5
A. Seat Fore/Aft Adjustment
Lift the handle under the front of the seat to manually slide the seat forward or rearward .
B. Seat Height Adjustment
Press the vertical control to raise or lower the seat .
C. Lumbar Adjustment
Press the horizontal control to adjust the amount of lumbar support .
D. Seatback Recline Adjustment
Lift the lever to manually recline or raise the seatback .
Manual Driver’s Seat
Power Driver’s SeatFA. Seat Adjustment
Move the front horizontal control to move the seat forward or rearward and to raise, lower or tilt the seat .
B. Seatback Recline Adjustment
Move the vertical control to recline or raise the seatback .
C. Lumbar Adjustment
Press the rear horizontal control to adjust the amount of lumbar support .
Memory Driver’s SeatF
Set Memory Positions
1 . Adjust the driver’s seat and power outside mirrors to the desired position .
2 . Press and hold the MEM button and button 1 on the outboard side of the
driver’s seat until a beep sounds .
3 . Repeat these steps using button 2 for a second driver .
Recall Memory Positions
Press and hold button 1 or 2 until the memory position is reached .
Note: To change the memory recall and exit settings, go to Comfort and Convenience in the Vehicle Settings menu.
See Seats and Restraints in your Owner Manual.
Driver’s Seat Adjustments
F Optional equipment
ACB
BADC
7
Wipers and Washers
Windshield Wipers and Washer
Move the lever up or down to operate the windshield wipers .
HI Continuous High Speed
LO Continuous Low Speed
INT Intermittent
Rotate the band to adjust the delay between wipes .
OFF
1x Mist
Washer Fluid
Pull the lever toward you to spray washer fluid on the windshield.
Rear Wiper and Washer
The rear wiper switch is located on the end of the wiper lever .
A. ON Continuous Low Speed
B. OFF
C. INT Intermittent
Washer Fluid
Push the lever away from you to spray washer fluid on the rear window.
See Instruments and Controls in your Owner Manual.
Power Programmable LiftgateF
Programming the Liftgate Height
1 . Turn the power liftgate switch to the 3/4 mode position .
2 . Open the liftgate by pressing the RKE transmitter liftgate button or the touchpad on the center of the liftgate .
3 . Stop the liftgate at the desired height by pressing any liftgate button . Adjust manually to the desired height if necessary .
4 . To save the setting, press and hold the button next to the liftgate latch for three seconds. The taillamps will flash when the setting is saved .
See Keys, Doors and Windows in your Owner Manual.
MAX
Fully open the liftgate .
3/4
Open the liftgate to the programmed height .
OFF
Operate the liftgate manually .
F Optional equipment
A
B
C
