2016 Alfa Romeo 4C engine oil

ENGINE OIL
Check that the oil level is between the
MIN and MAX marks on the dipstick A
fig. 121.
For this check, take out the dipstick
from its seat, clean it with a lint-free
cloth, reinsert the dipstick; take it out
again and check the oil level.
121)
If the level of the oil is close to or below
the MIN mark, add oil via the filler fitting
B fig. 121 until the MAX mark is
reached.
23)
To unscrew and re-tighten the filler cap
it is necessary to use the tool A shown
in fig. 123, found in the car.
Take out the engine oil dipstick A, clean
it with a lint-free cloth and reinsert it.
Extract the engine oil dipstick again and
check that the level is between the MIN
and MAX marks on the dipstick.
121)
WARNING Make sure that the oilcap is tightened properly in its seat
after topping the oil up.
Once the cap has been tightened,
before closing the engine bonnet,
remove the tool A fig. 123and
replace it in its housing to prevent losing
it or damaging the engine.
The range between the MIN and MAX
levels corresponds to approximately 1
litre of oil.
Engine oil consumption
24)3)
The maximum engine oil consumption
is usually 400 grams every 1000 km.
When the car is new, the engine needs
to be run in; therefore the engine oil
consumption can only be considered
stabilised after the first 5,000 -
6,000 km.
IMPORTANT After adding or changing
the oil, let the engine run for a few
seconds and wait a few minutes after
stopping it before you check the level.
ENGINE COOLANT
122)
The coolant level must be checked
when the engine is cold and must
range between the MIN and MAX
marks on the reservoir.
If the level is too low, unscrew reservoir
plug C fig. 121 and add the fluid
described in the "Fluids and lubricants"
paragraph of the "TechnicalSpecifications" chapter.
WINDSCREEN WASHER
FLUID
123) 124)
To check the windscreen washer fluid
level, proceed as follows:
to avoid any interference during the
procedure, lift the windscreen wiper
blade according to the "Windscreen
wiper" paragraph in the "Maintenance
and care" chapter;
loosen the 4 self-tapping screws A
fig. 124 using the supplied screwdriver.
Remove the engine cover grille;
release the plug from the opening;
leaving the plug close to the opening,
put a finger on the central hole B
fig. 125 in the plug and remove it: the
level can be seen on the control pipe C
fig. 126 due to capillarity;
123A0L0231124A0L0130
134
SERVICING AND MAINTENANCE
25)

fig. 128 and remove the protection
panel;
check that the fluid is at the max.
level.
after checking, reposition the
protection panel and tighten the 2
self-tapping screws E.
If the fluid level in the reservoir is not
sufficient, proceed as follows:
take the black funnel for topping up
the brake fluid and its extension pipe
from the service kit in the luggage
compartment;
loosen the reservoir plug and
introduce the funnel F fig. 129 with the
extension pipe in the reservoir inlet;
after topping up, remove the funnel
F with the extension pipe;
tighten the reservoir plug;
reposition the protection panel and
tighten the 2 self-tapping screws E.WARNING Be very careful while
removing the plug from the opening to
prevent the plug from falling inside the
vehicle body.
IMPORTANT
22)Be careful not to confuse the various
types of fluids while topping up: they are
not compatible with each other! Topping up
with an unsuitable fluid could severely
damage your vehicle.
23)The oil level must never exceed the
MAX reference.
24)Do not add oil with specifications other
than those of the oil already in the engine.25)PARAFLU
UPanti-freeze fluid is used in
the engine cooling system; use the same
fluid type as that already in the cooling
system when topping up. PARAFLU
UP
may not be mixed with other types of
anti-freeze fluids. In the event of topping up
with an unsuitable product, under no
circumstances start the engine and contact
a dedicated Alfa Romeo Dealership.
26)Prevent brake fluid, which is highly
corrosive, from coming into contact with
painted parts. Should it happen,
immediately wash with water.
27)Be very careful while topping up the
brake fluid, as it could drip from the
extension pipe inside the vehicle
under-bonnet and on parts of the body and
windscreen, corroding and damaging
them. Adopt suitable protection (e.g
absorbing paper) to reduce this risk as
much as possible.
WARNING
118)The Alfa Romeo 4C is designed and
produced for road use, in compliance with
the current regulations. Vehicle use in the
track must be considered as occasional
and in any case under the responsibility of
the user. The vehicle CANNOT be modified
or tampered with for any reason; this
would alter the Manufacturer homologation
and/or safety requirements. Using a
modified or tampered product relieves the
Manufacturer from any responsibility on the
product and may expose people to serious
risks.
128A0L0149
129A0L0160
136
SERVICING AND MAINTENANCE

