2015 Peugeot 208 key battery

3
208_en_Chap00a_sommaire_ed01-2016
Fuel tank 154
Snow chains 1 58
Towing a trailer

1
59
Energy load

1
61
Accessories


162
Changing a wiper blade
1

64
Fitting roof bars

1
65
Bonnet


167
Checking levels

1
70
Checks
1

73
BlueHDi and AdBlue
® additive 1 74
Straight cut matt paint 1 81
Practical information
Triangle 1 82
Temporary puncture repair kit 1 83
Spare wheel

1
88
Changing a bulb
1

95
Fuses


202
12 V battery

2
08
To w i n g


2 12
Running out of fuel (Diesel)

2
14
In the event of a breakdown
Emergency call 222
Assistance call 2 23
7-inch touch screen

2
25
Audio system / Bluetooth

2
95
Audio system

3
15
Audio equipment and telematics
Alphabetical index Key
Warning
This symbol marks warnings which it is
essential to observe for your own safety,
for the safety of others or to avoid any risk
of damaging your vehicle.
InformationThis symbol draws your attention to
additional information for better use of
your vehicle.
Protection of the environmentThis symbol accompanies advice relating
to protection of the environment.
AdviceThis symbol indicates a reminder of
practical information.
Technical data
General information 2 15
Petrol engines 2 16
Diesel engines
2

17
Dimensions (in mm)

2
18
Identification markings
2

20
Contents

Over view
4
208_en_Chap00b_vue-ensemble_ed01-2016
Exterior view
Remote control key 3 5 -39, 44
- ope ning / closing
-
a

nti-theft protection
-
gu

ide-me-home lighting
-


starting
-

s
witching off
-


battery
-

u
nlocking the vehicle
-

l
ocking the vehicle Boot
4

3
-
ope

ning / closing
-
em

ergency release
Reversing camera
1

46
Temporary puncture repair kit

1
83 -187
Wipers
87- 89
Changing a wiper blade
1

64
Demisting - Defrosting
6

6-67
Changing bulbs
1

99-201
-
r

ear lamps
-
3
rd brake lamp
-
n
umber plate lamps
-


foglamp
Fuel tank, misfuel prevention
1

54-157
Running out of Diesel fuel

2
14
Sunroof blind

7

0
Roof bars

1

65
Accessories
1

62-163
Advice on care

1

81
Roadholding


90-92
Snow chains

1

58
Under- inf lation
15

1-153
Tyre pressures

1

86 -187, 220
Spare wheel

1

88 -194
-

tools
-

r

emoving / refitting
Lighting controls
7

7-83
LED lamps

8

3
Daytime running lamps
8

3
Headlamp beam adjustment
8

5
Cornering lighting
8

6
Changing bulbs
1

95-199
-

f

ront lamps
-


foglamps
-
d

irection indicator repeaters
Door mirrors

7

5 -76
Doors
35

-39, 40
-
ope

ning / closing
-

c

entral locking
-
em

ergency control
Courtesy lamp

6

8
Alarm
4

1- 42
Electric windows

4

6 - 47 Par k Assist
1

47-150
Parking sensors
1
44-145
Towbar
1
59-161
Towing

212-213

Access
38
208_en_Chap02_ouvertures_ed01-2016
Back-up door locking
For mechanically locking and unlocking the doors in the event of a fault with the central locking
system or a battery failure.
Driver's door
Insert the key in the lock to lock or unlock the
d o o r.
Passenger doors
F On the rear doors, check that the child lock is not on.
F

R
emove the black cap located on the edge
of the door, using the key.
F

I
nsert the key into the aperture without
forcing, then without turning, move the
latch sideways towards the inside of the
d o o r.
F

R
emove the key and refit the cap.

Access
44
208_en_Chap02_ouvertures_ed01-2016
Changing the battery
Battery ref.: CR1620 / 3 volts. If the battery is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.
F

U
nclip the cover using a screwdriver in the
cutout.
F

R
emove the cover.
F

E
xtract the flat battery from its location.
F

P
lace the new battery into its location
observing the original direction.
F

C
lip the cover in place.
Do not throw the remote control
batteries away, they contain metals
which are harmful to the environment.
Take them to an approved collection
point.
Remote control problem
Reinitialisation
F Switch off the ignition.
F
T urn the key to position 2 (Ignition) .
F

P
ress the closed padlock immediately for a
few seconds.
F

S
witch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again.
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
F

F

irst of all, use the key in the lock to unlock
or lock your vehicle.
F

T

hen, reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as possible.

