Octane Rating, Gasoline (Fuel)................527
Odometer...............................298
Tr i p . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..298
Off-Pavement Driving (Off-Road)..............457
Off-Road Driving (Off-Pavement)..............457
Oil, Engine..............................305
Capacity.............................669
Change Interval........................607
Dipstick..............................607
Disposal..............................610
Filter................................610
Filter Disposal.........................610
Identification Logo......................608
Materials Added to......................610
Recommendation.......................608
Synthetic.............................609
Viscosity.............................608
Oil Filter, Selection........................610
Onboard Diagnostic System..................603
Opener, Garage Door (HomeLink®)............248
Operating Precautions......................603
Operator Manual (Owner’s Manual).............6
Outside Rearview Mirrors...................130
Overhead Console.........................245
Overheating, Engine.......................295
Owner’s Manual (Operator Manual).............6
Paint Care..............................644
Panic Alarm..............................24
Parking Brake............................469
ParkSense® System, Rear....................223
Passing Light............................177
Passive Entry.............................35
Pets...................................107
Placard, Tire and Loading Information..........501
Power
Brakes...............................472
Distribution Center (Fuses)................65110
INDEX 705
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into
this vehicle’s electronic system to provide immunity
to radio frequency signals. Mobile two-way radios
and telephone equipment must be installed prop-
erly by trained personnel. The following must be
observed during installation.
The positive power connection should be made
directly to the battery and fused as close to the
battery as possible. The negative power connection
should be made to body sheet metal adjacent to the
negative battery connection. This connection
should not be fused.
Antennas for two-way radios should be mounted on
the roof or the rear area of the vehicle. Care should
be used in mounting antennas with magnet bases.
Magnets may affect the accuracy or operation of
the compass on vehicles so equipped.
The antenna cable should be as short as practical
and routed away from the vehicle wiring when pos-
sible. Use only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio
to ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater
than normal may require special precautions.
All installations should be checked for possible in-
terference between the communications equip-
ment and the vehicle’s electronic systems.
