2014 Peugeot RCZ light

61
22 26
56 208, 209
105 147
208, 209
FAMILIARISATION
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
MONITORING
The instrument panel has permanent back-
lighting for improved visibility in all situations,
both day and night.
- With the ignition on, the fuel gauge needle should indicate the level of fuel remaining.
- With the engine running, its associated low level warning lamp should go off.
- With the ignition on, the oil level indicator should display "OK" or "correct",
depending on version, for a few seconds.
If the levels are not correct, top up the levels
which are low.
INSTRUMENT PANEL
- With the ignition on, the orange and red warning lamps come on.
- With the engine running, these warning lamps should go off.
If warning lamps remain on, refer to the page
concerned.
WARNING LAMPS
Illumination of the indicator lamp indicates the
status of the corresponding function.
A. Emergency call.
SWITCH PANEL
B. Deactivation of the interior volumetric and anti-tilt sensors (alarm).
C. Central locking.
D. Deactivation of the DSC/ASR system.
E. Deactivation of the front and rear parking sensors.
F. Access to PEUGEOT services.

20
RCZ_EN_CHAP00B_PRISE EN MAIN_ED02-2013
OPTIMISE THE USE OF YOUR GEARBOX
With a manual gearbox, move off gently and change up without
waiting. During acceleration change up early.
With an automatic or electronic gearbox, give preference to automatic
mode and avoid pressing the accelerator pedal heavily or suddenly.
The gear shift indicator invites you engage the most suitable gear: as
soon as the indication is displayed in the instrument panel, follow it
straight away.
For vehicles fi tted with an electronic or automatic gearbox, this
indicator appears only in manual mode.
DRIVE SMOOTHLY
Maintain a safe distance between vehicles, use engine braking rather
than the brake pedal, and press the accelerator progressively. These
practices contribute towards a reduction in fuel consumption and CO
2
emissions and also helps reduce the background traffi c noise.
CONTROL THE USE OF YOUR ELECTRICAL
EQUIPMENT
Before moving off, if the passenger compartment is too warm, ventilate it
by opening the windows and air vents before using the air conditioning.
Above 30 mph (50 km/h), close the windows and leave the air vents
open.
Remember to make use of equipment that can help keep the temperature
in the passenger compartment down (sunroof and window blinds...).
Switch off the air conditioning, unless it has automatic regulation, as soon
as the desired temperature is attained.
Switch off the demisting and defrosting controls, if not automatic.
Switch off the heated seat as soon as possible.
Switch off the headlamps and front foglamps when the level of light
does not require their use.
Avoid running the engine before moving off, particularly in winter; your
vehicle will warm up much faster while driving.
As a passenger, if you avoid connecting your multimedia devices
(fi lm, music, video game...), you will contribute towards limiting the
consumption of electrical energy, and so of fuel.
Disconnect your portable devices before leaving the vehicle.
ECO-DRIVING
Eco-driving is a range of everyday practices that allow the motorist to \
optimise their fuel consumption and CO2 emissions.
If your vehicle has cruise control, make use of the system at speeds
above 25 mph (40 km/h) when the traffi c is fl owing well.

22
PETROL - DIESEL MANUAL
OR AUTOMATIC GEARBOX
INSTRUMENT PANELS DIALS
1. Rev counter.
Indicates the speed of rotation of the engine (x 1 000 rpm).
2. Coolant temperature.
Indicates the temperature of the engine coolant (°Celsius).
3. Fuel level.
Indicates the quantity of fuel remaining in the tank.
4. Vehicle speed.
Indicates the current speed of the moving vehicle (mph or km/h).
5. Small display screen.
6. Central display screen.
7. Display management button.
Starts a manual CHECK.
Recalls the service information.
Resets the selected function to zero (trip distance recorder or service indicator).
8. Lighting dimmer button.
Adjusts the brightness of the lighting of the instruments and controls.
With large central display screen
Panel grouping together the vehicle operation indication dials and
warning lamps, with permanent back-lighting.
For more information, refer to the paragraph relating to the button
or function and its associated display.
With small central display screen

1/
MONITORING
Vehicle parameters *
This menu allows you to activate or deactivate certain driving and
comfort equipment:
- vehicle speed repeat,
- selective unlocking (refer to the "Access" section),
- guide-me-home lighting (refer to the "Visibility" section),
- interior mood lighting (refer to the "Ease of use and comfort" section),
- daytime running lamps ** (refer to the "Visibility" section),
- directional headlamps (refer to the "Visibility" section),
- rear parking sensors (refer to the "Driving" section).
Choice of language
This menu allows you to select the language used by the display:
Deutsch, English, Espanol, Français, Italiano, Nederlands, Portugues,\

Pусский, Portugues-Brasil, Türkçe ** .
Choice of units
This menu allows you to select the units: temperature (°Celsius or
°Fahrenheit) and fuel consumption (l/100 km, mpg or km/l).
* Depending on version.
** Depending on country of sale.

