2016 Acura ILX pan

uuChild Safety uSafety of Infants and Small Children
54
Safe Driving
3. Open the tether anchor cover behind the
head restraint.
4. Raise the head restraint to its highest
position, then rout e the tether strap
between the head restraint legs, and secure
the tether strap hook onto the anchor.
5. Tighten the tether strap as instructed by the
child seat manufacturer.
6. Make sure the child seat is firmly secured by
rocking it forward and back and side to
side; little movement should be felt.
7. Make sure any unused seat belt that a child
can reach is buckled, the lockable retractor
is activated, and the be lt is fully retracted
and locked.
Flexible Type
1 Installing a LATCH-Compatible Child Seat
For your child's safety, when using a child seat
installed using the LATCH system, make sure that the
seat is properly secured to the vehicle. A child seat
that is not properly secu red will not adequately
protect a child in a crash and may cause injury to the
child or other vehicle occupants.
Tether
Strap
Hook
Anchor
16 ACURA ILX-31TX66300.book 54 ページ ２０１４年１２月２２日　月曜日　午後１０時１５分

Continued55
uuChild Safety uSafety of Infants and Small Children
Safe Driving1. Place the child seat on the vehicle seat.
2. Route the seat belt through the child seat
according to the seat manufacturer’s
instructions, and insert the latch plate into
the buckle.
u Insert the latch plate fully until it clicks.
3. Slowly pull the shoulder part of the belt all
the way out until it stops. This activates the
lockable retractor.
4. Let the seat belt completely wind up into
the retractor, then try to pull it out to make
sure the retractor is locked.
u If you are able to pull the shoulder belt
out, the lockable retractor is not
activated. Pull the seat belt all the way
out, and repeat steps 3 – 4.
5. Grab the shoulder part of the seat belt near
the buckle, and pull up to remove any slack
from the lap part of the belt.
u When doing this, place your weight on
the child seat and push it into the vehicle
seat.
■Installing a Child Seat with a Lap/Shoulder Seat Belt1Installing a Child Seat with a Lap/Shoulder Seat Belt
A child seat that is not properly secured will not
adequately protect a child in a crash and may cause
injury to the child or other vehicle occupants.
16 ACURA ILX-31TX66300.book 55 ページ ２０１４年１２月２２日　月曜日　午後１０時１５分

63
Instrument Panel
This chapter describes the buttons, indicators, and gauges that are used while driving.
Indicators............................................ 64
Multi-Information Display Warning and Information Messages ...................... 81
Gauges and Multi-Information Display Gauges .............................................. 88
Multi-Information Display .................. 89
16 ACURA ILX-31TX66300.book 63 ページ ２０１４年１２月２２日　月曜日　午後１０時１５分

64
Instrument Panel
Indicators
*1:On the left: Models without full color displayOn the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Parking Brake
and Brake
System
Indicator
(Red)
●Comes on for a few seconds
when you set the power mode
to ON, then goes off if the
parking brake has been
released.
●Comes on when the parking
brake is applied, and goes off
when it is released.
●Comes on when the brake
fluid level is low.
●Comes on if there is a problem
with the brake system.
●The beeper sounds and the
indicator comes on if you drive
with the parking brake not
fully released.
●Comes on while driving - Make sure
the parking brake is released. Check
the brake fluid level.
2 What to do when the indicator
comes on while driving P. 493
●Comes on along with the ABS
indicator - Have the vehicle checked
by a dealer.
2 If the Brake System Indicator
(Red) Comes On P. 493
U.S.
Canada
16 ACURA ILX-31TX66300.book 64 ページ ２０１４年１２月２２日　月曜日　午後１０時１５分

