2014 PORSCHE 911 TURBO Button

58 Air Conditioning
A- Set temperature left/right B - Set air quantity
Setting temperature
For personal comfort, the interior temperature can be adjusted individually for the driver’s and passenger’s side between 61 °F (16 °C) and 85 °F (29.5 °C). Recommendation: 72 °F (22 °C).
The selected temperature is shown on the display.
Increasing temperature
fPress button TEMP upwards. The preset temperature value is shown on the air-conditioning display.
Information
Pressing button AUTO/SYNC selects the preset temperature.
Information
The air-conditioning system always cools and heats the passenger compartment to the preset temperature at maximum cooling or heating temperature.Setting the temperature temporarily to a lower or higher value does not cool or heat the passenger compartment to the desired temperature more quickly.
Set air quantity
The selected air quantity is shown in a bar display above the button . The more bars that are displayed, the more air flows into the passenger compartment.
Increasing air quantity
fPress button upwards.
Reducing air quantity
fPress button downwards.
Pressing button AUTO/SYNC switches back to automatic mode.
If the air quantity was reduced so much that OFF appears on the air-conditioning display, the outside-air supply is interrupted and the air-conditioning compressor is switched off.
The windows can mist up if the air quantity setting is OFF.fOnly select air quantity setting OFF for short periods.fPress button upwards (increase air quantity).
Setting air distribution manually
fPress button . The air flows to the windshield and the side windows.fPress button .The air flows from the central and side vents. The air vents must be open.fPress button .The air flows to the footwell.
The indicator light on the button lights up.
Cancelling manual air distribution
fPress the relevant air distribution button again. The indicator light on the button goes out.orPress button AUTO/SYNC. Air quantity and distribution are controlled automatically and variations are compensated.
Air Shut-off Impairing VisionWARNINGh
14_991_Turbo_21.book Seite 58 Mittwoch, 9. April 2014 2:19 14

60 Air Conditioning
Heated Rear Window/
Exterior Mirror Heating
Heated rear window/exterior mirror heating is ready for operation when the engine is running.
Switching on
fPress button .The indicator light on the button lights up.
Depending on the outside temperature, the heating switches off automatically after approx. 5 to 20 minutes.fThe heating can be switched back on by pressing the button again.
Switching off
fPress button .The indicator light on the button goes out.
If the charging condition of the battery is critical, the heated rear window/exterior mirror heating function is restricted initially and then switched off.
14_991_Turbo_21.book Seite 60 Mittwoch, 9. April 2014 2:19 14

Windows, Sunroof and Cabriolet 63
If one-touch operation is disabled after the window is blocked, the window will close with its full closing force when the manual closing function is used.fEnsure that nobody can be injured, pinched or crushed when the windows close.
Storing end position of the windows after connecting the vehicle battery
The end positions of the windows are lost when the battery is disconnected and reconnected. One-touch operation of the windows is disabled.
Perform these steps for all windows: 1. Close window completely once by pulling the rocker switch.2. If the window is completely closed, briefly pull the rocker switch again 3 times. 3. Open the window completely once by pressing the rocker switch.
Sunroof
The electric sunroof and the roll-up sunblind can be operated using the buttons in the center console.
When opening or closing the roof or sunblind, particularly when using one-touch operation, parts of the body may become trapped between moving and fixed vehicle parts.fEnsure that nobody is injured when operating the roof or roll-up sunblind.fAlways remove the ignition key when leaving the vehicle or switch ignition off on vehicles with Porsche Entry & Drive. Always take the ignition key with you when leaving the vehicle. Uninformed persons (e.g. children) could injure themselves when operating the sunroof or roll-up sunblind.fIn case of danger, press the sliding roof or sunblind button immediately.
Damage to the roof, if the roof is opened or lifted when a roof transport system is fitted and the roof collides with the carrier/load.fDo not open or lift the roof when a roof transport system is fitted.
Operational readiness of the sunroof and roll-up sunblind
The sunroof and roll-up sunblind are ready for operation:
– With ignition switched on.
Information
The roof and sunblind have a force limiter. If the roof or sunblind are obstructed during the closing operation, they will open again immediately.
At speeds above 120 mph (200 km/h) and at temperatures below --22 °F (–30 °C), the roof can only be closed. The opening function is disabled.
Closing the windows manuallyWARNINGh
Opening and closing the sunroof and roll-up sunblind
WARNINGh
NOTICE
14_991_Turbo_21.book Seite 63 Mittwoch, 9. April 2014 2:19 14

