0>.>/６年>0月>/>0日　 金曜日　午後４時>/６分

153
uuOperating the Switches Around the Steering WheeluWipers and Washers
Controls
When you push the lever down to AUTO, the
windshield wipers sweep once, and go into
the automatic mode.
The wipers operate intermittently, at low
speed, or at high speed and stops in
accordance with the amount of rainfall the
rainfall sensor detects.
■ AUTO sensitivity adjustment
When in AUTO, you can also adjust the
rainfall sensor sensitivity using the intermittent
time adjustment ring.
Sensor sensitivity
■Automatic Intermittent Wipers *1Automatic Intermittent Wipers
*
The rainfall sensor is in the location shown below.
AUTO should always be turned OFF before the
following situation: • Cleaning the windshield
• Driving through a car wash
Sensor
Adjustment Ring
Low sensitivity:
Wipers will operate when more
rainfall is detected.
High sensitivity:
Wipers will operate when less
rainfall is detected.
* Not available on all models
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 153 ページ >0>.>/６年>0月>/>0日　 金曜日　午後４時>/６分

156
uuOperating the Switches Around the Steering WheeluAdjusting the Steering Wheel
Controls
Adjusting the Steering Wheel
The steering wheel height and distance from your body can be adjusted so that you
can comfortably grip the steering wheel in an appropriate driving posture.1.Pull the steering wheel adjustment lever up.
uThe steering wheel adjustment lever is
under the steering column.
2. Move the steering wheel up or down, and
in or out.
uMake sure you can see the instrument
panel gauges and indicators.
3. Push the steering wheel adjustment lever
down to lock the steering wheel in position.
uAfter adjusting the position, make sure
you have securely locked the steering
wheel in place by trying to move it up,
down, in, and out.
1Adjusting the Steering Wheel
Make any steering wheel adjustments before you
start driving.
3WARNING
Adjusting the steering wheel position while
driving may cause you to lose control of the
vehicle and be seriously injured in a crash.
Adjust the steering wheel only when the
vehicle is stopped.
To adjust
To lock Lever
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 156 ページ >0>.>/６年>0月>/>0日　
金曜日　午後４時>/６分

159
Continued
Controls
Adjusting the Seats
Front Seats
Adjust the driver’s seat as far back as possible
while allowing you to ma intain full control of
the vehicle. You should be able to sit upright,
well back in the seat and be able to
adequately press the pedals without leaning
forward, and grip the steering wheel
comfortably. The passenger’s seat should be
adjusted in a similar manner, so that it is as far
back from the front airbag in the dashboard
as possible.
1Adjusting the Seats
The National Highway Traffic Safety Administration
and Transport Cana da recommend that drivers allow
at least 10 inches (25 cm) between the center of the
steering wheel and the chest.
Always make seat adjustments before driving.
3WARNING
Sitting too close to a front airbag can result
in serious injury or death if the front
airbags inflate.
Always sit as far back from the front
airbags as possible while maintaining
control of the vehicle.
Move back.
Allow sufficient
space.
16 CIVIC 2D HC２ (０A ０１ ０C)-31TBG6000.book 159 ページ >0>.>/６年>0月>/>0日　
金曜日　午後４時>/６分