Page 249 of 288
Downloaded from www.Manualslib.com manuals search engine
, 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
6 L G H 7 X U Q 6 L J Q D O / L J K W L I H T X L S S H G
76MH0A006
1) Remove the light housing (1) by sliding
to left with your finger.
76MH0A007
2) Turn the bulb holder (2) clockwise and
pull it out from the light housing.
76MH0A008
(4) Removal
(5) Install
3) To remove and install the bulb of the
turn signal light (3), simply pull out or
push in the bulb.
) U R Q W 7 X U Q 6 L J Q D O / L J K W
) U R Q W 3 R V L W L R Q / L J K W (Vehicle with the halogen headlights)
61MM0A030
(1)
(2)
(3)
(4)
(5)
(2)
(1)
Page 250 of 288
Downloaded from www.Manualslib.com manuals search engine , 1 6 3 ( & 7 , 2 1 $ 1 ' 0 $ , 1 7 ( 1 $ 1 & (
0 6 (
61MM0B077
1) Open the engine hood. To remove the
bulb holder of the front turn signal light
(1) or the front position light (2) from the
light housing, turn the holder counter-
clockwise and pull it out.
61MM0B078
(3) Removal
(4) Install
2) To remove the bulb of the front turn sig-
nal light (1) from the bulb holder, push in
the bulb and turn it counterclockwise. To
install a new bulb, push it in and turn it
clockwise.
To remove and install the bulb of the
front position light (2), simply pull out or
push in the bulb.
9 H K L F O H Z L W K W K H G L V F K D U J H K H D G O L J K W V
61MM0A091
To replace the bulb of the front turn signal
light (1), follow the procedure for the front
turn signal light bulb replacement of the
vehicle with the halogen headlights.NOTE:
Position function in discharge headlamp is
LED type, which is non replaceable.
(2)(1)
(2)
(1) (3)
(4)
( ; $ 0 3 / (
(1)
Page 268 of 288
Downloaded from www.Manualslib.com manuals search engine ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
- X P S V W D U W L Q J L Q V W U X F W L R Q V
: K H Q - X P S 6 W D U W L Q J < R X U 9 H K L F O H
8 V H W K H ) R O O R Z L Q J 3 U R F H G X U H 1) Use only a 12-volt battery to jump start
your vehicle. Position the good 12-volt
battery close to your vehicle so that the
jump leads will reach both batteries.
When using a battery installed on
another vehicle, DO NOT LET THE
VEHICLES TOUCH. Set the parking
brakes fully on both vehicles.
2) Turn off all vehicle accessories, except
those necessary for safety reasons (for
example, headlights or hazard lights).
54MN259
3) Make jump lead connections as follows:
1. Connect one end of the first jump
lead to the positive (+) terminal of the
flat battery (1).
2. Connect the other end to the positive
(+) terminal of the booster battery (2).
3. Connect one end of the second jump
lead to the negative (–) terminal of the
booster battery (2).
4. Make the final connection to an
unpainted, heavy metal part (i.e.
engine mount bracket (3)) of the
engine of the vehicle with the flat bat-
tery (1).
: $ 5 1 , 1 *
Page 270 of 288
Downloaded from www.Manualslib.com manuals search engine ( 0 ( 5 * ( 1 & < 6 ( 5 9 , & (
0 6 (
, I W K H 6 W D U W H U ' R H V 1 R W 2 S H U D W H1) Try turning the ignition switch to the
“START” position or try pressing the
engine switch to change the ignition
mode to START with the headlights
turned on to determine the battery condi-
tion. If the headlights go excessively dim
or go off, it usually means that either the
battery is flat or the battery terminal con-
tact is poor. Recharge the battery or cor-
rect battery terminal contact as
necessary.
, I W K H ( Q J L Q H L V ) O R R G H GIf the engine is flooded with the fuel, it may
be hard to start. If this happens, press the
accelerator pedal all the way to the floor
and hold it there while cranking the engine.
• For petrol engine model, do not operate
the starter motor for more than 12 sec-
onds.
• For diesel engine model, do not operate
the starter motor for more than 30 sec-
onds.
, I W K H ( Q J L Q H 2 Y H U K H D W VThe engine could overheat temporarily
under severe driving conditions. If the high
engine coolant temperature warning light
comes on as overheating during driving:
1) Turn off the air conditioner, if equipped.
2) Take the vehicle to a safe place and
park.
3) Let the engine run at the normal idle
speed for a few minutes until the high
engine coolant temperature warning
light goes off.
: $ 5 1 , 1 *
, I \ R X V H H R U K H D U H V F D S L Q J V W H D P
V W R S W K H Y H K L F O H L Q D V D I H S O D F H D Q G
L P P H G L D W H O \ W X U Q R I I W K H H Q J L Q H W R O H W
L W F R R O ' R Q R W R S H Q W K H K R R G Z K H Q
V W H D P L V S U H V H Q W : K H Q W K H V W H D P
F D Q Q R O R Q J H U E H V H H Q R U K H D U G R S H Q
W K H K R R G W R V H H L I W K H F R R O D Q W L V V W L O O
E R L O L Q J , I L W L V \ R X P X V W Z D L W X Q W L O L W
V W R S V E R L O L Q J E H I R U H \ R X S U R F H H G
Page 285 of 288
Downloaded from www.Manualslib.com manuals search engine
6 3 ( & , ) , & $ 7 , 2 1 6
0 6 (
, 7 ( 0 / L J K W V : $ 7 7 $ * ( % 8 / % 1 R
Headlight Halogen 12V 60/55W H4
Discharge 12V 25W D5S
Front fog light 12V 35W H8
Position light 12V 5W W5W
LED –
Turn signal light Front 12V 21W PY21W
Rear 12V 21W PY21W
Side turn signal light 12V 5W WY5W
LED –
Tail/brake light 12V 21/5W P21/5W
High mount stop light 12V 5W W5W
Reversing light 12V 16W W16W
License plate light 12V 5W W5W
Interior light Glove box light (if equipped) 12V 1.4W –
Footwell light (if equipped) /
Instrument panel pocket light
(if equipped)LED –
Center 12V 10W –
Other lights 12V 5W W5W
