2015 NISSAN JUKE clock


> (GLW   0RGHO )'@
6-6
In case ofemergency
SCE0948
Jack -uppoint
1. Place thejack directly underthejack-up
point asillustrated sothe top ofthe jack
contacts thevehicle atthe jack-up point.
Align thejack head between thetwo
notches inthe front orthe rear asshown.
Also fitthe groove ofthe jack head between
the notches asshown.
The jack should beused onlevel firm
ground.
SCE0504
2. Loosen eachwheel nutone ortwo turns by
turning itcounterclockwise withthewheel
nut wrench. Donot remove thewheel
nuts until thetire isoff the ground.
3. To lift the vehicle, securely holdthejack lever
and rodwith both hands asshown above.
Carefully raisethevehicle untilthetire clears
the ground. Remove thewheel nuts,and
then remove thetire.
&RQGLWLRQ


> (GLW   0RGHO )'@
8-10
Maintenance anddo-it-yours elf
SDI2651
1. Oilfiller cap
2. Oildrain plug
3. Oilfilter
Engine oiland filter
GUID-0E3 F5EC9-066 C-4F79-BD C5-1BCF07 F45F7E
1. Place alarge drain panunder thedrain plug.
2. Remove theoilfiller cap.
3. Remove thedrain plugwithawrench and
completely draintheoil.
CAUTION
Be careful nottoburn yourself, asthe
engine oilishot.
.
Waste oilmust bedisposed of
properly.
.
Check yourlocal regulations.
(Perform steps4to 7only when theengine
oil filter change isneeded.)
4. Loosen theoilfilter withanoilfilter wrench.
Remove theoilfilter byturning itby hand.
5. Wipe theengine oilfilter mounting surface
with aclean rag.
CAUTION
Be sure toremove anyoldgasket
material remaining onthe mounting
surface ofthe engine. Failuretodo so
could leadtoengine damage.
6. Coat thegasket onthe new filter withclean
engine oil.
7. Screw inthe oilfilter clockwise untilaslight
resistance isfelt, then tighten additionally
more than2/3turn.
Oil filter tightening torque:
11 to15 ft-lb
(14.7 to20.5 N´m)
8. Clean andre-install thedrain plugwitha
new washer. Securely tightenthedrain plug
with awrench. Drain
plugtightening torque:
22 to29 ft-lb
(29 to39 N´m)
Do not use excessive force.
9. Refill theengine withtherecommended oil
through theoilfiller opening, andinstall the
oil filler capsecurely .
See ªCapacities andrecommended fluids/
lubricantsº (P.9-2) fordrain andrefill capa-
city .The drain andrefill capacity depends on
the oiltemperature anddrain time.Use
these specifications forreference only.Al-
ways usethedipstick todetermine the
proper amount ofoil inthe engine.
10. Start theengine andcheck forleakage
around thedrain plugandtheoilfilter.
Correct asrequired.
11. Turn theengine offand wait more than10
minutes. Checktheoillevel withthedipstick.
Add engine oilifnecessary .
After theoperation
GUID-02 E3EFF4-6A0C -4167-AC8B-E5E800B0 3EDA
1. Lower thevehicle carefully tothe ground.
2. Dispose ofwaste oiland filter properly .
&RQGLWLRQ