2016 Citroen DS5 HYBRID ESP

Eco-driving

Eco-driving is a range of everyday practices that allow the motorist to optimise their fuel
consumption and CO
2 emissions.

Adapted to your Hybrid4 vehicle


Use gear selector position A
, as this optimises gear changes to suit the circumstances, and
the AUTO
mode of the Hybrid4 mode selector.
When moving off, accelerate normally up to the desired speed ( POWER
zone between 20
and 40 %).
At steady speeds, drive gently with small movements of the accelerator pedal ( ECO
or
CHARGE
zone), to allow running in electric mode when driving at low speed.
Anticipate the need to slow down and use engine braking ( CHARGE
zone), so as to make
use of the recovery of "free" energy, while maintaining light pressure on the accelerator
pedal.

For information on other eco-driving practices, refer to the corresponding section of the
handbook for the vehicle.

37Practical information










Temporary puncture repair kit


This kit comprises a compressor and a sealant cartridge.
It allows you to carry out a temporary repair
to a tyre.
This makes it possible to continue to the nearest garage.

It can be used for for repairing most
punctures on the tread or shoulder of
the tyre.
The compressor can be used to check
and adjust a tyre pressure.

For more information on the use of this
temporary puncture repair kit, refer
to the corresponding section in the
handbook for the vehicle.

All of these tools are specific to your
vehicle.
Do not use them for other purposes.



Access to the kit














List of tools



1.
12 V compressor.
Contains a sealant cartridge for the
temporary repair of a tyre and can also be
used for adjusting tyre pressures.

2.
Chock.
For blocking the wheels of the vehicle.

3.
Wheel bolt cover remover.
For removing the wheel bolt head
protectors on alloy wheels.

4.
Wheel trim remover.
For removing the wheel bolt finishers on
alloy wheels.

5.
Removable towing eye.

This kit is installed in the storage box, under the
boot floor.

Recovery of the vehicle on a fl at-bed


Never recover the vehicle by towing it with two or four wheels on the ground, as there is a risk of
damage to the transmission.
However, if necessary because access to the vehicle is difficult, the vehicle can be moved a few
dozen metres, at a speed of less than 6 mph (10 km/h).

Use the towing eye only
to pull the vehicle out
or to lash it for recovery on a flat-bed lorry or
trailer.

Before doing any work, with the ignition on, press the brake pedal and place the gear selector at
position N
, then switch off the Hybrid4 system ( READY
lamp off).
Always call on professionals for recovery of the vehicle on a flat-bed lorry or trailer.









Snow chains


Recommendations


The use of snow chains is only authorised on
the front wheels.
The mode selector must be in the
4WD
position.

For information on the sizes
compatible with the tyres on your
vehicle and advice on use, refer to the
corresponding section in the handbook
for the vehicle.

39Te c h n i c a l d a t a

Electric motor



-


Te c h n o l o g y
Synchronous with permanent magnets
Max. power: EU standard (kW) *
27
Max. power speed (rpm)
2 000 to 7 500
Max. torque: EU standard (Nm)
200
Max. torque speed (rpm)
800 to 1 290
Efficiency (%)

80 to 90

High voltage batter y


Ni-MH

(Nickel Metal Hydride)
Voltage (V~)

200
Energy capacity (kWh / Ah)
1.1 / 5.5
Range (miles (km))
1.2 (2) (approximately)


















Electric motor and battery


Range varies according to the ambient climatic conditions, the driving style and conditions, the use of vehicle systems and ageing of the battery.

*
The maximum power corresponds to the value type approved on a test bed, under conditions defined by European legislation (directive 1999/99/EC).

Diesel engine and gearbox



Diesel engine



HDi 160



Gearbox


ETG6 electronic

(6- speed)


Cubic capacity (cc)

1 997
Bore x stroke (mm)

85 x 88
Max power: EU standard (kW) *
120
Max power engine speed (rpm)
3 850
Max torque: EU standard (Nm)
300
Max torque engine speed (rpm)
1 750
Fuel

Diesel
Catalytic conver ter

Ye s
Particle filter

Ye s
Engine oil capacity with filter replacement
(in litres)
5.0

*
The maximum power corresponds to the type approved value on a test bed, under conditions defined by European legislation
(directive 1999/99/EC).

4Dconcept
Diadeis
Interak
08-15
Labels are fi tted in various areas of your vehicle. They
carry safety warnings as well as vehicle identifi cation
information. Do not remove them: they form an integral part
of your vehicle.

Automobiles CITROËN declares, by application of the
provisions of the European regulation (Directive 2000/53)
relating to End of Life Vehicles, that it achieves the
objectives set by this regulation and that recycled materials
are used in the manufacture of the products that it sells.
Printed in the EU
Anglais
For any work on your vehicle, use a qualifi ed workshop
that has the technical information, competence and
equipment required, which a CITROËN dealer is able to
provide.


Reproduction or translation of all or part of this document
is prohibited without written authorisation from Automobiles
CITROËN.

We draw your attention to the following points:


- The fi tting of electrical equipment or accessories not
listed by CITROËN may cause faults and failures
with the electrical system of your vehicle. Contact
a CITROËN dealer for information on the range of
recommended accessories.

- As a safety measure, access to the diagnostic socket,
used for the vehicle's electronic systems, is reserved
strictly for CITROËN dealers or qualifi ed workshops,
equipped with the special diagnostic tool required (risk
of malfunctions of the vehicle's electronic systems that
could cause breakdowns or serious accidents). The
manufacturer cannot be held responsible if this advice is
not followed.

- Any modifi cation or adaptation not intended or
authorised by Automobiles CITROËN or carried out
without meeting the technical requirements defi ned by
the manufacturer would lead to the suspension of the
legal and contractual warranties.