64 Windows, Sunroof and Cabriolet
A- Open roof B - Lift/lower roof C - Close roof
Steel Sunroof
Opening the roof
First setting – manual operation
fPull and hold button A in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly pull button A to the second setting. The roof opens automatically to the end position.
The process can be interrupted by pulling button A or C again.
Lifting/lowering the roof
fPress button B. The roof is lifted/lowered to the end position.
The process can be interrupted by pressing button B again.
Closing the roof
First setting – manual operationfPull and hold button C in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly pull button C to the second setting. The roof closes automatically.
The process can be interrupted by pulling button C or A again.
A- Open/close sunblind B - Lift/lower roof C - Open/close roof
Glas Sunroof
Opening the roof
First setting – manual operation
fPress and hold button C in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly press button C to the second setting. The roof opens automatically to the end position.
The process can be interrupted by pressing button C again.
Lifting/lowering the roof
fPress button B. The roof is lifted/lowered to the end position.
The process can be interrupted by pressing button B again.
14_991_Turbo_21.book Seite 64 Mittwoch, 9. April 2014 2:19 14

Windows, Sunroof and Cabriolet 65
Closing the roof
First setting – manual operationfPull and hold button C in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly pull button C to the second setting. The roof closes automatically.
The process can be interrupted by pulling button C again.
Opening the roll-up sunblind
First setting – manual operationfPull and hold button A in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly pull button A to the second setting. The sunblind opens automatically to the end position.
The process can be interrupted by pressing button A again.
Closing the roll-up sunblind
First setting – manual operationfPress and hold button A in the first setting until the desired position is reached.
Second setting – one-touch operationfBriefly press button A to the second setting. The sunblind closes automatically to the end position.
The process can be interrupted by pressing button A again.
Information
If the sunroof is partly or fully open, the sunblind can only be closed as far as the front edge of the sunroof.
If the sunblind is closed, it will be opened (pulled along) automatically when the sunroof is opened.
Warning message on multi-function display
If there is a fault in the sunroof the warning “ Close sunroof completely” appears on the multi- function display.fClose sunroof with button C. Have the fault corrected by an authorized Porsche dealer at the next opportunity.
Emergency closing of sunroof
Emergency closing after repeated intervention from the force limiter
If the closing operation of the roof is impeded by an obstruction, it can be closed manually with increased force.
To perform emergency closing: 1. Remove the obstruction. 2. Pull and hold button C in the first setting until the roof closes and stops in the closed position.Repeat closing operation if necessary
Emergency operation if roof drive mechanism fails
If the roof drive mechanism is defective, it can be closed manually using the hexagon key from the tool kit.fBefore using emergency operation, check that the fuse is intact.
For information on changing fuses:fPlease see the chapter “CHANGING FUSES” on page 267.
14_991_Turbo_21.book Seite 65 Mittwoch, 9. April 2014 2:19 14

66 Windows, Sunroof and Cabriolet
1.Carefully lever off the cap from the roof liner using a screwdriver, for example.2. Take the hexagon key out of the tool kit in the luggage compartment.
For information on the tool kit:fPlease see the chapter “TOOLS” on page 198.
3. Insert the hexagon key all the way into the opening.4. Applying continuous upward pressure, turn the key clockwise until the roof is fully closed.5. Remove the key. 6. Refit the cap. 7. Stow the key in the tool kit.fHave the fault corrected at an authorized Porsche dealer.
Storing end position of the sunroof
The end positions of the roof are lost after disconnection/connection of the vehicle battery, if the vehicle battery is exhausted or after jump lead starting, after emergency operation or after changing the fuse for the roof.
The roof closes with its full closing force when storing the end position.fEnsure that nobody is injured when closing the roof.
The vehicle must be stationary in order to store the end position of the roof.1. Switch on ignition. 2. Pull and hold button C in the first setting until the roof closes and stops in the closed position.The process for storing the end position begins after approximately 10 seconds. The roof now opens and closes once automatically. Storage is now complete.If this process is not executed, please perform the following procedure:Pull and hold button C in the first setting until the roof closes fully and stops. If necessary, repeat the closing operation until the roof has stopped moving completely.The process takes a maximum of 15 seconds.Start the storing process again if the button is released before the roof has stopped moving completely.
Storing the end positionWARNINGh
14_991_Turbo_21.book Seite 66 Mittwoch, 9. April 2014 2:19 14

