RSS-210 standard. Operation is subject to
the following two conditions:
1. These devices may not cause interfer-
ence, and
2. These devices must accept any interfer-
ence, including interference that may
cause undesired operation of the device. Information on copyright
Registered trademarks
Bluetooth
®
technology is the standard for
short-range wireless data transmission of up
to approximately 10 meters.
Bluetooth ®
is a registered trademark of Blue-
tooth Special Interest Group (SIG) Inc. An SD memory card is a digital storage
medium.
SD memory cards carry the logo displayed
above. This logo is a registered trademark of
SanDisk Corporation. Qualified specialist workshops
Always have all work on or modifications to
electronic components carried out at a quali- fied specialist workshop. This workshop has
the necessary specialist knowledge and tools
to carry out the work required. In particular,
work relevant to safety or on safety-related systems must be carried out at a qualified
specialist workshop.
An authorized Mercedes-Benz Center is a
qualified specialist workshop. Protection against theft
This device is equipped with technical meas-
ures to protect it against theft.
i You can obtain further information from
an authorized Mercedes-Benz Center. Cleaning
To clean, use a slightly damp cloth. The cloth must be soft and lint-free. For stubborn dirt,
you can use a mild cleaning agent. In partic-
ular, do not clean the display with alcohol,
acid or an abrasive cleaning agent. 8
Int
roduction
X
Press the 0064button repeatedly until the
menu bar is selected. X
To switch on: selectMicrophone On
Microphone On.
The The microphone is on
The microphone is on message
appears briefly in the display. The 004Dsym-
bol disappears from the display/selection
window.
X To switch off: selectMicrophone Off
Microphone Off.
The The microphone is off
The microphone is off message
appears briefly in the display and the 004D
symbol appears in the display/selection
window. Accepting/rejecting a waiting call
If you receive an incoming call while already
making a call, the display shows the incoming call. You also hear a tone.
i The
call waiting function is only available
if it is supported and has been activated by
the mobile phone network provider. X
To accept: press the0061button. or
X Press the control knob.
You are connected to the new party. The
previous call is ended.
X To reject: press the0076button.
or X Select Reject Reject in the display.
The waiting call is rejected. Transferring a call
From the hands-free system to the
mobile phone i
If you wish to continue a call in private
mode, you will need to perform the neces-
sary steps on the mobile phone (see the
mobile phone operating instructions).
From the mobile phone to the hands-
free system i
If you wish to continue a call using Audio
15, you will need to perform the necessary
steps on the mobile phone (see the mobile phone operating instructions). Setting the reception and transmis-
sion volume
If a mobile phone is connected, you can opti-
mize the reception and transmission volumes – even during a call. Inquire about the best
possible settings at an authorized Sprinter
Dealer.
i If reception and transmission volumes
have been incorrectly set, call quality may
be impaired.
X Press the 002Bbutton.
X Press the 0064button repeatedly until the
menu bar is selected.
X Select Telephone Telephone .
X Select Adjust Volume
Adjust Volume. Using the telephone
33Telephone Z
