2014 Peugeot RCZ instrument panel

144
DISPLAYS IN THE INSTRUMENT PANEL
The programmed information is grouped together in the instrument
panel screen.
5. Cruise control off / resume indication.
6. Cruise control mode selection indication.
7. Programmed speed value.
PROGRAMMING
 Turn dial 1 to the "CRUISE" position: the cruise
control mode is selected but is not switched on
(OFF / Pause).
 Set the programmed speed by accelerating to the required speed, then press button 2 or 3
(e.g.: 70 mph (110 km/h)).
You can then change the programmed speed using
buttons 2 and 3 :
- by + or - 1 mph (km/h) = short press,
- by + or - 5 mph (km/h) = long press,
- in steps of + or - 5 mph (km/h) = maintained press.
 Switch off the cruise control by pressing button 4 : the display confi rms that it has been
switched off (OFF / Pause).
 Switch the cruise control back on by pressing button 4 again.

148
Deactivation / Activation of the rear parking sensors
The function is deactivated or activated via the vehicle confi guration
menu.
The status of the function is stored when the ignition is switched off.
OPERATING FAULT
In the event of a malfunction of the system, when reverse gear
is engaged this warning lamp is displayed in the instrument
panel and/or a message appears in the screen, accompanied
by an audible signal (short beep).
Contact a PEUGEOT dealer or a qualifi ed workshop.
In bad weather or in winter, ensure that the sensors are not
covered with mud, ice or snow. When reverse gear is engaged, an
audible signal (long beep) indicates that the sensors may be dirty.
Certain sound sources (motorcycle, lorry, pneumatic drill, etc.)
may trigger the audible signals of the parking sensor system.
The function will be deactivated automatically if a trailer is being
towed or a bicycle carrier is fi tted (vehicle fi tted with a towbar or
bicycle carrier recommended by PEUGEOT).

150
FUEL TANK
Fuel tank capacity: approximately 55 litres.
LOW FUEL LEVEL
FILLING
When the fuel tank minimum level is reached this warning
lamp comes on on the instrument panel, accompanied by an
audible signal and an alert message. When it fi rst comes on
there remains approximately 5 litres of fuel in the tank.
Until suffi cient fuel is added, this warning lamp appears every time
the ignition is switched on, accompanied by an audible signal and a
message. When driving, this audible signal and display of the alert
message are repeated with increasing frequency as the fuel level drops
towards "0" .
Refuel as soon as possible to avoid running out of fuel.
If you run out of fuel (Diesel), refer also to the "Running out of fue\
l
(Diesel)" section.
A label affi xed to the inside of the fl ap reminds you of the type of fuel to
be used depending on your engine.
Additions of fuel must be of at least 5 litres, in order to be registere\
d by
the fuel gauge. To fi ll the tank in complete safety:
 the engine must be switched off,

 press the rear part of the fl ap, then raise it to open it,
 turn the cap to the left,
 remove the cap and hook it onto the clip located on the inside of the fl ap,
 fi ll the tank, but do not continue after the 3rd cut-off of the
pump ; this could cause malfunctions.
Opening the fi ller cap may create a noise a caused by an inrush
of air. This vacuum is entirely normal, resulting from the sealing of
the fuel system.

156
CHECKING LEVELS
ENGINE OIL LEVEL
The check is carried out either when the ignition is switched
on using the oil level indicator in the instrument panel, or using
the dipstick.
Take care when working under the bonnet, as certain areas of the engine m\
ay be extremely hot (risk of burns) and the cooling fan could start
at any time (even with the ignition off).
Check all of these levels regularly, in line with the warranty and maintenance record. Top them up if necessary, unless otherwise indicated.
If a level drops signifi cantly, have the corresponding system checked by a PEUGEOT dealer or a qualifi ed workshop.
To ensure that the reading is correct, your vehicle must be on
level ground and the engine must have been off for more than
30 minutes.
It is normal to top up the oil level between two services (or oil chang\
es).
PEUGEOT recommends that you check the level, and top up if
necessary, every 3 000 miles (5 000 kms).
Checking using the dipstick
Refer to the "Petrol engine" or "Diesel engine" section for the location\
of
the dipstick in the engine compartment of your vehicle.
- Take the dipstick by its coloured grip and remove it completely.
- Wipe the end of the dipstick using a clean non-fl uffy cloth.
- Refi t the dipstick and push fully down, then pull it out again to make the visual check: the correct level is between the marks A and B . A = MAX
B = MIN
If you fi nd that the level is above the A mark or below the B mark, do
not start the engine .
- If the level is above the MAX mark (risk of damage to the engine),
contact a PEUGEOT dealer or a qualifi ed workshop.
- If the level is below the MIN mark, you must top up the engine oil.