Access47
208_en_Chap02_ouvertures_ed01-2016
Reinitialisation
Always remove the key when leaving
the vehicle, even for a short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this,
press the switch concerned.
When operating the passenger electric
window controls, the driver must ensure
that no one prevents the correct closing
of the windows.
The driver must ensure that passengers
use the electric windows correctly.
Be aware of children when operating
the windows.Advice
Inhibition
For the safety of your children, press
the control to prevent operation
of the windows of the rear doors,
irrespective of their position.
With the warning lamp on, the rear switches
are deactivated. With the warning lamp off, the
switches are active. Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch is not active during these
operations:
-
l

ower the window completely, then raise
it; it will rise in steps of a few centimetres
each time the switch is pressed. Repeat
the operation until the window closes
completely,
-

p
ress and hold the switch upwards for at
least 1 second after reaching this position,
window closed.
2

Driving131
208_en_Chap06_conduite_ed01-2016
Stop & Start
The "ECO" lamp comes on in the
instrument panel and the engine goes
into standby.
Operation
STOP mode
With e-HDi or BlueHDi Diesel and an
electronic gearbox:
-

S
peed below 4 mph (6 km/h).
-

G
ear lever in position N
Or
-
B

rake pedal pressed.
Special cases
STOP mode is not invoked when:
- the driver's door is open,
-

t
he driver's seat belt is not fastened,
-

t
he vehicle has not exceeded 6 mph
(10 km/h) since the last engine start using
t h e key,
-

t
he engine is needed to maintain a
comfortable temperature in the passenger
compartment,
-
d

emisting is selected,
-
s

ome special conditions (battery charge,
engine temperature, braking assistance,
ambient temperature...) where the engine is
needed to assure control of a system.
The "ECO" lamp flashes for a few
seconds then goes off.
This operation is perfectly normal.
The system puts the engine temporarily into
standby - STOP mode - during stops in the
traffic (red lights, traffic jams, ...). The engine
restarts automatically - START mode - as soon
as you want to move off. The restart takes
place instantly, quickly and silently.
Per fect for urban use, the Stop & Start system
reduces fuel consumption and exhaust
emissions as well as the noise level when
stationary.
With BlueHDi Diesel and a manual gearbox:
-

A

s soon as the vehicle stops.
-

G

ear lever in neutral and clutch pedal
released.
With PureTech petrol and a manual,
electronic or automatic gearbox:
-

A

s soon as the vehicle stops.
-

G

ear lever in neutral and clutch pedal
released (manual gearbox).
-

B

rake pedal pressed or gear lever in
position N (electronic or automatic
gearbox).
6

Driving
132
208_en_Chap06_conduite_ed01-2016
For your comfort, during parking
manoeuvres, STOP mode is not
available for a few seconds after
coming out of reverse gear.
The Stop & Start system does not affect
the functionality of the vehicle, such as
for example, braking, ...
Never refuel with the engine in STOP
mode; you must switch off the ignition
with the key. A time counter calculates the sum
of the periods in STOP mode
during a journey. It rests itself
to zero every time the ignition is
switched on with the key.
Advice
S TA R T m o d e
Special casesAs a safety measure and for your comfort,
START mode is invoked automatically when:
-
y

ou open the driver's door,
-
y

ou unfasten the driver's seat belt,
-
s

ome special conditions (battery charge,
engine temperature, braking assistance,
ambient temperature...) where the engine is
needed for control of a system.
The "ECO" warning lamp flashes for
a few seconds, then goes off.
This operation is perfectly normal.
With a manual gearbox
:
-

C

lutch pedal depressed.
With an electronic / automatic gearbox :
-

G

ear lever in position A / D or M .
-
B

rake pedal released. The "ECO"
lamp goes off and the
engine restarts.
or
-

G

ear lever in position N .
-
B

rake pedal released.
-

T

hen gear lever in position A / D or M .
or
-
R

everse gear engaged.
With a manual gearbox in STOP mode,
if you engage a gear without fully
depressing the clutch pedal, a message
is displayed asking you to fully depress
the clutch pedal so that the engine can
restart.

Driving133
208_en_Chap06_conduite_ed01-2016
Manual deactivation
- Press.
- T he indicator lamp in the control remains
on.
-

A m
essage is displayed.
If the vehicle is stationary in Stop mode, the
engine immediately restarts.
Manual reactivation
Driving on flooded roads
Before driving through a flooded road,
it is strongly recommended that you
deactivate the Stop & Start system.
For more advice on driving, particularly
on flooded roads, refer to the
corresponding section.
Opening the bonnet
Before doing anything under the
bonnet, deactivate the Stop & Start
system to avoid the risk of injury related
to an automatic change to START
mode.
In some circumstances, such as maintaining
a comfortable temperature in the passenger
compartment, it may be useful to deactivate
Stop & Start.
The system can be deactivated at any time,
once the ignition is on.
This control switches off the Stop & Start
system.
Operating fault
The Stop & Start system requires a
12 V battery of special specification and
technology.
All work on this type of battery must
be done by a PEUGEOT or a qualified
workshop.
For more information on the 12 V
battery, refer to the corresponding
section.
In the event of a fault with the system, the
"ECO OFF" switch warning lamp flashes then
comes on continuously.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
In the event of a fault in STOP mode, the
vehicle may stall. All of the warning lamps
come on. It is then necessary to switch off
the ignition and start the engine again using
t h e


key.
-

Press.
-

T

he indicator lamp in the control goes off.
-

A c

onfirmation message is displayed.
If the engine is in STOP mode, it then
restarts.
The Stop & Start

system is reactivated
automatically every time the ignition is
switched on.
6