2015 LEXUS RX450h jump start

321-1. Hybrid system
■
Regenerative braking
In the following situations, kinetic energy is converted to electric energy and decel-
eration force can be obtained in conjunction with the recharging of the hybrid bat-
tery (traction battery). ●
The accelerator pedal is released. ●
The brake pedal is depressed with the shift lever in D or S.■
Conditions in which the gasoline engine may not stop
The gasoline engine starts and stops automatically. However, it may not stop auto-
matically in the following conditions: ●
During gasoline engine warm-up●
During hybrid battery (traction battery) charging●
When the temperature of the hybrid batt ery (traction battery) is high or low●
When the heater is switched on■
Charging the hybrid battery (traction battery) ●
As the gasoline engine charges the hybrid battery (traction battery), the battery
does not need to be charged from an outside source. However, if the vehicle is
left parked for a long time the hybrid ba ttery will slowly discharge. For this rea-
son, be sure to drive the vehicle at least once every few months for at least 30
minutes. If the hybrid battery becomes fully discharged and you are unable to
jump-start the vehicle with the 12-volt battery, contact your Lexus dealer. ●
If the shift lever is in N, the hybrid battery (traction battery) will not be charged.
Always put the shift lever in P when the vehicle is stopped. When driving in
heavy traffic, operate the vehicle with the shift lever in D or S to avoid discharg-
ing the battery.■
After the 12-volt battery has discharged or has been changed or removed
The gasoline engine may not st op even if the vehicle is running on the hybrid battery
(traction battery). If this continues for a few days, contact your Lexus dealer.

7845-2. Steps to take in an emergency
If the vehicle 12-volt battery is discharged The following procedures may be used to start the hybrid system if the vehi-
cle’s 12-volt battery is discharged.
You can also call your Lexus dealer or a qualified repair shop.
If you have a set of jumper (or booster) cables and a second vehicle
with a 12-volt battery, you can jump start your vehicle by following the
steps below.
Open the hood and remove the engine compartment covers.
(  P. 655)
Remove the fuse box cover and open the exclusive jump start-
ing terminal cover.
Connect the jumper cables according to the following procedure:
Connect a positive jumper cable clam p to the exclusive jump start-
ing terminal on your vehicle
Connect a positive jumper cable cl amp to the positive (+) battery
terminal on the second vehicle
Connect a negative cable clamp to the negative (-) battery terminal
on the second vehicle
Connect the clamp at the other end of the negative cable to a solid,
stationary, unpainted metallic point away from the exclusive jump
starting terminal and any moving part s, as shown in the illustration.STEP 1
STEP 2
STEP 3

5
When trouble arises
7855-2. Steps to take in an emergency
■
Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting.■
To prevent 12-volt battery discharge ●
Turn off the headlights and the audio sy stem while the hybrid system is off.●
Turn off any unnecessary electrical compon ents when the vehicle is running at a
low speed for an extended period, such as in heavy traffic.■
When the 12-volt battery is removed or discharged ●
The power back door must be initialized.
(  P. 8 3 7 )●
The hybrid system may not start. (
 P. 6 6 8 )
●
Make sure that the key is not inside th e vehicle when recharging or replacing
the 12-volt battery. The key may be locked in the vehicle if the alarm is activated.
(  P. 1 2 8 ) Start the engine of the second vehicle. Increase the engine
speed slightly and maintain that level for approximately 5 min-
utes to recharge the 12-volt battery of your vehicle.
Open and close any of the doors of your vehicle with the
“POWER” switch off.
Maintain the engine sp eed of the second ve hicle and start the
hybrid system of your vehicle by turning the “POWER” switch
to ON mode.
Make sure the “READY” indicat or comes on. If the indicator
does not come on, contact your Lexus dealer.
Once the hybrid system has st arted, remove the jumper cables
in the exact reverse order from which they were connected.
Once the hybrid system starts, have the vehicle inspected at your
Lexus dealer as soon as possible. STEP 4
STEP 5
STEP 6
STEP 7
STEP 8

7865-2. Steps to take in an emergency
■
Charging the 12-volt battery
The electricity stored in the 12-volt batter y will discharge gradually even when the
vehicle is not in use, due to natural discharge and the draining effects of certain
electrical appliances. If the vehicle is left for a long time, the 12-volt battery may dis-
charge, and the hybrid system may be un able to start. (The 12-volt battery
recharges automatically while the hybrid system is operating.)
CAUTION■
Avoiding 12-volt battery fires or explosions
Observe the following precautions to prevent accidentally igniting the flammable
gas that may be emitted from the 12-volt battery: ●
Make sure each jumper cable is connecte d to the correct terminal and that it is
not unintentionally in contact with an y other than the intended terminal.●
Do not allow the other end of the jumper cable connected to the “+” terminal to
come into contact with any other parts or metal surfaces in the area, such as
brackets or unpainted metal.●
Do not allow the + and - clamps of the jumper cables to come into contact with
each other.●
Do not smoke, use matches, cigarette lighters or allow open flame near the 12-
volt battery.■
12-volt battery precautions
The 12-volt battery contains poisonous and corrosive acidic electrolyte, while
related parts contain lead and lead compounds. Observe the following precautions
when handling the 12-volt battery: ●
When working with the 12-volt battery, always wear safety glasses and take care
not to allow any battery fluids (acid) to co me into contact with skin, clothing or the
vehicle body.
●
Do not lean over the 12-volt battery.
●
In the event that battery fluid comes into contact with the skin or eyes, immedi-
ately wash the affected area with water and seek medical attention.
Place a wet sponge or cloth over the affected area until medical attention can be
received.

5
When trouble arises
7875-2. Steps to take in an emergency
CAUTION●
Always wash your hands after handling the battery support, terminals, and other
battery-related parts.●
Do not allow children near the 12-volt battery.■
After recharging the 12-volt battery
Have the 12-volt battery inspected at your Lexus dealer as soon as possible.
If the 12-volt battery is deteriorating, co ntinued use may cause the 12-volt battery to
emit a malodorous gas, which may be de trimental to the health of passengers.■
When replacing the 12-volt battery
 P. 6 6 9
NOTICE■
When handling jumper cables
When connecting the jumper cables, ensure that they do not become entangled in
the cooling fans or belt.■
Avoiding accidental short-circuits
When connecting jumper cables, observe the following precautions: ●
Make sure each jumper cable is connected to the correct terminal.●
Do not allow the ends of the jumper cable used for the “+” terminals to come into
contact with any other parts or metal surfaces in the area, such as brackets or
unpainted metal.●
Do not allow the “+” and “-” terminals of the jumper cables to come into contact
with each other.■
Exclusive jump starting terminal precaution
The exclusive jump starting terminal is to be used when charging the 12-volt battery
from another vehicle in an emergency. It cannot be used to jump start another vehi-
cle.