2015 MITSUBISHI L200 sensor

Exterior - front (Club cab)E001005068521. Outside rear-view mirrors p. 6-10
2. Side turn-signal lamps* p. 5-36, 10-25, 10-30
3. Fuel tank filler door p. 2-02
4. Locking and unlocking p. 3-02 Keyless entry system* p. 3-04
5. Side turn-signal lamps* p. 5-36, 10-25, 10-30
6. Front turn-signal lamps p. 5-36, 10-25, 10-30
7. Headlamps p. 5-32, 10-25, 10-27 Position lamps p. 5-32, 10-25, 10-29
8. Front fog lamps* p. 5-37, 10-25, 10-30
9. Headlamp washers* p. 5-42
10. Bonnet p. 10-03 Engine compartment p. 11-22
11. Wiper and washers p. 5-38
12. Rain sensor* p. 5-39
13. Antenna p. 7-83
Exterior - front (Club cab)
1-18OKTE15E3Overview1

Exterior - front (Double cab)E001005068651. Antenna* p. 7-832. Sunroof* p. 3-14
3. Antenna* p. 7-83
4. Outside rear-view mirrors p. 6-10
5. Side turn-signal lamps* p. 5-36, 10-25, 10-30
6. Fuel tank filler door p. 2-02
7. Locking and unlocking p. 3-02 Keyless entry system* p. 3-04
8. Side turn-signal lamps* p. 5-36, 10-25, 10-30
9. Front turn-signal lamps p. 5-36, 10-25, 10-30
10. Headlamps p. 5-32, 10-25, 10-27 Position lamps p. 5-32, 10-25, 10-29
11. Front fog lamps* p. 5-37, 10-25, 10-30
12. Headlamp washers* p. 5-42
13. Bonnet p. 10-03 Engine compartment p. 11-22
14. Wiper and washers p. 5-38
15. Rain sensor* p. 5-39
Exterior - front (Double cab)
1-20OKTE15E3Overview1

WARNINGlIn order to reduce the risk of serious or
fatal injury in an accident, always wearyour own seat belt. Do not allow anyone
to ride in your vehicle unless he or she is also seated and wearing a seat belt. Chil-
dren should additionally be restrained in a secure child restraint system.NOTEl When luggage is placed on the front passen-
ger seat, a sensor in the seat cushion may,
depending on the weight and position of the
luggage, cause the warning tone to sound and the warning lamp to come on (Double
cab).Adjustable seat belt anchor
(front seats)*
E00405000299
The seat belt anchor height can be adjusted.
Move the seat belt anchor down with the lock knob (A) depressed. To move the anchor up,
slide it without depressing the lock knob (A).WARNINGl When adjusting the seat belt anchor, set it
at a position that is sufficiently high so
that the belt will make full contact with your shoulder but will not touch your
neck.Lap belts*
E00405100128
The lap belts should be adjusted by holding
the belt and latch plate at right angles to each
other, and then pulling the belt as shown in
the illustration to a snug fit around the occu- pant.
1- Tighten
2- Loosen

While holding the latch plate, insert the latch
plate into the buckle until a “click” is heard.
Seat belts
4-12OKTE15E3Seat and seat belts4 Anchor down Anchor up

