2015 MAZDA MODEL CX-3 belt

2–48
Essential Safety Equipment
SRS Air Bags
O N
Front passenger front air bag, side air bag, and front passenger seat belt pretensioner
operate. Activate the system only when a child-restraint system is not installed on the front
passenger seat.
Switching to ON position
1. Insert the key into the front passenger air bag deactivation switch and turn the key
anticlockwise until the key points to ON.
2. Remove the key.
3. Make sure the air bag deactivation indicator light remains illuminated when the ignition
is switched ON. The air bag deactivation indicator light turns off after a short period of
time.
$9@&;&&%@&EJUJPOJOEC







*Some models.2–49
Essential Safety Equipment
SRS Air Bags
Supplementary Restraint System Components
*
*
Some models
Driver/Front passenger infl ators and air bags
Crash sensors, and diagnostic module (SAS unit)
Seat belt pretensioners (page 2-17 )
Front air bag sensor
Side crash sensors *
Air bag/seat belt pretensioner system warning light (page 4-36 )
Side and curtain infl ators and air bags *
Front passenger air bag deactivation indicator light * (page 2-45 )
Front passenger air bag deactivation switch * (page 2-45 )
Driver seat slide position sensor * (page 2-51 )
$9@&;&&%@&EJUJPOJOEC







*Some models.2–50
Essential Safety Equipment
SRS Air Bags
How the SRS Air Bags Work
Your Mazda is equipped with the following types of SRS air bags. SRS air bags are
designed to work together with the seat belts to help to reduce injuries during an accident.
The SRS air bags are designed to provide further protection for passengers in addition to the
seat belt functions. Be sure to wear seat belts properly.
Seat Belt Pretensioners
The pretensioners operate differently depending on what types of air bags are equipped. For
details on the seat belt pretensioner operation, refer to the SRS Air Bag Deployment Criteria
(page 2-54 ).
Front
The front seat belt pretensioners are designed to deploy in moderate or severe frontal, near
frontal collisions. In addition, during a side collision, the pretensioner operates on the side in
which the collision occurs.
Rear Outboard
*
The rear outboard seat belt pretensioners are designed to deploy in moderate or severe
frontal, near frontal collisions.
$9@&;&&%@&EJUJPOJOEC







*Some models.2–54
Essential Safety Equipment
SRS Air Bags
SRS Air Bag Deployment Criteria
This chart indicates the applicable SRS equipment that will deploy depending on the type of
collision.
(The illustrations are the representative cases of collisions.)
SRS
equipment Types of collision
A severe frontal/near frontal collision A severe side collision
*2 A rear collision
Front
seat belt
pretensioner X *1 (both sides) X *1 (impact side only)
No air bag and seat belt
pretensioner will be
activated in a rear collision.
Rear
seat belt
pretensioner
* X (both sides)
Driver air
bag X
Front
passenger
air bag X
*1
Side air bag * X *1 (impact side only)
Curtain air
bag
* X (impact side only)
X : The SRS air bag equipment is designed to deploy in a collision.
*1 (With Front Passenger Air Bag Deactivation Switch)
The front passenger front and side air bags and the front seat belt pretensioner are designed to deploy depending
on the status of the front passenger air bag deactivation switch.
*2 (With Side/Curtain Air Bags)
In a side collision, the front seat belt pretensioners and the side/curtain air bags deploy (only on the side in
which the collision occurs).
$9@&;&&%@&EJUJPOJOEC







4–6
When Driving
Start/Stop Engine
NOTE
  After starting a cold engine, the
engine speed increases and a whining
sound from the engine compartment
can be heard.
 This is for improved exhaust gas
purifi cation and does not indicate
defect of the parts.
1. Make sure you are carrying the key.
2. Occupants should fasten their seat
belts.
3. Make sure the parking brake is on.
4. Continue to press the brake pedal
fi rmly until the engine has completely
started.
5. (Manual transaxle)
Continue to press the clutch pedal
fi rmly until the engine has completely
started.
(Automatic transaxle)
Put the vehicle in park (P). If you must
restart the engine while the vehicle is
moving, shift into neutral (N).
NOTE
(Manual transaxle)
The starter will not operate if the clutch
pedal is not depressed suffi ciently.
(Automatic transaxle)
The starter will not operate if the
selector lever is not in P or N and the
brake pedal is not depressed suffi ciently. 6. Verify that the KEY indicator light
(green) in the instrument cluster and the
push button start indicator light (green)
illuminate.
Indicator light
Push button start
NOTE
  If the push button start indicator light
(green) fl ashes, make sure that the
key is being carried.
  If the push button start indicator light
(green) fl ashes with the key being
carried, touch the key to the push
button start and start the engine.
Refer to Engine Start Function When
Key Battery is Dead on page 4-9 .
$9@&;&&%@&EJUJPOJOEC







4–9
When Driving
Start/Stop Engine
NOTE
 (Germany) Drive immediately after starting the
engine. However do not use high
engine speeds until reaching the
operating temperature.
 
