2016 Citroen C4 PICASSO rear bumper

207
C4-Picasso-II_en_Chap05_eclairage-visibilite_ed01-2016
Displays
Illumination of the corresponding indicator lamp in the instrument panel confirms that the
lighting
  selected   is   on.
The rear sidelamps and direction
indicators
  are   located   on   the   tailgate.  
W

hen   they   are   on,   opening   the   tailgate  
a

utomatically transfers illumination to
the lamps located in the rear bumper, to
maintain
  the   safety   of   the   vehicle.
Main lighting
Lighting off (ignition off) /Daytime running lamps (engine running).
Automatic illumination of headlamps.
D aytime   running   lamps   /   Dipped  
b

eam   /   Main   beam.
Sidelamps.
Dipped
  or   main   beam   headlamps.
Turn
 
the
 
ring   A to place the desired symbol
against
 
the   mark.
Selection of main lighting mode
Model without AUTO lighting
Model with AUTO lighting Headlamp dipping
Pull the stalk B towards you to switch the
l ighting   between   dipped   and   main   beam  
h

eadlamps or to activate automatic headlamp
dipping.
In
  the   lighting   off   and   sidelamps   modes,   the  
d

river can switch on the main beam headlamps
temporarily
  ("headlamp   flash")   by   maintaining   a  
p

ull   on   the   stalk.
5
Lighting and visibility

262
C4-Picasso-II_en_Chap07_info-pratiques_ed01-2016
Towbar with quickly detachable towball
Fitting
F Below the rear bumper, unclip and remove the   protective   cover   on   the   carrier.F
 B efore   fitting   the   towball,   check   that   the  p
oints of contact, indicated by the arrows,
are
  clean.
 U

se   a   soft   clean   cloth.F
 
E
nsure   that   the   towball   is   fully   engaged.  
T

he two pins must be in contact with
the cut-outs in the carrier and the
trigger  B must have returned to the
"locked" p osition.
F I nstall and clip in place the protective
cover,
  by   rotating   it   to   the   left.
F

O
n the towball, press and hold control A .
F
 
R
elease   the   locking   mechanism   by  
p

ressing   the   trigger   B. F

P
ut the end of the towball into the carrier,
located
  below   the   bumper,   as   far   as   it   will   go.
No
  tools   are   required   to   install   or   remove   the   towball   on   this   genuine   towbar   system.
F  
C
onnect   the   trailer   plug   to   the   13 -way  
s

ocket   provided,   located   next   to   the   carrier.
F
 
M
ake   the   trailer   safe   by   attaching   its   safety  
c

able to the eye provided for this purpose,
located
  on   the   carrier.
Practical information

320
C4-Picasso-II_en_Chap08_en-cas-panne_ed01-2016
Towing another vehicle
F On the rear bumper, unclip the cover by pressing   at   the   bottom.
F
 
S
crew   the   towing   eye   in   fully.
F
 
I
nstall   the   towing   bar.
F
 
S
witch   on   the   hazard   warning   lamps   on  
b

oth   vehicles.
F
 
M
ove   off   gently,   drive   slowly   and   for   a   short  
di

stance.
F
O
n the front bumper, unclip the cover by
pressing
 
on
 
the
 
left.
F
 
S

crew
 
the
 
towing
 
eye
 
in
 
fully.
F
 
I

nstall
 
the
 
towing
 
bar.
F
 
P

lace
 
the
 
gear
 
lever
 
in
 
neutral
 
(position
 
N
with
 
an
 
automatic
 
gearbox).
Towing your vehicle
Failure to observe this instruction could
result   in   damage   to   certain   components  
(

braking,   transmission...)   and   the  
a

bsence   of   braking   assistance   the   next  
t

ime   the   engine   is   started.
F
 
U

nlock   the   steering   by   turning   the   key  
i

n
  the   ignition   one   notch   and   release   the  
par

king
 b
rake.
F
 
S

witch   on   the   hazard   warning   lamps   on  
b

oth   vehicles.
F
 
M

ove   off   gently,   drive   slowly   and   for   a   short  
di

stance.
In the event of a breakdown