2015 MITSUBISHI MIRAGE USB

Cup holders 5-108 Features and controls
5
N00551500275
To open, pull the lever (A).
N00527301433
The cup holder is designed for holding cups or drink-cans secu
rely in its holes.
The cup holder is located in front of the floor console.
N00537000175 N00502800065
Glove compartment
WA R N I N G An open glove comp
artment door can
cause a serious injury or death to the frontpassenger in an accident, even if the pas- senger is wearing his/
her seat be
lt. Always
keep the glove comp
artment door closed
when driving.NOTE
 The USB input terminal (if so equipped) is located in the glove compartment. Fordetails, refer to “USB input terminal” on page 5-101.
Cup holders
NOTE
 Plastic bottles may sometimes not fit securely depending on the shape of the bot- tle. Plastic bottles could fall if driving isdone while a plastic bot
tle is not securely
placed, so check that plastic bottles are placed securely or
use the bottle holder.
For the front seat
CAUTIONDo not drink beverages while driving your vehicle.This is distracting a
nd could cause an acci-
dent.
For the rear seat Bottle holders
CAUTION Drink beverages while
driving your vehicle
is distracting and ca
n cause an accident.
Vibration and shaking while driving may cause beverages to spill.
Be very careful, as
spilling hot beverage
s could cause burns.
BK0212400US.book 108 ページ ２０１４年４月１日　火曜日　午後２時２１分

7
Comfort controlsVents ................................................................................................7-2 Heater without air conditioning functi
on (if so equipped) ...............7-4
Manual air conditioning (if so equipped) .........................................7-7Automatic air conditioning (if so equipped)................................... 7-11 Important air conditioning operating tips ..
...........
...........
.........
.....7-17
Air purifier (if so equipped)............................................................7-18AM/FM electronically tune
d radio with CD player
(if so equipped) ..........................................................................7-18 To play tracks from USB device (if so equipped) ..........................7-27 To play tracks from a Bluetooth
® device
(vehicles with Bluetooth
® 2.0 interface) ...................................7-35
Steering wheel audio remote control
switches (if so equipped) .....7-37
Error codes .....................................................................................7-38 Handling of compact discs .............................................................7-40 Antenna ..........................................................................................7-41General information about your radio .....
...........
...........
...........
.....7-42
BK0212400US.book 1 ページ ２０１４年４月１日　火曜日　午後２時２１分

To play tracks from USB device (if so equipped)
Comfort controls 7-27
7
N00762200056
You can connect your iPod or USB memory device to the USB input terminal and playmusic files stored in the iPod or USB mem- ory device. See the following section for the types ofconnectable devices
and supported files.
Refer to “Types of connectable devices and supported file specifications” on page 5-103.See the following sections for the connecting methods, “How to conne
ct an iPod” on page
5-102 and “How to connect a USB memorydevice” on page 5-101. If your vehicle is equipped with a Bluetooth
®
2.0 interface, you can play music files in your iPod or USB memory de
vice via voice opera-
tion. Refer to “To play iPod
tracks via voice opera-
tion” on page 7-29 and “To play USB mem-
ory device tracks via voice operation” on page 7-35.
N00762300060
N00762400087
1. Press the PWR switch to turn on the audio system. The system turns on in the lastmode used. 2. Connect your iPod to the USB input ter- minal.Refer to “How to connect an iPod” on page 5-102. 3. Press the CD button several times toswitch to the iPod mode. The input mode changes as follows every time the CD but- ton is pressed: CD mode
 iPod mode
 Bluetooth
® mode (if so equipped)

AUX mode
 CD mode.
The iPod indicator are illuminated andthen the iPod mode will be activated. 4. Once the device is selected, playback starts and indicato
r appears on the dis-
play.
 If the connection cord
alone is left connected
to the auxiliary audi
o connector, noise may
be produced from the speakers.  For information on how to connect and oper- ate the commercially av
ailable audio equip-
ment, refer to the ow
ner’s manual for the
commercially availabl
e audio equipment.
To play tracks from USB device
(if so equipped)
NOTE
NOTE
 A file protected by c
opyright might not be
able to playback.  It is recommended to adjust the equalizer of the connected device to 0 db or neutral.
iPod control panel and display

1- CD (Mode changeover) button 2- RADIO button 3-
DISP (Title display)/ (Return) but- ton
4-
(USB device active) indicator
5- iPod indicator 6- Display 7- TRACK indicator8- RPT (Repeat mode) indicator
9- RDM (Random mode)/F-RDM (Folder
random mode) indicator
10- SEL (Select)
indicator
11- PAGE (Title scroll) button 12-
(Fast-reverse/Track down) button
13-
(Fast-forward/Track up) button
14- PWR (On-Off)/SEL (Select) switch 15- RPT (Repeat) button 16- RDM (Random) buttonTo play from an iPod

BK0212400US.book 27 ページ ２０１４年４月１日　火曜日　午後２時２１分

To play tracks from USB device (if so equipped) 7-28 Comfort controls
7
5. To stop the playback, press the RADIO button or CD button to switch to a differ-ent mode.
N00762500033
To fast-forward/reverse the current track, press the button or button. To fast-forward the current track, press the
button. While the button is kept pressed,
the track will be fast-forwarded.
To fast-reverse the current track, press the button. While the button is kept pressed, the track will be fast-reversed.
N00762600034
Press the button repeatedly until the desired track number appears on the display. Press the button repeatedly until the desired track number appears on the display.
N00762700077
You can select desired tracks from the “Playl- ists”, “Artists”,
“Albums”, “Songs” or
“Genre” (vehicles with Bluetooth
® 2.0 inter-
face) menus on your iPod. Operate the SEL switch to select desired tracks. The selected menu or category or track is shown in the display.When this mode is activated by pressing the SEL switch, the SEL i
ndicator will be dis-
played in the display.
NOTE
 Depending on the condition of your iPod, it may take a longer time
before the playback
starts.NOTE
 Buttons on the iPod are disabled while the iPod is connected to the audio system.  To adjust the volume and tone, refer to “To adjust the volume” on page 7-18 and “To adjust the tone” on page 7-19.
To fast-forward/reverse the track

