MOONROOF*
The moonroof control is on the overhead console. It has a
one-touch open and close feature. To stop its motion during
the one-touch operation, press the control a second time.
To open, press and release the SLIDE control. It stops short of
the fully opened position to help reduce wind noise. Press the
SLIDE control again to fully open the moonroof. To close, pull
and release the SLIDE control.
To vent, press and release the TILT control. Pull and hold the
TILT control to close the moonroof.
Once you close the moonroof, you can still open or close the
sliding shade manually. Pull the shade toward the front of the
vehicle to close it.
REAR HEATED SEATS *
Press the heated seat control repeatedly to cycle through the
settings and off. More lights indicate a higher setting.
AMBIENT LIGHTING *
When activated, ambient lighting illuminates key areas of your
interior with a choice of colors.
To access and make adjustments, use your touchscreen
1. Press the Settings icon > Ambient Lighting.
2. Touch the desired color.
3. Move the color up or down to increase or decrease the intensity.
To switch the feature on or off, touch the selected color again.
MEMORY FEATURE*
The memory function saves and recalls the positions of the
driver seat, power mirrors, tilt and telescoping steering column*
and adjustable pedals.* Use the memory controls on the left
side of the driver’s seat
to program and then recall
memory positions.
To program
1. Switch on the ignition.
2. Move the memory features to your desired position.
3. Press and hold the
button until you hear a tone.
Use this same procedure to set the second position using the
button.
You can now use these controls to recall the set memory positions.
You can also program your memory seats to your transmitter.
That way, when you unlock your door with the transmitter, your
memory features automatically move into your saved position.
See the Seats chapter in your Owner’s Manual for more details.
REAR WINDOW BUFFETING
You may hear a pulsing noise when one or both of the rear
windows are open. Lower a front window slightly to reduce
this noise.
comfort (co ntinued)
POWERFOLD® THIRD -ROW SEAT *
The 60/40 split-folding bench seat uses a power-activated
seatback release. Fold one side or both down for more flexibility.
The controls are on the right-hand rear quarter trim panel,
accessible from the liftgate area.
Note: Make sure you unfasten all of the safety belts and fold the
head restraints down first.
To lower
1. Press the corresponding control(s) or use the middle control
to fold both seats down.
2. To return the seatback(s) to the original position(s), press the
corresponding control(s) again.
See the Seats chapter in your Owner’s Manual for
more information.
Note: The power-folding seats operate for 10 minutes after you
switch the ignition off. The transmission must be in park (P) and
the liftgate or liftgate glass must be open.
LEATHER CLEANING
For cleaning and removing spots and stains, use Motorcraft®
Premium Leather and Vinyl Cleaner** or a commercially
available leather cleaning product for automotive interiors.
Note: Test any cleaning product on an inconspicuous area first.
Do not use the following products as these may damage
the leather:
• Oil and petroleum or silicone-based leather conditioners.
• Household cleaners.
• Alcohol solutions.
• Solvents or cleaners intended specifically for rubber, vinyl
and plastics.
For complete information, see the Vehicle Care chapter of your
Owner’s Manual.
page no. s ixteen*if equipped **Do no t use o n the K ing Ranch seats. See yo ur Owner’s Manual for details.*if equippedpage no. seventeen
SELECTSHIFT AUTOMATICTM TRANSMISSION *
Gives you the ability to manually change gears if you like. To use,
move the gearshift lever from drive (D) to manual (M).
• Press the (+) button to upshift.
• Press the (–) button to downshift.
To return back to automatic shifts, move the gearshift lever from
manual (M) to a different gearshift position.
EASY FUEL® SYSTEM
When fueling your vehicle
1. Put your vehicle in park (P) and switch the ignition off.
2. Open the fuel filler door.
3. Slowly insert the fuel filler nozzle fully into the fuel system,
and leave the nozzle fully inserted until you are done pumping.
4. Wait at least 10 seconds before removing the fuel pump
nozzle to allow any residual fuel to drain into the fuel tank.
When refueling the vehicle fuel tank from a fuel container,
use the plastic funnel located in the spare wheel storage tray.
Clean the funnel or properly dispose of it.
Note: Do not use aftermarket funnels as they will not work with
the Easy Fuel system and may cause damage. You can purchase
extra funnels from an authorized dealer if you choose to dispose
of the funnel.
FUEL TYPE AND FUEL TANK CAPACITY
Depending on your vehicle, your fuel tank has a capacity of
either 28 gallons (106L) or 33.5 gallons (126.8L).
Use only UNLEADED gasoline blended with a maximum of
15% ethanol and a minimum of an 87 octane rating. Do not use
E85 (ethanol), diesel, fuel-methanol, leaded fuel or any other
fuel because it could damage or impair the emission
control system.
TIRE PRESSURE MONITORING SYSTEM
Your vehicle is equipped with a Tire Pressure Monitoring
System (TPMS) that displays a low tire pressure warning light
when one or more of your tires are significantly under-inflated.
If this happens, stop and check your tires as soon as possible.
Inflate them to the proper pressure. Refer to the Tire Pressure
Monitoring System section in the Wheels and Tires chapter of
your Owner’s Manual for more information.
LOCATION OF SPARE TIRE AND TOOLS
The temporary spare tire is located under the vehicle, just
forward of the rear bumper. The temporary spare is for
emergency use only and you should replace it as soon as
possible. The jack and tools are under the access panel in the
floor behind the rear seat. Make sure to switch off the power
running boards* prior to jacking, hoisting or towing your vehicle.
Refer to the Wheels and Tires chapter in your Owner’s Manual.
CONVENIENCE
POWER LIFTGATE OPERATION*
You can open your power liftgate three different ways:
• Push the control on the instrument panel.
• Press the control on your remote
entry transmitter twice within
three seconds.
• Press the liftgate control located
on the inside of the liftgate handle.
To close with the rear cargo area button, press and release
the control located on the left, rear quarter panel.
SECURICODETM KEYLESS ENTRY KEYPAD *
Lock or unlock the doors without a key by using the keypad.
Enter the factory-set, 5-digit entry code or your personal code.
This code is on the owner’s wallet card in the glove box.
To unlock all doors, enter the factory-set code or your personal
code, then press 3•4 within five seconds. With intelligent
access, press any button on the keypad once to unlock all
doors. You do not need to enter a code first.
To lock all doors, press and hold 7•8 and 9•0 at the same
time with the driver door closed. You do not need to enter the
keypad code first.
REMOTE START*
Remote start allows you to start the engine from outside
your vehicle using your key. To start, press and then press twice within three seconds. Your vehicle runs for 5, 10,
or 15 minutes, depending on the setting. See the Information
Displays chapter in your Owner’s Manual to select the duration
of the remote start system.
Once inside, apply the brake while pressing the START STOP
button. Shift into drive (D) and go. If you have an integrated
keyhead transmitter, insert the key into the ignition and switch
the ignition on as you normally would before driving. To switch
the engine off from outside the vehicle after using your remote
start, press
once.
POWER RUNNING BOARDS *
When active, the running boards extend down and out when
you open the doors. They return to the stowed position after a
two-second delay when you close the doors.
To enable and disable the power running board feature, refer to
the Information Displays chapter in your Owner’s Manual.
Note: Do not use the running boards, front and rear hinge
assemblies, running board motors, or the running board
under-body mounts to lift the vehicle when jacking. Always
use proper jacking points. See your Owner’s Manual for details.
ESSENTIAL FEATURES
*if equippedpage no. nineteenpage no. eighteen*if equipped
Instrument Panel