Pregnant women restraintE00405600064WARNINGlSeat belts work for everyone, including
pregnant women. Pregnant women should
use the available seat belts. This will re- duce the likelihood of injury to both thewoman and the unborn child. The lap belt
should be worn across the thighs and as snug against the hips as possible, but not
across the waist. Consult your doctor if you have any additional questions or con-
cerns.Seat belt pretensioner
system and force limiter
system* E00405700283
The driver’s and front passenger’s seat equip-ped with an airbag has a pretensioner seat belt.
Pretensioner system
E00405801089
The pretensioner system will retract their re-
spective seat belts instantaneously, thus max-imizing the seat belt’s effectiveness, if there
is a frontal impact severe enough to injure the
driver and/or front passenger and the ignition
switch is in the “ON” or “START” position.
The seat belt pretensioner includes the fol-
lowing components:
1- Front impact sensors
2- Seat belt pretensioners
3- Airbag control unit
WARNINGl To obtain the best results from your pre-
tensioner seat belt, make sure you have
adjusted your seat correctly and wear your seat belt properly.CAUTIONl Installation of audio equipment or repairs in
the vicinity of the pretensioner seat belts or
floor console must be performed in line with MITSUBISHI MOTORS guidelines. It is
important to do so because the work could affect the pretensioner systems.CAUTIONl If you need to scrap the vehicle, please con-
sult a MITSUBISHI MOTORS Authorized
Service Point. It is important to do so be- cause unexpected activation of the preten-
sioner seat belts could cause injuries.NOTEl The pretensioner seat belts will be activated
if the vehicle suffers a severe frontal impact, even if the seat belts are not worn.
l The pretensioner seat belts are designed to
work only once. After the pretensioner seat
belts have been activated, we recommend you have them replaced by a MITSUBISHI
MOTORS Authorized Service Point.SRS warning lamp
E00405900126
This warning lamp is shared by the SRS air-
bags and the pretensioner seat belts.
Refer to “SRS warning lamp” on page 4-40.
Force limiter system
E00406000078
In the event of a collision, each force limiter system will effectively absorb the load ap- plied to the seat belt so as to minimize the
impact to the passenger.
Pregnant women restraint
4-13OKTE15E3Seat and seat belts4

WARNINGlOlder children should be seated, properly
wearing the seat belt, with an appropriatebooster seat if needed.Caution for installing the child
restraint on vehicles with a front passenger airbag
E00408800588
The label shown here is attached on vehicles with a front passenger airbag.
WARNINGl Extreme Hazard!
Do not use a rearward facing child re- straint on a seat protected by an airbag in
front of it!How the Supplemental Re-
straint System works
E00407301352
The SRS includes the following components:
1- Airbag module (Driver)
2- Front passenger’s airbag OFF indication
lamp
3- Airbag module (Passenger)
4- Front impact sensors
5- Airbag control unit
6- Front passenger’s airbag ON-OFF
switch

7- Side airbag modules
8- Side impact sensors
9- Curtain airbag modules
The airbags will operate only when the igni- tion switch is in the “ON” or “START” posi-
tion.
When the airbag control unit detect an impact of sufficient frontal or side force, it sends an
ignition signal to the airbag modules to ignite
materials in the inflator and generate gas and
inflate the airbags.
The airbags deployment produces a sudden, loud noise, and releases some smoke andpowder, but these conditions are not injuri-
ous, and do not indicate a fire in the vehicle. People with respiratory problems may feel
some temporary irritation from chemicals
used to produce the deployment; open the
windows after airbag deployment, if safe to do so.
Supplemental restraint system (SRS) - airbag*
4-30OKTE15E3Seat and seat belts4

The airbags deflate very rapidly after deploy-
ment, so there is little danger of obscured vi- sion.
The time required from the sensors detecting an impact to deflation of the airbags after de-
ployment is shorter than a blink of an eye.CAUTIONl Airbags inflate at an extremely rapid speed.
In certain situations, contact with inflatingairbags can result in abrasions, light cuts,
bruises, and the like.Front passenger’s airbag ON-
OFF switch
E00410100331
The front passenger’s airbag ON-OFF switch
can be used to disable the front passenger’s airbag. If you have a rearward facing child
restraint system that cannot be fitted to any seat other than the front passenger seat, be
sure to turn OFF the front passenger’s airbag ON-OFF switch before using it. (Refer to
“To turn an airbag off” on page 4-31.)
The front passenger’s airbag ON-OFF switch
is located in the glove box.WARNINGl To reduce risk of serious or fatal injury:
• Always remove the key from the igni-
tion switch before operating a front
passenger’s airbag ON-OFF switch. Failure to do so could adversely affect
the airbag performance.
• Wait at least 60 seconds to operate the
front passenger’s airbag ON-OFF switch after turning the ignition switch
from “ON” position to “LOCK” posi- tion.
The SRS airbag system is designed to retain enough voltage to deploy the air-
bag.WARNING• Always remove the key from the front
passenger’s airbag ON-OFF switch af-
ter operating that switch. Failure to do so could lead to improper position ofthe front passenger’s airbag ON-OFF
switch.To turn an airbag off
E00410600440
To turn an airbag off, follow these steps:
1. Insert the key into the key opening of the
appropriate front passenger’s airbag ON-
OFF switch, and turn that airbag ON-
OFF switch to the “OFF” position.
2. Remove the key from the key opening of
the front passenger’s airbag ON-OFFswitch.
3. Insert the key into the ignition switch,
and turn the ignition to the “ON” posi-
tion.
Supplemental restraint system (SRS) - airbag*
4-31OKTE15E3Seat and seat belts4

