4
Remote Keyless Entry Transmitter
Keyless Access System
F Optional equipment
Unlock
Press to unlock the
driver’s door. Press
again to unlock all
doors.
Power Liftgate
Press twice to open or
close the liftgate. Press
once to stop power liftgate operation.
Lock
Press to lock all doors.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle.
The exterior lamps will flash and the horn
will sound.
Press and hold to activate the alarm. Press
it again to cancel the alarm.
Note: To change the remote lock, unlock, and
remote start settings, go to Remote Lock, Unlock,
Start in the Vehicle Settings menu.
Remote Vehicle Start
Press and release the
Lock button and
then immediately press and hold the
button until the turn signal lamps flash to
start the engine from outside the vehicle.
After entering the vehicle, turn on the
ignition.
• During a remote start, the engine will
run for 10 minutes. Repeat these steps
to run the engine for an additional 10
minutes. A remote start can be extend
-ed once.
• Press and hold the
button until
the parking lamps turn off to cancel a
remote start.
Remote Start and Heated Seats: Select
the remote start heated seat option in the
Vehicle Settings to have the heated seats
turn on during a remote start. The heated
seat button indicators do not illuminate
and the temperature of the unoccupied
seat may be reduced during a remote start.
See Keys, Doors and Windows in your Owner Manual.
The Keyless Access System enables operation of the doors, igni-tion and liftgate without removing the Remote Keyless Entry
transmitter from your pocket or purse. The transmitter must be within 3 feet of the door being unlocked or the liftgate.
Keyless Unlocking
With the transmitter within range:
Press the lock button on the driver’s door handle to unlock
the driver’s door; press it again within 5 seconds to unlock all doors.
Press the lock button on a passenger door handle to unlock all doors.
Press the touchpad on the liftgate handle to open the liftgate.
Keyless Locking
With the ignition off, the transmitter removed from the vehicle, and all doors closed:
Press the lock button on any door handle to lock all doors immediately.
If Passive Locking is turned on, all doors will lock automatically after a short delay.
Note: To change the Keyless Locking and Unlocking settings, go to Remote Lock, Unlock, Start in the
Vehicle Settings menu.
See Keys, Doors and Windows in your Owner Manual.
6
Front Seats
Set Memory Seat Positions
With the ignition On or in Accessory mode:
1. Adjust the seat and power outside
mirrors to the desired positions.
2. Press and release the SET button on the
driver’s door. A beep will sound.
3. Immediately press and hold button 1
until two beeps sound.
Repeat these steps using button 2 for a
second driver.
To store a seat position for more clearance when exiting the vehicle, repeat these steps
using the
Exit button instead of button
1 or 2.
Recall Memory Seat Positions
Press and hold button 1, 2 or Exit until the seat and mirrors reach the set position.
The memory/exit positions can be programmed to be recalled automatically.
To set the Auto Memory Recall or Easy Exit options, go to the Settings > Vehicle >
Comfort and Convenience menu.
See Seats and Restraints in your Owner Manual.
Power Seat Adjustments
A. Seat Adjustment
Move the horizontal control to move
the seat forward or rearward and to tilt,
raise or lower the seat.
B. Seatback Recline Adjustment
Move the vertical control to recline or
raise the seatback.
C. Lumbar Support Adjustment
Press the rear control to adjust the
amount of lumbar support.
Steering Wheel Adjustment
With the vehicle parked, push down the lever under the steering column to adjust the
steering wheel. The steering wheel can then be moved up or down and in or out. Pull
up the lever to lock the steering wheel in place.
See Instruments and Controls in your Owner Manual.
Ac
B
7
Rear Seat Adjustment
To slide the seat forward or rearward, lift
the bar (A) under the seat cushion and
slide the seat.
Reclining the Seatback
To recline the seat cushion, pull the lever
(B) on the side of the seatback and move
the seatback to the desired position.
Release the lever.
Folding the Seatback
1. Press the button on the side of the head
restraint. It will fold automatically.
2. Pull the lever (B) on the side of the seat
cushion and fold the seatback forward or
pull the release lever located on the side of
the cargo area.
To raise the seatback, pull the lever on the
side of the seat cushion and push the
seatback rearward until it locks in the
upright position. Adjust the seatback.
See Seats and Restraints in your Owner Manual.
F Optional equipment
Rear Seats
Power Liftgate
Open/Close the Power Liftgate
Press the Power Liftgate button on the RKE transmitter twice.
Press the Power Liftgate knob on the driver’s door.
Press the touchpad on the liftgate handle to open the liftgate.
Press the button next to the liftgate pull to close the liftgate.
Programming the Liftgate Height
1. Turn the Power Liftgate knob to the 3/4 mode position.
2. Open the liftgate.
3. Adjust the liftgate manually to the desired height.
4. To save the setting, press and hold the button next to the liftgate pull for 3 seconds.
The turn signals will flash when the setting is saved.
Hands-Free Operation
To open or close the liftgate hands-free, kick your foot under the left side of the rear
bumper. The RKE transmitter must be within 3 feet of the liftgate.
See Keys, Doors and Windows in your Owner Manual.
A
B