7/
CHECKS
BRAKE FLUID LEVEL
The brake fl uid level should be close to the "MAX" mark. If it is
not, check the brake pad wear.
Changing the fluid
Refer to the warranty and maintenance record for details of the interval\

for this operation.
Fluid specification
The brake fl uid must conform to the manufacturer's recommendations.
POWER STEERING FLUID LEVEL
The power steering fl uid level should be close to the "MAX"
mark. With the engine cold, unscrew the cap to check the level.
Topping up the engine oil level
Oil grade
The oil must be the correct grade for your engine and conform to the
manufacturer's recommendations.
Refer to the "Petrol engine" or "Diesel engine" section to identify the \
location of the oil fi ller cap in the engine compartment of your vehicle.
- Unscrew the oil fi ller cap to reveal the fi ller aperture.
- Add oil in small quantities, avoiding any spills on engine components (risk of fi re).
- Wait a few minutes before checking the level again using the dipstick.
- Add more oil if necessary.
- After checking the level, carefully refi t the oil fi ller cap and the dipstick in its tube.
After topping up the oil, the check when switching on the ignition with \
the oil level indicator in the instrument panel is not valid during the \
30 minutes after topping up.
Engine oil change
Refer to the warranty and maintenance record for details of the interval\

for this operation.
In order to maintain the reliability of the engine and emission control \
system, the use of additives in the engine oil is prohibited.

F0
158
DIESEL FUEL ADDITIVE LEVEL (DIESEL WITH
PARTICLE EMISSIONS FILTER)
The additive reservoir low level is indicated by fi xed illumination
of this warning lamp, accompanied by an audible signal and
a message that the particle emissions fi lter additive level is
too low.
Topping up
The reservoir must be topped up without delay by a PEUGEOT dealer
or a qualifi ed workshop.
USED PRODUCTS
Avoid prolonged contact of used oil or fl uids with the skin.
Most of these fl uids are harmful to health or indeed very corrosive.
Do not discard used oil or fl uids into sewers or onto the ground.
Take used oil to a PEUGEOT dealer or a qualifi ed workshop
(France) or to an authorised waste disposal site.
COOLANT LEVEL
The coolant level should be close to the "MAX" mark but
should never exceed it.
When the engine is warm, the temperature of the coolant is regulated
by the fan.
In addition, as the cooling system is pressurised, wait at least one hou\
r
after switching off the engine before carrying out any work.
To avoid any risk of scalding, unscrew the cap by two turns to allow the \
pressure to drop. When the pressure has dropped, remove the cap and
top up the level. The cooling fan may start after switching off the engine: take
care with articles and clothing that might become caught by the
fan blades.
Fluid specification
The coolant must conform to the manufacturer's recommendations.
SCREENWASH AND HEADLAMP WASH FLUID
In the case of vehicles fi tted with headlamp washers, the low
fl uid level is indicated by an audible signal and a message in
the instrument panel screen.
Top up the reservoir when you next stop the vehicle.
Fluid specification
For optimum cleaning and to avoid freezing, this fl uid must not be
topped up with or replaced with plain water.
In wintry conditions, the use of an ethyl alcohol or methanol base fl uid is
recommended.

188
DASHBOARD FUSES
The fusebox is placed in the lower section of the dashboard (left-hand \
side). It consists of two boxes.
Access to the fuses
 Refer to the paragraph "Access to the tools".
Fuse tables
Fuse N° Rating Functions
F2 30 A Locking and deadlocking earth.
F3 5 A Airbags, active bonnet and pretensioners
control unit.
F4 10 A Clutch pedal switch, electrochromatic
rear view mirror, automatic gearbox,
switching and protection unit.
F5 30 A One-touch electric windows, folding door
mirrors supply.
F7 5 A Front and rear courtesy lamps, map
reading lamps, sun visor lighting, glove
box lighting.
F8 20 A Audio equipment, audio/telephone,
multifunction screen, tyre under-infl ation
detection, clock.
F9 30 A 12 V socket.
F10 15 A Steering mounted controls.
F 11 15 A Low current ignition switch.
F12 15 A Instrument panel, air conditioning,
driver's seat memory unit, rain /
sunshine sensor, airbags.
Box 1

8/
PRACTICAL INFORMATION
Fuse N° Rating Functions
F13 5 A Engine fusebox, active bonnet.
F14 15 A Multifunction screen, seat belt and
passenger's front airbag warning lamps
display, instrument panel screen,
amplifi er, Bluetooth system, parking
sensors control unit, USB Box.
F15 30 A Locking and deadlocking.
F17 40 A Rear screen and door mirrors demist/
defrost.
Fuse N° Rating Functions
G36 30 A Hi-Fi amplifi er.
G37 30 A Passenger's seat memory unit.
G38 30 A Driver's seat memory unit.
G39 5 A Lighting memory unit.
G40 30 A Driver and passenger heated seats.
Box 2