30
Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the
corresponding system has come into operation.
It may be accompanied by an audible signal.
Depending on your version of instrument panel, illumination of the
indicator lamp may also be accompanied by:
- a symbol in the central instrument panel screen and a message in the multifunction screen,
or
- a symbol and a message in the central instrument panel screen.
Warning lamp is on Cause Action / Observations
Left-hand
direction
indicato r fl ashing with
buzzer.
The lighting stalk is pushed
down.

Right-hand direction
indicator fl ashing with
buzzer. The lighting stalk is pushed up.
Hazard warning
lamps fl ashing with
audible signal. The hazard warning lamps
switch, located on the dashboard,
has been operated. The left-hand and right-hand direction indicators and their
associated indicator lamps fl ash simultaneously.
Sidelamps fi xed. The lighting stalk is in the
"Sidelamps" position or the
"AUTO" position with low light.
Dipped beam
headlamps fi xed. The lighting stalk is in the
"Dipped beam headlamps"
position or in the "AUTO" position
in conditions of low light.
Main beam
headlamps fi xed. The lighting stalk is pulled
towards you. Pull the stalk again to return to dipped beam
headlamps.

38
LIGHTING DIMMER
Permits manual adjustment of the brightness of the instruments and
controls to suit the ambient light level. Only operates when the vehicle\

lighting is on, with the exception of the daytime running lamps.
Activation
 Press the button to change the brightness of the instruments and controls.
 When the lighting reaches the minimum setting, release the button, then press again to increase it.
or
 When the lighting reaches the maximum setting, release the button, then press again to reduce it.
 When the lighting reaches the level of brightness required, release the button.
Deactivation
When the vehicle lighting is off, or in day mode on vehicles fi tted with
daytime running lamps, pressing the button does not have any effect.
CLOCK
The analogue clock, located between the central vents of the
dashboard, does not have an adjustment button.
To set the time, refer to the section relating to your multifunction
screen's confi guration menu.
The clock is synchronised with the multifunction screen time; once the
the setting has been confi rmed on the multifunction screen, the hands
will turn to synchronise with the screen, and each time the ignition is \
switched on.

44
* Depending on version.
** Depending on country of sale.
"PERSONALISATION-CONFIGURATION"
MENU
Once this menu has been selected, you can gain access to the
following functions:
- defi ne the vehicle parameters,
- display confi guration,
- choice of language.
Define the vehicle parameters *
Once this menu has been selected, you can activate or deactivate the
following equipment:
- selective unlocking (refer to the "Access" section),
- guide-me-home lighting (refer to the "Visibility" section),
- interior mood lighting (refer to the "Ease of use and comfort" section)\
,
- daytime running lamps ** (refer to the "Visibility" section),
- rear parking sensors (refer to the "Driving" section). Example: setting of the duration of the guide-me-home lighting
 Press the "
 " or "  " buttons, then the "OK" button to select the
menu required.
 Press the "  " or "  " buttons, then the "OK" button to select the
"Guide-me-home headlamps" line.
 Press the "  " or "  " buttons to set the value required (15, 30 or
60 seconds), then press the "OK" button to confi rm.
 Press the "  " or "  " buttons, then the "OK" button to select the
"OK" box and confi rm or press the "Back" button to cancel.

1/
MONITORING
"SETUP" MENU
 Press the "SETUP" button to gain access to the confi guration
menu:
- "Display confi guration",
- "Voice synthesis",
- "Choice of language",
- "Vehicle parameters",
- "Alert log".
For safety reasons, confi guration of the multifunction screen by
the driver must only be done when stationary.
Display configuration
This menu allows you to choose a colour scheme for the screen, to
adjust the brightness, set the date and time and choose the units for
distance (km or miles), fuel consumption (l/100 km, mpg or km/l) and\

temperature (°Centigrade or °Fahrenheit).
Voice synthesis
This men allows you to adjust the volume for navigation instructions and\

to choose the type of voice (male or female).
* Depending on version.
** According to country of sale.
Choice of language
This menu allows you to choose the language used by the screen
(French, English, Italian, Portuguese, Spanish, German, Dutch, Turkish,
Polish, Russian).
Vehicle parameters *
This menu allows you to activate or deactivate certain driving and
comfort equipment, arranged by category:
- Access to the vehicle ● Selective unlocking of the driver's door; refer to "Access"),
- Parking sensors
- Operation of wipers
● Rear wiper linked to reverse (rear wiper operates in reverse gear; refer to "Visibility"),
- Lighting confi guration (see "Visibility"):
● Duration of the guide-me-home lighting,
● Directional headlamps (main/additional directional lighting),
● Mood lighting (Interior mood lighting),
● Daytime running lamps function ** .
Alert log
It lists the active alerts by displaying their associated messages in tu\
rn.
Setting the date and time
 Press " SETUP ".
 Select "Display confi guration" and confi rm.
 Select "Set date and time" and confi rm.
You can select " Synchronise the minutes with GPS ", so that the
minutes are adjusted automatically by satellite reception.  Select the setting to modify. Conform by pressing "
OK ", then adjust
the setting and modify again.
 Adjust the settings one by one.
 Select " OK " in the screen then confi rm to save the setting.