Type 1
Rotate the switch to turn on the lamps.
OFFAll lamps offPosition, tail, licence plate and instru-
ment panel lamps onHeadlamps and other lamps go onType 2
Rotate the switch to turn on the lamps.
OFFAll lamps off
AUTO
With the ignition switch in the
“ON” position, headlamps, posi-
tion, tail, licence plate, and instru-
ment panel lamps turn on and off
automatically in accordance with
outside light level. All lamps turn
off automatically when the igni-
tion switch is turned to the “OFF”
position.Position, tail, licence plate and in-
strument panel lamps onHeadlamps and other lamps go onNOTEl The sensitivity of the automatic on/off con-
trol can be adjusted.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
l When the headlamps are turned off by the
automatic on/off control with the ignition
switch in the “ON” position, the front fog lamps (if so equipped) and rear fog lamp al-
so go off. When the headlamps are subse- quently turned back on by the automatic
on/off control, the front fog lamps also come on but the rear fog lamp stays off. If you wish to turn the rear fog lamp back on, oper-
ate the switch again.
l Do not cover the sensor (A) for the automat-
ic on/off control by affixing a sticker or label
to the windscreen.
Combination headlamps and dipper switch
5-33OKTE15E3Instruments and controls5

NOTElThe front fog lamps are automatically turned
off when the headlamps or tail lamps are turned off. To turn the front fog lamps on again, turn the knob in the “ON” directionafter turning on the headlamps or tail lamps.
l Do not use fog lamps except in conditions of
fog, otherwise excessive lamp glare maytemporarily blind oncoming vehicle drivers.
l In case of vehicles with Daytime Running
Lamp, the front fog lamp can be operated even if the lamp switch is set to the “OFF”
position, because the low beam of the head- lamps, tail lamps, etc. illuminate when the
ignition key is at the “ON” position.Rear fog lamp switch
E00506900313
The rear fog lamp illuminates only when theheadlamps or front fog lamps (if so equipped)
are on.
An indication lamp in the instrument cluster
comes on when the rear fog lamp is turned on.

[Vehicles without front fog lamps]
Turn the knob once in the “ON” direction to
turn on the rear fog lamp. To turn the rear fog
lamp off, turn the knob once in the “OFF” di- rection. The knob will automatically return to
its original position when you release it.

[Vehicles with front fog lamps]
Turn the knob once in the “ON” direction to turn on the front fog lamps. Turn the knob
once more in the “ON” direction to turn on the rear fog lamp. To turn the rear fog lamp
off, turn the knob once in the “OFF” direc- tion. Turn the knob once more in the “OFF” direction to turn off the front fog lamps. The
knob will automatically return to its original
position when you release it.NOTEl The rear fog lamp is automatically turned off
when the headlamps and front fog lamps (if
so equipped) turned off.
l To turn the rear fog lamp on again, turn the
knob once in the “ON” direction after turn-ing on the headlamps. (Vehicles without
front fog lamps)NOTEl To turn the rear fog lamp on again, turn the
knob twice in the “ON” direction after turn-ing on the headlamps. (Vehicles with front
fog lamps)
l In case of vehicles with Daytime Running
Lamp, the rear fog lamp can be operated
even if the lamp switch is set to the “OFF”
position, because the low beam of the head- lamps, tail lamps, etc. illuminate when the ignition key is at the “ON” position.Wiper and washer switch
E00507101191CAUTIONlIf the washer is used in cold weather, the
washer fluid sprayed against the glass may
freeze, which may hinder visibility. Warm the glass with the defroster or rear window
demister before using the washer.Windscreen wipers
E00516900303
Except for vehicles equipped
with rain sensor
The windscreen wipers can be operated with the ignition switch in the “ON” or “ACC”
position.
Rear fog lamp switch
5-38OKTE15E3Instruments and controls5