119)Never smoke while working in the
engine compartment: gas and inflammable
vapours may be present, with the risk of
fire.
120)Be very careful when working in the
engine compartment when the engine is
hot: you may get burned.
121)If the engine oil is being topped up,
wait for the engine to cool down before
loosening the filler plug, particularly for
vehicles with aluminium plug (for
versions/markets, where provided).
WARNING: risk of burns!
122)The cooling system is pressurised. If
necessary, only replace the plug with
another original or the operation of the
system may be adversely affected. Do not
remove the reservoir plug when the engine
is hot: you risk scalding yourself.
123)Do not travel with the windscreen
washer fluid reservoir empty: the
windscreen washer is essential for
improving visibility. Repeated operation of
the system without fluid could damage or
cause rapid deterioration of some system
components.
124)Some commercial additives for
windscreen washer fluid are flammable.
The engine compartment contains hot
components which may start a fire.
125)Brake fluid is poisonous and highly
corrosive. In the event of accidental
contact, immediately wash the affected
parts with water and mild soap. Then rinse
thoroughly. Call a doctor immediately if
swallowed.
126)The symbol
, on the brake fluid
container indicates if a brake fluid is
synthetic or mineral-based. Use of mineral
type fluids will damage the special rubber
seals of the braking system beyond repair.
IMPORTANT
3)Used engine oil and oil filters contain
substances which are harmful to the
environment. You are advised to go to a
dedicated Alfa Romeo Dealership to have
the oil and filters changed.
AIR CLEANER
For cleaner replacement, contact a
dedicated Alfa Romeo Dealership.
137

FLUIDS AND LUBRICANTS
Your car is equipped with an engine oil that has been thoroughly developed and tested in order to meet the requirements of the
Scheduled Servicing Plan. Constant use of the prescribed lubricants guarantees the fuel consumption and emission
specifications. Lubricant quality is crucial for engine operation and duration.
PRODUCT SPECIFICATIONS
UseFluid and lubricant specifications for a correct use
of the carGenuine fluids and
lubricantsReplacement interval
Lubricant for petrol
engines
32)
SAE 5W-40 ACEA C3 grade totally synthetic lubricant.
FIAT 9.55535-GH2 classification.SELENIA SPORT POWER
Contractual Technical
Reference No. F052.H12According to Scheduled
Servicing Plan
163

Driver's side front airbag.........90
Driving style................101
DTC (Drag Torque Control) system . .41
EBD system................41
Electric windows..............37
Engine
engine cooling system fluid level......................134
identification codes.........148
marking................147
technical data............149
Engine codes...............148
Engine compartment
checking levels............132
washing................142
Engine coolant indicator.........60
Engine cover
Closing..................39
Opening.................38
Engine oil
consumption.............134
level check..............134
EOBD system...............46
ESC (Electronic Stability Control)
system..................40
Exterior lights................28
Extinguisher.................35
Filling the tank...............54
Fitting "Universal" child restraint
system..................87Fix&Go automatic kit..........106
Flashing...................29
Fluids and lubricants
(specifications)............163
Front airbags................90
Fuel consumption............166
Fuel cut-off system............33
Fuel level gauge..............60
Fuel supply................150
Fuses (replacement)...........120
Gear Shift Indicator...........60
Handbrake.................96
Hazard warning lights...........32
HBA system................42
Headlights..................39
Adjusting the headlights abroad.......................39
bulb replacement..........116
Light beam direction.........39
Heating and ventilation..........24
Hill Holder system.............42
Identification data
bodywork paint plate........147
chassis marking...........146
engine marking............147
identification data plate.......146
Ignition switch...............18
Steering lock..............18
Installing electrical/electronic
devices................5,47Instrument panel..............58
Interior fittings...............33
Interiors (cleaning)............143
Jack....................109
Lavacristallo
livello liquido lavacristallo......134
Light clusters
front light clusters (changing a
bulb)..................116
rear light clusters (changing a
bulb)..................117
Lubricants (specifications).......163
Luce plafoniera
sostituzione lampada........119
Luggage compartment
Opening.................38
Luggage compartment / Engine
cover...................38
Main beam headlights..........28
bulb replacement..........116
Maintenance and care
heavy-duty use of the car.....131
periodic checks...........131
scheduled servicing.........127
scheduled servicing plan......128
Manual climate control..........26
Menu.....................61
Menu options................61
Number plate lights
bulb replacement..........118
INDEX