Fast-forward
Fast-reverseTo select a desired track

Tr a c k u p Tr a c k d o w n
NOTE
 Pressing the button once during the song will cause the audio system to restart play- back from the beginning of the song.
To find a track from the iPod menu

Press the SEL switch :To start this mode or
to select the menu or category or track.
Turn the SEL switch :To show the menu or
category or track.
NOTE
 To cancel the selecti
on, press the button
to return to the previous step.  If no operation is perf
ormed for 10 seconds
or more or other butt
on is operated after the
SEL switch has been pressed, searching of the desired tracks is canceled.  If no operation is performed for 5 seconds or more after the track is
displayed, playback
starts.  When the SEL indicato
r is not shown on the
display and the SEL switch is operated, the volume adjustment is activated.
BK0212400US.book 28 ページ ２０１４年４月１日　火曜日　午後２時２１分

To play tracks from USB device (if so equipped)
Comfort controls 7-29
7
N00762800023
Press the RPT button during playback to show “RPT” in the display. To exit this mode, press the button again.
N00762900024
Press the RDM button to show “RDM” in thedisplay. The iPod randomly select
s tracks from the
current category and plays the selected tracks.To exit this mode, press the button again.
N00763000035
Press and hold the RDM button until you heara beep to show “F-RDM” in the display.The iPod randomly sele
cts tracks in the
album from the current category and play the selected tracks.To exit this mode, press the button again.
N00763100049
You can display the track titles, artist names,genre and album titles recorded in the iPod. The display changes as follows every time the DISP button is pressed during playback:
Album title
 Track name
 Artist name

Genre (vehicles with Bluetooth
® 2.0 inter-
face)
 Normal display.
N00763200040
Desired tracks can be
selected and played
from your iPod by “Artis
t”, “Album”,
“Playl-
ist” and “Genre” us
ing voice commands.
For information concerning the voice recog- nition function or spea
ker registration func-
tion, refer to “Bluetooth
® 2.0 interface” on
page 5-81. The following explains how to prepare forvoice operation and play the tracks.
N00763300067
To use the voice operation, press the SPEECH button (A) first.
N00763400039
1. Say “Play” on the main menu.
To play the same track repeatedly

To play tracks in random order

To play tracks in each album in random order

To switch the display

NOTE
 Up to 11 characters are shown in the display at once. If the title is cut off in the middle,press the PAGE button. The next characters are displayed every time this button is pressed.  If no title is stored, “NO TITLE” is shown in the display.  Characters that cannot
be displayed are sub-
stituted by “•”.
To play iPod tracks via voice operation (vehicles with Blue- tooth
® 2.0 interface)

Preparation for voice operation

To search by artist name

NOTE
 The Bluetooth
® 2.0 interface
starts recogniz-
ing the connected device. If the connected device
cannot be recognized
or a connection error
occurs, the Bluetooth
®
2.0 interface starts an appropriate voice guide. Follow th
e voice guide.
BK0212400US.book 29 ページ ２０１４年４月１日　火曜日　午後２時２１分

To play tracks from USB device (if so equipped) 7-30 Comfort controls
7
2. After the voice guide says “Would you like to play by Artist, Album, Playlist orGenre?,” say “Artist”. 3. After the voice guide
says “What Artist
would you like to play?,” say the artist name.4. If there is only one ma
tch, the system pro-
ceeds to step 6. 5. If there are two or more matches, thevoice guide will say “More than one match was found, would you like to play ?” If you
say “Yes,” the sys-
tem proceeds to step 6. If you say “No,” the next matching artist is uttered by the system.
6. After the voice guide
says “Playing name>,” the system creates a playlistindex for the artist. 7. The system exits
the voice recognition
mode and starts playback.
N00763500030
1. Say “Play” on the main menu. 2. After the voice guide says “Would you like to play by Artist, Album, Playlist orGenre?,” say “Album”.
3. After the voice gui
de says “What Album
would you like to play?” say the album title. 4. If there is only one ma
tch, the system pro-
ceeds to step 6. 5. If there are two or more matches, the voice guide will say “More than onematch was found, would you like to play ?” If yo
u say “Yes,” the sys-
tem proceeds to step 6.If you say “No,” the name of the next matching album is uttered by the system. 6. After the voice gui
de says “Playing
,” the system creates a playl- ist index for the album title.
NOTE
 If you say “Artist ,” you can skip step 3.NOTE
 If you say “No” to three or all artist names uttered by the system, the voice guide willsay “Artist not found, please try again” andthe system returns to step 2.  Search time depends
on the number of songs
on your connected devi
ce. Devices contain-
ing a large number of songs may take longer to return search results.
NOTE
 If the confirmation function is active, the voice guide confirms if
the artist name is
correct. If the artist name is correct, say “Yes”. If not, say “No”. After the voice guidesays “Artist not found, please try again,” the system returns to step 2.
To search by album title

NOTE
 The Bluetooth
® 2.0 interface
starts recogniz-
ing the connected device. If the connected device
cannot be recognized
or a connection error
occurs, the Bluetooth
®
2.0 interface starts an appropriate voice guide. Follow the voice guide.
NOTE
 If you say “Album