2015 MITSUBISHI L200 spare wheel

Exterior - rear (Single cab)E00100505419
1234567891. High-mounted stop lamp p. 10-25, 10-34
2. Rear turn-signal lamps p. 5-36, 10-25, 10-33
3. Stop and tail lamps p. 5-32, 10-25, 10-33
4. Reversing lamps p. 10-25, 10-33
5. Tyre inflation pressures p. 10-12 Changing tyres p. 8-18
Tyre rotation p. 10-14
Tyre chains p. 10-15
6. Spare wheel p. 8-17
7. Licence plate lamps p. 5-32, 10-25, 10-35
8. Rear fog lamp (Driver’s side only) p. 5-38, 10-25, 10-33
9. Rear gate p. 3-11
Exterior - rear (Single cab)
1-17OKTE15E3Overview1

Exterior - rear (Club cab)E001005050571. Rear turn-signal lamps p. 5-36, 10-25, 10-33
2. Stop and tail lamps p. 5-32, 10-25, 10-33
3. Reversing lamps p. 10-25, 10-33
4. Tyre inflation pressures p. 10-12 Changing tyres p. 8-18
Tyre rotation p. 10-14
Tyre chains p. 10-15
5. Spare wheel p. 8-17
6. Licence plate lamps Type 1 p. 5-32, 10-25, 10-35
7. Rear fog lamp (Driver’s side only) Type 2* p. 5-38, 10-25, 10-33
8. Rear fog lamp (Driver’s side only) Type 1* p. 5-38, 10-25, 10-33
9. Rear gate p. 3-11
10. High-mounted stop lamp p. 10-25, 10-34
Exterior - rear (Club cab)
1-19OKTE15E3Overview112
3
4
5
6
7 8
9
10

Exterior - rear (Double cab)E001005050601. Rear turn-signal lamps p. 5-36, 10-25, 10-33
2. Stop and tail lamps p. 5-32, 10-25, 10-33
3. Reversing lamps p. 10-25, 10-33
4. Tyre inflation pressures p. 10-12 Changing tyres p. 8-18
Tyre rotation p. 10-14
Tyre chains p. 10-15
5. Spare wheel p. 8-17
6. Licence plate lamps Type 1 p. 5-32, 10-25, 10-35
7. Rear fog lamp (Driver’s side only) Type 2* p. 5-38, 10-25, 10-33
8. Rear fog lamp (Driver’s side only) Type 1* p. 5-38, 10-25, 10-33
9. Rear gate p. 3-11
10. High-mounted stop lamp p. 10-25, 10-34
Exterior - rear (Double cab)
1-21OKTE15E3Overview112
3
4
5
6
7 8
9
10

If the vehicle breaks down.................................................................. 8-02Emergency starting............................................................................. 8-02
Engine overheating............................................................................. 8-04
Bleeding the fuel system..................................................................... 8-05 Removal of water from the fuel filter................................................. 8-06
Tools, jack and jack handle................................................................. 8-07 Jacking up the vehicle......................................................................... 8-13
Spare wheel......................................................................................... 8-17
How to change a tyre.......................................................................... 8-18
Towing................................................................................................ 8-22
Operation under adverse driving conditions....................................... 8-25For emergencies
OKTE15E38

WARNINGlBe sure to apply chocks or blocks to the
correct tyre when jacking up the vehicle.If the vehicle moves while jacked up, the
jack could slip out of position, leading to
an accident.NOTEl The chocks shown in the illustration do not
come with your vehicle. It is recommended
that you keep one in the vehicle for use if needed.
l If chocks are not available, use stones or any
other objects that are large enough to hold the wheel in position.
6. Get the spare wheel, jack and jack han-
dle ready.
7. Place the jack under one of the jacking
points shown in the illustration. Use the jacking point closest to the tyre you wish
to change.
2WD vehicles with 15 inch wheelsC-Front jacking point (2WD vehicles with
15 inch wheels)2WD vehicles with 16 inch wheels and
4WD vehiclesD-Front jacking point (2WD vehicles 16
inch wheels and 4WD vehicles)E-Rear jacking point
Jacking up the vehicle
8-14OKTE15E3For emergencies8

