"' N
a: LL co
rl I.O
"' rl
"' rl
General Information
Applies to vehicles: with parking system (rear, with rear
view ca mera)
Fig . 125 Covered area (D and uncove red area @of the
rear view came ra
Fig. 126 Trunk lid : Locatio n of the rear view camera
Sensors in the bumper
Sensors are located in the front and rear
bumpers. If these detect an obstacle, audible
and visual signals warn you. The range at
which the sensors begin to measure is approx
i mately :
side 3
ft (0.90 m)
front center 4
ft (1.20 m)
side 2
ft (0.60 m)
rear center 5 .2 ft (1.60 m)
Distance warning when reversing starts when
an obstacle is detected in the range of the
parking assist system. As the distance de
creases, the time interva l between the audib le
tones becomes shorter.
When the distance is less than 1 ft (0 .30 m),
the tone becomes continuous. At this point
you should stop backing up.
If the d istance to an obstacle stays the same,
the volume of the distance signal chime is
gradually reduced after about 4 seconds (does
Park assist 107
not affect the continuous signal tone). Ap
proaching another obstacle will cause the dis
tance signal to sound again at the norma l vo l
ume .
Rear view camera coverage area
The MMI display shows the area covered by
the rear view camera
c:> fig. 125 (!). Objects
that are not in the area covered @are not
shown on the MMI display .
We recommend that you practice parking with
the rear view camera in a traffic-free location
or parking lot to become familiar with the sys
tem, the orientation lines, and their function.
When doing this, there should be good light
and weather cond itions.
In the MMI display, objects or vehicles appear
closer or further away if:
-you are driving in reverse gear from a leve l
surface onto an incline, or a downward
slope,
-you are driving in reverse gear toward pro
trud ing ob jects,
- the vehicle is car ry in g too much load in the
rear.
The accuracy of the orientation lines and blue
surfaces diminishes if:
- the rear view camera does not provide a reli
able image, for example, in poor visibility
conditions or if the lens is dirty,
- the image on the screen is not vis ible due to
sun glare and reflection.
Caring for the rear view camera lens
The rear view camera is located above the rear
license plate bracket. For the parking assist to
operate, the lens
c:> fig . 126 must be kept
clean:
- Dampen the lens with a household alcohol
based glass cleaner, and clean the lens with
a dry cloth
c:> (D.
- Remove snow with a hand brush and ice
preferably with a de-ic ing spray
c:> (D.
"' N
a: LL co
rl I.O
"' rl
"' rl
Reverse Parking
Applies to vehicles: with parking system plus wit h rea r
view ca mera
Parking mode 1 can be used when parking in
a garage or parking space.
Fig. 127 MMI Display: Aiming at a parking spot
Fig . 128 MMI Display : A ligning the vehicle
• Sw itch the MMI on and se lect the reverse
gear.
• Turn the steering wheel until the orange ori
entation lines
(D appear in the parking spot
c> fig. 12 7. Use the markings @to help you
estimate the distance from an obstacle .
Each marking corresponds to 3
ft (1 m) . The
blue area represents an extension of the ve
hicle 's outline by approximately 16
ft (5 m)
to the rear.
• While driving in reverse gear, adj ust the
steer ing wheel angle to fit the parking space
with the aid
of the orange orientation lines
¢ (D. @ marks the rear bumper. You should
stop driving in reverse as soon as and no lat
er than when the red orientation line@
abuts a n object ¢_&. !
A WARNING
- The rear view came ra does no t show the
entire area beh ind the veh icle
Par k ass ist 109
r::!) page 107, fig . 125. Watch out espe
cially for small children and animals. The rear view camera cannot always detect
them, posing risk of an accident!
- Please note that objects not touching the
ground can appear to be further away
than they really are (for example, the bumper of a parked vehicle, a trailer
hitch, o r the rear of a truck). In this case,
you shou ld not use the help lines to help
with parking, wh ich poses danger of an
accident!
(D Note
- Low obstacles a lready s ignaled by a
warning can disappear from the system's detect ion range as they are app roached
and wi ll not continue to be signaled. Ob
jects such as barrier chains, trai ler draw
bars, thin painted vert ica l poles or fen
ces may not be detected by the system,
posing risk of damage.
- In the MMI display, the direction of trav
el of the vehicle rear is represented de
pending on the steering wheel angle.
The vehicle front swings out more than
the vehicle rear . Maintain plenty of d is
tance from an obstacle so that your out
side mi rror or a corner of you r vehicle
does not co llide w ith any obsta cles -dan
ger of accident !
110 Park assist
Parallel Parking
Applies to vehicles: with par king system p lus w it h rear
view ca mera
Use parking mode 2 to help you park on the
edge of a street.
F ig. 129 MMI Display: blue s urface in the parking spot
Fig. 130 MMI Disp lay: Blue curve on the curb
The following steps apply only when there is
no obstacle (such as a wall) near the parking
spot. Otherwise, please read the "Tips on Parking Next to Obstacles"¢
page 110.
.. Activate the turn signal.
.. Position your vehicle parallel to the edge of
the street, approximately 3 ft (1 m) from a parked vehicle .
.. Switch the MMI on and select the reverse
gear. The parking aid turns on and parking
mode 1 appears on the display.
"Press the
Mode¢ fig. 129 © control button
on the MMI control console. Parking mode 2
appears .
.. Back up in reverse gear and align your vehi
cle so that the blue area
@ borders on the
rear end of the vehicle or on the parking
spot line. The blue area represents an exten
sion of the vehicle's outline by approximate ly 16 ft (S m) to the rear. The long s ide of the blue
area shou ld be on the curb. The en
tire blue area must fit into the parking spot.
.. While the vehicle is stationary, turn the
steering wheel to the rig ht as far as it will
go.
" Back into the parking spot. Stop the vehicle
as soon as the blue curve is nea r the curb
q fig . 130 ¢0.
"Whil e the vehicle is stationary, turn the
steering wheel to the left as far as it will go .
.. Continue to back up into the parking spot
until the vehicle is parked parallel to the
curb .@ marks the rear bumper. You should
stop driving in reverse as soon as and no lat
er than when the red orientation line@
abuts an object¢_&. ! Keep an eye on the
front of your vehicle while do ing th is ¢ 6) .
Parking next to obstacles
When there is an obstacle (such as a wa ll)
next to the parking spot, choose a spot with
more space on the sides. Posit ion the long
s ide of the blue area so that there is suff ic ient
space from the curb . The area must not be on
the curb . You will a lso need to start turning
the steer ing wheel much earlier. There should
be a sufficient amount of space between the
curb and the blue curve, and the blue curve
¢
fig. 130 must not touch the curb.
A WARNING
- The rear view camera does not show the
entire area behind the vehicle
¢
page 10 7, fig. 12 5. Watch out espe
cially for small children and anima ls. The
rear view camera cannot always detect
them, posing risk of an acc ident!
- Please note that objects not touching the
ground can appear to be further away
than they really are (for example, the
bumper of a parked vehicle, a trailer
hitch, or the rear of a truck). In this case,
you should not use the help lines to help
with parking, which poses danger of an
accident!
.__ _____________ _J ...