(SKYACTIV-G 2.0)




 Whether the engine is cold or
warm, it should be started without
the use of the accelerator.
 


 If the engine does not start the fi rst
time, refer to Starting a Flooded
Engine under Emergency Starting.
If the engine still does not start,
have your vehicle inspected by an
Authorised Mazda Repairer (page
7-27 ).
 
(SKYACTIV-D 1.5) If the ambient temperature is lower
than about - 10 °C (14 °F), the
maximum engine speed may not
be attained for about three minutes
after the engine starts to protect the
engine.
 (Manual transaxle vehicle with
i-stop function)
 If the engine has stopped due to
stalling, it can be restarted by
depressing the clutch pedal within 3
seconds of the engine stopping.
 The engine cannot be restarted even
if the clutch pedal is depressed under
the following conditions:
 


 The driver's door is open.



 The driver's seat belt is unfastened.



 The clutch pedal is not released
completely after the engine stalled.
 


 The clutch pedal is depressed with
the engine not stopped completely.
Engine Start Function When Key
Battery is Dead
CAUTION
When starting the engine by holding
the transmitter over the push button
start due to a dead key battery or a
malfunctioning key, be careful not
to allow the following, otherwise the
signal from the key will not be received
correctly and the engine may not start.
 
 Metal parts of other keys or metal
objects touch the key.

  Spare keys or keys for other vehicles
equipped with an immobilizer system
touch or come near the key.

  Devices for electronic purchases, or
security passage touch or come near
the key.
$9@&;&&%@&EJUJPOJOEC







4–14
When Driving
Start/Stop Engine
Automatic transaxle
1. Engine idling stops when the brake pedal is depressed while the vehicle is driven (except
for driving in the R or M position second gear fi xed mode) and the vehicle is stopped.
2. The engine restarts automatically when the brake pedal is released with the selector lever
in the D or M position (not in second gear fi xed mode).
3. If the selector lever is in the N or P position, the engine does not restart when the brake
pedal is released. The engine restarts when the brake pedal is depressed again or the
selector lever is shifted to the D, M (not in second gear fi xed mode) or the R position.
(For the purposes of safety, always keep the brake pedal depressed when shifting the
selector lever while engine idling is stopped.)
Operation conditions
When the system is operable
Under the following conditions, engine idling stops and the i-stop indicator light (green)
turns on.
 


(SKYACTIV-G 2.0)
 The engine is warmed up.



(SKYACTIV-D 1.5)



 
 The engine is not cold.


 
 The fuel injection amount learning, which is performed periodically and automatically,
is not being performed.
 


 The engine has been started and the vehicle is driven for a certain period.



 The engine is started with the bonnet closed.



 The battery is in good condition.



 All doors, liftgate, and bonnet are closed.



 The driver's seat belt is fastened.



 The air conditioner is not operating with the airfl ow mode dial in the position (A/C
ON).
 


(Automatic air-conditioning)



 
 The temperature setting dial for the air conditioning is set to a position other than
maximum cooling (A/C ON).
 

 
 The vehicle's interior temperature and the set temperature for the air conditioner are
nearly the same.
 


 The i-stop warning light (amber) is not turned on/fl ashing.



 The keyless entry & push button start system functions are normal.



 The brake vacuum is suffi ciently high.



 The steering wheel is not being operated.
$9@&;&&%@&EJUJPOJOEC







4–16
When Driving
Start/Stop Engine
NOTE
Under the following conditions, a period of time is required to stop engine idling
 
 The battery power is depleted for some reasons such as the vehicle has not been driven
for a long period.
  The ambient temperature is high or low. 
 After the battery terminals are disconnected for some reasons such as for battery
replacement.
 (SKYACTIV-D 1.5) After PM removal is performed by the diesel particulate fi lter (DPF).
Engine does not restart
If the following operations are performed while the idling is stopped, the engine will not
restart for safety reasons. In such cases, start the engine using the normal method.
 
 The bonnet is opened. 
(European model) The driver's seat belt is unfastened and the driver's door is opened. 
(Except European model)




(Manual transaxle)
 With the shift lever in a position other than neutral, the driver's seat belt is
unfastened and the driver's door is opened.
 


(Automatic transaxle)
 With the selector lever in the D or M (not in second gear fi xed mode), the driver's
seat belt is unfastened and the driver's door is opened.
Engine-stop period is short or time until next engine idle stop is long
 
 The ambient temperature is high or low. 
 The battery power is depleted. 
 Power consumption by the vehicle's electrical parts is high.
Engine restarts automatically while engine idling is stopped
Under the following conditions, the engine restarts automatically.
 
 The i-stop OFF switch is pressed until the beep sounds.

 The air-conditioner is operated with the airfl ow mode dial in the position (A/C
ON).
 (Automatic air-conditioning)




 The temperature setting dial of the air-conditioner is set to maximum cooling (A/C
ON).
 


 The cabin temperature is largely different from the set temperature of the air-
conditioner.
$9@&;&&%@&EJUJPOJOEC