2016 DODGE DURANGO battery replacement

▫Programming Additional Transmitters .......27
▫ Transmitter Battery Replacement ...........27
▫ General Information ....................29
 REMOTE STARTING SYSTEM — IF EQUIPPED .29
▫ How To Use Remote Start ................30
▫ Remote Start Abort Message On Driver
Information Display (DID) — If Equipped ....31
▫ To Enter Remote Start Mode ...............31
▫ To Exit Remote Start Mode Without Driving The
Vehicle .............................32
▫ To Exit Remote Start Mode And Drive The
Vehicle .............................32
▫ Remote Start Comfort Systems — If Equipped .33
▫ General Information ....................33 
DOOR LOCKS .........................34
▫ Manual Door Locks ....................34
▫ Power Door Locks .....................35
▫ Child-Protection Door Lock System — Rear
Doors ..............................36
 KEYLESS ENTER-N-GO ..................38
▫ General Information ....................43
 WINDOWS ...........................43
▫ Power Windows .......................43
▫ Wind Buffeting .......................47
 LIFTGATE ............................47
▫ Power Liftgate — If Equipped .............49
 OCCUPANT RESTRAINT SYSTEMS ..........51
12 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Using The Panic Alarm
To turn the Panic Alarm feature on or off, push and hold
the PANIC button on the RKE transmitter for at least one
second and release. When the Panic Alarm is activated,
the turn signals will flash, the horn will pulse on and off,
and the interior lights will turn on.
The Panic Alarm will stay on for three minutes unless
you turn it off by either pushing the PANIC button a
second time or drive the vehicle at a speed of 15 MPH
(24 km/h) or greater.
NOTE:
•The interior lights will turn off if you place the ignition
in the ACC or ON/RUN position while the Panic
Alarm is activated. However, the exterior lights and
horn will remain on. •
You may need to be less than 35 ft (11 m) from the
vehicle when using the RKE transmitter to turn off the
Panic Alarm due to the radio frequency noises emitted
by the system.
Programming Additional Transmitters
Programming Key Fobs or RKE transmitters may be
performed at an authorized dealer.
Transmitter Battery Replacement
The recommended replacement battery is one CR2032
battery.
NOTE:
• Perchlorate Material — special handling may apply.
Batteries could contain dangerous materials. Please
dispose of them according to respect for environment
and local laws.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 27

MAINTAINING YOUR VEHICLE
CONTENTS
ENGINE COMPARTMENT — 3.6L ..........635
 ENGINE COMPARTMENT — 5.7L ..........636
 ONBOARD DIAGNOSTIC SYSTEM (OBD II) . . .637
▫ Onboard Diagnostic System (OBD II)
Cybersecurity ....................... .637
 EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS ......................... .638
 REPLACEMENT PARTS ..................640
 DEALER SERVICE ..................... .640
 MAINTENANCE PROCEDURES ...........641▫
Engine Oil ......................... .641
▫ Engine Oil Filter ..................... .645
▫ Engine Air Cleaner Filter ................645
▫ Maintenance-Free Battery ...............646
▫ Air Conditioner Maintenance .............647
▫ Body Lubrication .....................652
▫ Windshield Wiper Blades ...............652
▫ Adding Washer Fluid ..................654
▫ Exhaust System ..................... .655
▫ Cooling System ..................... .658
7

Normally, the OBD II system will be ready. The OBD II
system maynotbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition actuated test, which
you can use prior to going to the test station. To check if
your vehicle’s OBD II system is ready, you must do the
following:
1. Cycle the ignition switch to the ON position, but do not crank or start the engine.
NOTE: If you crank or start the engine, you will have to
start this test over.
2. As soon as you cycle the ignition switch to the ON position, you will see the “Malfunction Indicator Light
(MIL)” symbol come on as part of a normal bulb
check. 3. Approximately 15 seconds later, one of two things will
happen:
• The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle’s OBD II system is not readyand you should
not proceed to the I/M station.
• The MIL will not flash at all and will remain fully
illuminated until you place the ignition in the off
position or start the engine. This means that your
vehicle’s OBD II system is readyand you can proceed
to the I/M station.
If your OBD II system is not ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
7
MAINTAINING YOUR VEHICLE 639

Engine Air Cleaner Filter Selection
The quality of replacement engine air cleaner filters
varies considerably. Only high quality filters should be
used to assure most efficient service. MOPAR engine air
cleaner filters are a high quality filter and are recom-
mended.
Maintenance-Free Battery
Your vehicle is equipped with a maintenance-free battery.
You will never have to add water, nor is periodic main-
tenance required.
WARNING!
•Battery fluid is a corrosive acid solution and can
burn or even blind you. Do not allow battery fluid
to contact your eyes, skin, or clothing. Do not lean
over a battery when attaching clamps. If acid
(Continued)
WARNING! (Continued)
splashes in eyes or on skin, flush the area imme-
diately with large amounts of water. Refer to
“Jump-Starting Procedures” in “What To Do In
Emergencies” for further information.
• Battery gas is flammable and explosive. Keep
flame or sparks away from the battery. Do not use
a booster battery or any other booster source with
an output greater than 12 Volts. Do not allow cable
clamps to touch each other.
• Battery posts, terminals, and related accessories
contain lead and lead compounds. Wash hands
after handling.
646 MAINTAINING YOUR VEHICLE

Alarm System (Security Alarm)................21
All Wheel Drive (AWD) .....................492
Alterations/Modifications, Vehicle ...............9
Antifreeze (Engine Coolant) ...............659, 691
Disposal ............................. .662
Anti-Lock Brake System (ABS) ................509
Anti-Lock Warning Light ....................316
Appearance Care ........................ .670
Arming System (Security Alarm) ...............21
Assist, Hill Start ......................... .512
Auto Down Power Windows ..................44
Automatic Headlights ..................... .176
Automatic High Beams .....................176
Automatic Temperature Control (ATC) .......426, 434
Automatic Transmission .................483, 669
Adding Fluid ......................... .669
Fluid And Filter Changes ..................669
Fluid Change ......................... .669
Fluid Level Check ...................668, 669 Fluid Type
........................ .668, 695
Gear Ranges .......................... .484
Special Additives ...................... .668
Auxiliary Electrical Outlet (Power Outlet) ........257
Auxiliary Power Outlet .....................257
Axle Fluid ............................. .695
Battery ............................ .302, 646
Charging System Light ...................302
Keyless Transmitter Replacement (RKE) ........27
Belts, Seat ...............................112
Blind Spot Monitoring ..................... .135
Body Mechanism Lubrication .................652
B-Pillar Location ......................... .531
Brake Assist System ........................511
Brake Control System, Electronic ..............508
Brake Fluid ......................... .664, 695
Brake System ........................ .508, 664
Anti-Lock (ABS) ....................... .508
10
INDEX 717