Windows, Sunroof and Cabriolet 67
Storing end position of the roll-up sunblind
The end positions of the sunblind are lost after disconnecting/connecting the vehicle battery,
if the vehicle battery is exhausted or after jump lead starting, after emergency operation or after changing the fuse for the sunblind.
The sunblind closes with its full closing force when storing the end position.fEnsure that nobody is injured when closing the sunblind.
To store the end position for the sunblind, the vehicle must be stationary and the end position for the roof must already be stored.1. Switch on ignition. 2. Press and hold button A in the first setting until the sunblind closes and stops in the closed position.The process for storing the end position begins after approximately 10 seconds. The sunblind now opens and closes once automatically. Storage is now complete.If this process is not executed, please perform the following procedure:Press and hold button A in the first setting until the sunblind closes fully and stops. If necessary, repeat the closing operation until the sunblind has stopped moving completely.The process takes a maximum of 15 seconds.Start the storing process again if the button is released before the sunblind has stopped moving completely.
Cleaning the air deflector
Cleaning the air deflector with the roof open.
1. Switch on the ignition and open the roof fully with button B. If the air deflector is not fully extended, drive the vehicle for a short distance with the roof open until it is fully extended.2. Clean the air deflector and net using a damp sponge.
Convertible Top
Brief operating instructions can be found on the back of the driver’s sun visor.fPlease see the chapter “CAR CARE INSTRUCTIONS” on page 231.
Risk of damage to convertible top and convertible- top mechanism.fDo not operate convertible top:– At temperatures below 20 °F (0 °C).– When one side of the vehicle is on a curb, a lifting platform or a jack.– When items of luggage or other objects hinder the movement of the convertible top.– With the roll-over bars extended.fAvoid frequent operation of the convertible top with the engine off; the vehicle battery will rapidly discharge.fOnly drive with the convertible top fully open or closed (end positions).fBefore opening the convertible top, ensure that there are no objects in the area behind the rear seats.fWhen opening or closing the convertible top, ensure that there is sufficient clearance above it (e.g. in the garage).fTo prevent damp stains and abrasion damage, open the convertible top only when it is in a dry, clean state.fPark the vehicle in the shade if possible, since continuous exposure to the sun attacks textiles, rubber and colors.fThe convertible top may only be operated when driving on a level surface.fThe convertible top must not be operated in a strong head wind (above approx. 50 mph (80 km/h)).
Storing the end positionWARNINGh
NOTICE
14_991_Turbo_21.book Seite 67 Mittwoch, 9. April 2014 2:19 14

82 Lights, Turn Signals and Windshield Wipers
Instrument Lighting
The lighting is automatically adjusted to the ambient brightness via light sensors.In addition, when the vehicle lighting is switched on, the instrument and switch brightness can be adjusted manually.fTurn adjustment button A in the appropriate direction and hold until the desired brightness has been reached.
Adjusting the brightness while driving may cause you to lose control of the vehicle.fDo not reach through the steering-wheel spokes when driving.
Turn Signal/High Beam/Headlight
Flasher Stalk/Parking Light Switch
Turn signal, low beam and high beam are ready for operation when the ignition is on.1 – Turn signal light, left2 – Turn signal light, right3 – High beam, High Beam Assistant4 – Headlight flasher (also with the ignition switched off)
Stalk in center position – dipped beam
Turn signal lights
fPush the stalk once to the lower or upper pressure point 1 or 2. The turn signal lights flash three times.
High-beam headlight
Switching on and off (on vehicles WITHOUT High Beam Assistant)
fSwitching on : Push the stalk once to the front pressure point 3. The indicator light lights up on the tachometer.fSwitching off : Push the stalk once to the rear pressure point 4.
Activating/deactivating High Beam Assistant
The following conditions must be met before High Beam Assistant is activated:– Darkness– Light switch position is selected.– Vehicle speed is more than approx. 37 mph (60 km/h).– High Beam Assistant is activated on the multi-function display in the instrument panel.Please see the chapter “ACTIVATING AND DEACTIVATING HIGH BEAM ASSISTANT” on page 120.fActivating : Push the stalk once to the front pressure point 3. The indicator light in the speedometer lights up. The vehicle automatically selects between low beam and high beam.If the high beam is switched on, the indicator light on the tachometer lights up.fDeactivating : Push the stalk once to the rear pressure point 4. The High Beam Assistant can only be deactivated if the indicator light on the tachometer is lit.
Adjusting the brightness while drivingWARNINGh
14_991_Turbo_21.book Seite 82 Mittwoch, 9. April 2014 2:19 14