21
Berlingo-2-VP_en_Chap03_Pret-a-partir_ed01-2016
FRONT DOORS
From the inside
Use the door opening control to unlock and open the door concerned.
From the outside
Use the remote control to lock/unlock the vehicle.
Insert
the metal part of the key in the
lock
on the driver's side if the remote
control
does not work.
Disarming
- Unlock the vehicle with the remote control or switch on the ignition, the
red
LED goes off.
Locking the vehicle with
exterior protection only
If, while you are away from the vehicle, you wish to leave a window partially
open or a pet inside the vehicle, you
should
choose exterior protection only.
-
Switch
off the ignition.
-
In the next ten seconds,
press the button until the
red
LED
is
on
continuously
.
- Get out of the vehicle.
-
Within
the next five minutes, set
the
alarm by locking or deadlocking
using
the remote control (the red
LED
flashes once a second).
Triggering
The siren sounds, the direction indicators
flash for approximately 30 seconds and
the
red LED flashes rapidly.
- To switch it off, insert the key and switch on the ignition.
When
the alarm has been triggered ten
times
in
succession
(when
triggered
for
the
eleventh
time) it is deactivated. Repeat the
procedure
for setting the alarm.
Locking the vehicle without
alarm
- Insert the key in the lock on the driver's
door and lock it.
Do
not set the alarm when washing
your
vehicle.
Failure of the remote control
When the alarm is set but the remote control does not operate:
-
Unlock the doors with the key and open the door. The alarm is triggered.
- Switch on the ignition in the
next ten seconds. The alarm is
disarmed.
Incorrect operation
When the ignition is switched on, if the
red LED remains on for ten seconds,
there
is a fault in the siren connection.
Contact a CITR
o Ë n dealer to have the
system
checked.
Automatic setting of the alarm
depending on the country in which
the vehicle is sold, the alarm is set
automatically
approximately 2 minutes
after
the last door is closed.
To
prevent triggering of the alarm when
a door is opened, you have to press
the
remote control unlocking button
again.Do
not make any modifications
to
the alarm system as this could
cause
faults.
access
REadY To Go
3