65
uuIndicators u
Continued
Instrument Panel
*1:On the left: Models wi thout full color display
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Brake System
Indicator
(Amber)
●Comes on for a few seconds
when you set the power mode
to ON, then goes off.
●Comes on if there is a problem
with a system related to
braking other than the
conventional brake system.
●Comes on while driving - Have your
vehicle checked by a dealer.
●Stays on constantly - Avoid high
speeds and sudden braking. Take the
vehicle to a dealer immediately.
●With this indicator on, your vehicle still
has normal braking ability.
—
Low Oil
Pressure
Indicator
●Comes on when you set the
power mode to ON, and goes
off when the engine starts.
●Comes on when the engine oil
pressure is low.
●Comes on while driving -
Immediately stop in a safe place.
2 If the Low Oil Pressure Indicator
Comes On P. 491
U.S.
Canada
(Amber)
U.S.
Canada
U.S.
Canada
16 ACURA ILX-31TX66300.book 65 ページ ２０１４年１２月２２日　月曜日　午後１０時１５分

66
uuIndicators u
Instrument Panel
*1:On the left: Models without full color display
On the right: Models with full color display
*2:Models with full color display
*3:Models without full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Shift Lever
Position
Indicator
●Indicates the current gear
selection.
2 Shifting P. 345——
Transmission
Indicator
●Blinks if the transmission
system has a problem.●Blinks while driving - Avoid sudden
starts and acceleration and have the
vehicle checked by a dealer
immediately.
M (sequential
mode)
Indicator/
Gear Position
Indicator●Comes on when the manual
sequential mode is applied.
2 Sequential Shift Mode Operation
P. 348——
*2
*3
*2
*3
*2
*3
16 ACURA ILX-31TX66300.book 66 ページ ２０１４年１２月２２日　月曜日　午後１０時１５分

67
uuIndicators u
Continued
Instrument Panel
*1:On the left: Models wi thout full color display
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Malfunction
Indicator
Lamp
●Comes on when you set the
power mode to ON, and goes
off either when the engine
starts or after several seconds
if the engine did not start. If
“readiness codes” have not
been set, it blinks five times
before it goes off.
●Comes on if there is a problem
with the emissions control
system.
●Blinks when a misfire in the
engine's cylinders is detected.
●Readiness codes are part of the on
board diagnostics for the emissions
control systems.
2 Testing of Readiness Codes P. 505●Comes on while driving - Have the
vehicle checked by a dealer.
●Blinks while driving - Stop in a safe
place where there are no flammable
objects. Stop the engine for 10 minutes
or more, and wait for it to cool down.
Then, take the vehicle to a dealer.
2 If the Malfunction Indicator Lamp
Comes On or Blinks P. 492
Charging
System
Indicator
●Comes on when you set the
power mode to ON, and goes
off when the engine starts.
●Comes on when the battery is
not charging.
●Comes on while driving - Turn off
the climate control system and rear
defogger in order to reduce electricity
consumption.
2 If the Charging System Indicator
Comes On P. 491
16 ACURA ILX-31TX66300.book 67 ページ ２０１４年１２月２２日　月曜日　午後１０時１５分

68
uuIndicators u
Instrument Panel
*1:On the left: Models without full color display
On the right: Models with full color display
IndicatorNameOn/BlinkingExplanationMessage*1
Seat Belt
Reminder
Indicator
●Comes on and the beeper
sounds if you are not wearing
a seat belt when you set the
power mode to ON.
●If the front passenger is not
wearing a seat belt, the
indicator comes on a few
seconds later.
●Blinks while driving if either
you or the front passenger has
not fastened a seat belt. The
beeper sounds and the
indicator blinks at regular
intervals.
●The beeper stops and the indicator
goes off when you and the front
passenger fasten their seat belts.
●Stays on after you or the front
passenger has fastened the seat
belt - A detection error may have
occurred in the sensor. Have the vehicle
checked by a dealer.
2 Seat Belt Reminder P. 29
Low Fuel
Indicator
●Comes on when the fuel
reserve is running low
(approximately 1.9 U.S. gal./
7.5 Liter left).
●Blinks if there is a problem
with the fuel gauge.
●Comes on - Refuel your vehicle as soon
as possible.
●Blinks - Have the vehicle checked by a
dealer.
16 ACURA ILX-31TX66300.book 68 ページ ２０１４年１２月２２日　月曜日　午後１０時１５分