Spare wheelE00801100094
The spare wheel is stored under the floor of the cargo bed.
A- Spare wheel
CAUTIONl When removing the spare wheel, put on
gloves. Removing the spare wheel with your
bare hands may cause injury to the fingers.CAUTIONl Check the air pressure of the spare wheel
frequently and make sure it is ready for
emergency use at any time.
Driving with an insufficient tyre pressure
can lead to an accident. If you have no choice but to drive with an insufficient tyre
pressure, keep your speed down and inflate the tyre to the correct pressure as soon as possible. (Refer to “Tyre inflation pressures”
on page 10-12.)
Maintaining the spare wheel at the highest
specified air pressure will ensure that it can always be used under any conditions (city/
high-speed driving, varying load weight,
etc.).
To remove
1. Set the jack handle. (Club cab, Double
cab with rear retractable power window
only)
(Refer to “To use the jack handle” on page 8-13.)
2. Insert the jack handle (A) in the hole (B)
below the rear gate.
3. Securely insert the pin (C) on the jack
handle into the holder (D) of the spare
wheel carrier.
Spare wheel
8-17OKTE15E3For emergencies8

4.Insert the wheel nut wrench (E) through
the end of the jack handle hole (F), and
then turn it anticlockwise to lower the spare wheel completely to the ground
and to slack the chain.
5. Remove the hanger disc (G) from the
spare wheel.
To install
1. Install the hanger disc (A) in the wheel
disc hole.
2. Turn the wheel nut wrench (B) clock-
wise to wind up the chain.
NOTEl Confirm that the hanger disc is securely fit-
ted in the wheel disc hole when the wheel isjust lifted off the ground.
3. After winding up the spare wheel suffi-
ciently, make sure it is not loose (the tightening torque should be approxi-
mately 40 Nm) then withdraw the jack
handle, taking care not to turn it in the
reverse direction.
CAUTIONl The spare wheel should always be securely
in position.
If a flat tyre is changed, put the flat tyre in
the spare wheel mounting position with the wheel outer surface upward, and use the wheel nut wrench to secure it firmly.How to change a tyre
E00801202653
Before changing a tyre, first stop your vehi-cle in a safe, flat location. 1. Park the vehicle on level and stable
ground.
2. Set the parking brake firmly.
How to change a tyre
8-18OKTE15E3For emergencies8

3.On vehicles with manual transmission,
turn the ignition key to the “LOCK” po-
sition, move the gearshift lever to the “R” (Reverse) position.
On vehicles with automatic transmis- sion, move the selector lever to the “P” (PARK) position, turn the ignition key to
the “LOCK” position.
4. Turn on the hazard warning flashers and
set up a warning triangle, flashing signal lamp, etc., at an adequate distance from
the vehicle, and have all your passengers
leave the vehicle.
5. To prevent the vehicle from rolling
when it is raised on the jack, place
chocks or blocks (A) at the tyre that is diagonally opposite from the tyre (B)
you are changing.WARNINGl Be sure to apply chocks or blocks to the
correct tyre when jacking up the vehicle.If the vehicle moves while jacked up, the
jack could slip out of position, leading to
an accident.NOTEl The chocks shown in the illustration do not
come with your vehicle. It is recommended
that you keep one in the vehicle for use if needed.
l If chocks are not available, use stones or any
other objects that are large enough to hold the wheel in position.
6. Get the spare wheel, jack, jack handle
and wheel nut wrench ready.
NOTEl Put the spare wheel under the vehicle body
near the flat tyre. This makes it safer if the jack slips out of position.
7. Loosen the wheel nuts with the wheel
nut wrench. Do not remove the wheel nuts yet.
Five wheel nutsSix wheel nuts
How to change a tyre
8-19OKTE15E3For emergencies8