Page 79 of 595
77
Jumpy _en_Chap02_ouvertures_ed01-2016
If a sliding side door is not fully
closed:
-
v
ehicle stationary and engine
running, this warning lamp
comes on, accompanied by an
alert message for a few seconds,
-
v
ehicle moving (speed above
6 mph (10 km/h)), this warning
lamp comes on, accompanied
by an audible signal and an alert
message for a few seconds.
For more information on the Key,
Remote control or Keyless Entr y
and Starting and in particular locking
the vehicle, refer to the corresponding
section.
Closing
From outside
F Pull the handle toward you, then to the front, and if necessary lock the vehicle.
From inside
F Push the handle for ward to close the door, and if necessary lock the vehicle.
2
Access
Page 80 of 595
78
Jumpy _en_Chap02_ouvertures_ed01-2016
Electric sliding side door(s)
The exterior and interior door handles and the interior buttons allow the electrically powered
movement of the door to be started.
Opening and closing of the doors is accompanied by an audible signal.The remote controls buttons are not
active with the ignition switched on.
Opening
From outside
Using the remote controlF Press this button again to reverse the movement of the
d o o r.
Using the handle
F Door unlocked, press and hold this button until the
corresponding sliding side door
has opened. F
D
oor unlocked, pull and release the handle
to start the electrically powered opening of
the door.
F
P
ull the handle again to reverse the
movement of the door.
Access
Page 81 of 595

79
Jumpy _en_Chap02_ouvertures_ed01-2016
F Pull the handle toward the rear to unlock the loading area and start the electrically
powered opening of the door. F
P
ull the handle toward the rear to start the
electrically powered opening of the door.
Using the handle
Cab and loading area selectivity
activated. Child lock off (deactivated).
F
P
ull the handle toward the rear to totally
unlock the vehicle and start the electrically
powered opening of the door.
From inside
Cab and loading area selectivity
deactivated.
For more information on the Key,
Remote control or Keyless Entr y
and Starting and in particular total
or selective unlocking, refer to the
corresponding section. Cab
and loading area selectivity
deactivated.
From inside, total
unlocking then
opening
F To unlock the vehicle and start the
electrically powered opening of a door,
press the button for the corresponding
d o o r.
F
P
ressing the button again reverses the
movement of the door.
The button is inoperative and
accompanied by an audible signal, if:
-
t
he vehicle is moving,
-
t
he vehicle has been locked or
deadlocked from outside (using
the key, remote control or Keyless
Entry and Starting, depending on
equipment).
Depending on equipment, the button
for the left hand door is inoperative and
accompanied by an audible signal, if
the fuel filler flap is open.
Using the button(s) at the front
Vehicle locked Vehicle unlocked
2
Access
Page 82 of 595
80
Jumpy _en_Chap02_ouvertures_ed01-2016
F To unlock the loading area only and start
the electrically powered opening of a door,
press the button for the corresponding
d o o r.
F
P
ressing the button again reverses the
movement of the door. The button is inoperative and
accompanied by an audible signal, if:
-
t
he vehicle is moving,
-
t
he vehicle has been locked or
deadlocked from outside (using
the key, remote control or Keyless
Entry and Starting, depending on
equipment).
Depending on equipment, the button
for the left hand door is inoperative and
accompanied by an audible signal, if
the fuel filler flap is open.
For more information on the Key
,
Remote control or Keyless Entr y
and Starting and in particular total
or selective unlocking, refer to the
corresponding section.
Using the button(s) at the frontFrom inside,
selective unlocking
then opening
Cab and loading area selectivity
activated.
Access
Page 83 of 595

81
Jumpy _en_Chap02_ouvertures_ed01-2016
F Child lock deactivated, to unlock the vehicle and start the electrically powered
opening of a door, press the button for the
corresponding door.
F
P
ressing the button again reverses the
movement of the door.
The button is not operational and
pressing it results in an audible signal, if:
-
t
he vehicle is moving,
-
t
he vehicle has been locked or
deadlocked from outside (using
the key, remote control or Keyless
Entry and Starting, depending on
equipment),
-
t
he child lock is on (activated).
The button for the left-hand door is not
operational and pressing it results in an
audible signal if the fuel filler flap is open. The button is not available and
accompanied by an audible signal, if:
-
t
he vehicle is moving,
-
t
he vehicle has been locked or
deadlocked from outside (using
the key, remote control or Keyless
Entry and Starting, depending on
equipment),
-
t
he child lock is on (activated).
The button for the left-hand door is not
available and is accompanied by an
audible signal if the fuel filler flap is open.
Using the button(s) at the frontFrom inside,
unlocking then
openingUsing the button(s) on the door
pillar
F Child lock deactivated, to unlock the vehicle and start the electrically powered
opening of a door, press the button for the
corresponding door.
F
P
ressing the button again reverses the
movement of the door.
For more information on the Child lock
,
refer to the corresponding section.
2
Access
Page 84 of 595
82
Jumpy _en_Chap02_ouvertures_ed01-2016
The remote controls buttons are not
active with the ignition switched on.
Closing
From outside
F To start the electrically powered opening of the door, press the button for the
corresponding door.
F
P
ressing the button again reverses the
movement of the door.
Using the button(s) at the front
The button is not operational and
pressing it results in an audible signal,
if the speed of the vehicle is above
20
mph (30 km/h).
From inside
Using the remote control
F Press and hold this button until the sliding door has closed.
F
P
ress this button again to
reverse the movement of the
d o o r.
Using the handle
F Pull and release the handle to start the electrically powered opening of the door.
F
P
ull the handle again to reverse the
movement of the door.
Access
Page 85 of 595
83
Jumpy _en_Chap02_ouvertures_ed01-2016
F To start the electrically powered opening of a door, press the button for the
corresponding door.
F
P
ressing the button again reverses the
movement of the door.
Using the button(s) on the door
pillar
The button is not operational and
pressing it results in an audible signal,
if the speed of the vehicle is above
20
mph (30 km/h). If a sliding door is not fully closed:
-
v
ehicle stationary and engine
running, this warning lamp comes
on, accompanied by an alert
message for a few seconds,
-
v
ehicle moving (speed above
6 mph (10 km/h)), this warning
lamp comes on, accompanied
by an audible signal and an alert
message for a few seconds.
2
Access
Page 90 of 595

88
Jumpy _en_Chap02_ouvertures_ed01-2016
For more information on the Key,
Remote control or Keyless Entr y
and Starting , and in particular total
or selective locking, refer to the
corresponding section.
Confirmation that the door is going
to open is signalled by the direction
indicators flashing for a few seconds,
accompanied by an audible signal.
The movement of the door is reversed
if you pass your foot under the bumper
during operation of the door.
If fitted to your vehicle, the electric door
mirrors unfold on unlocking the vehicle.
Opening
With "
Hands-free access " activated in the
vehicle configuration menu.
F
W
ith the remote control on your person and
in the recognition zone A , pass your foot
under the outer rear bumper, on the side
you want to open the door. Cab
and loading area selectivity
deactivated.
Cab and loading area selectivity
activated.
If the vehicle is locked, it is unlocked before
opening the door.
If the vehicle is locked, the loading area is
unlocked before opening the door. If the vehicle is locked, it is unlocked before
opening the door.
Access