Page 145 of 240
 143
QUICK HELP 
8
Failed bulb or lamp
  Third  brake  lamp 
  Type B , P21W - 21W 
   -   Unscrew  the  two  screws. 
  -   Remove  the  lamp. 
  -   Remove the bulb holder moving aside the two tabs. 
  -   Remove the faulty bulb by pressing it  lightly while turning it anticlockwise. 
  -   Change  the  bulb.   
  Number  plate  lamps 
   Type C,  C5W - 5W 
   -   Press the point, indicated by the arrow,  then remove the plastic lens. 
  -   Remove the failed bulb by moving aside  the two contacts. 
  -   With the new bulb in place, ensure  that it is secured correctly between the 
two contacts. 
  -   Replace the plastic lens and press on it  to lock it in place.     
     
        
        Page 151 of 240

 149
QUICK HELP 
8
Puncture
   -   If a pressure of at least  3 bars  is not 
reached within 5 minutes, disconnect 
the compressor from the valve and the 
power socket, then move the vehicle 
forward by approximately 10 metres to 
distribute the sealant fluid inside the 
tyre. 
  -   Then repeat the inflating operation:     ●   if a pressure of at least   3 bars  is not 
reached within 10 minutes, switch off 
your vehicle: the tyre has suffered 
too much damage and repair has not 
been possible.Contact a PEUGEOT 
dealer or a qualified workshop. 
  ●   if the tyre has been inflated to a  pressure of   4 bars , set off again 
immediately.   
 After driving for approximately 10 minutes, 
stop and check the pressure of the tyre 
again. 
 Adjust the pressure if necessary and contact 
a PEUGEOT dealer or a qualified workshop 
as soon as possible.  
  Checking  and  adjusting the pressure 
 The compressor can only be used to check 
and adjust the pressure. 
   -   Disconnect  the  hose   I   and connect it to 
the tyre valve directly; the cartridge will 
then be connected to the compressor 
and the filling fluid will not be injected.  
 If it is necessary to deflate the tyre, connect 
the hose   I  to the tyre valve and press the 
yellow button, placed in the centre of the 
switch on the compressor.  
  Replacing  the  cartridge 
 To replace the sealant cartridge, carry out 
the following operations: 
   -   disconnect  the  hose   I  , 
  -   turn the cartridge to be replaced  anticlockwise and lift it, 
  -   insert the new cartridge and turn it  clockwise, 
  -   reconnect  the  hose   I   and connect the 
hose   B  in its location.   
   The cartridge contains ethylene-glycol, a 
product which is harmful if swallowed and 
which causes irritation to the eyes. 
 Keep out of reach of children. 
 After use, do not discard the cartridge in the 
environment, take it to a PEUGEOT dealer or an 
appropriate waste disposal organisation. 
 This puncture repair kit and replacement cartridges 
are available from PEUGEOT dealers.   
     
        
        Page 168 of 240
01
  " Telephone "  
allows the connection of a mobile telephone via  Bluetooth.   
  " Vehicle information "  
gives access to the ambient temperature, the clock, the compass and the trip computer.  
  " Settings "  
allows certain functions to be activated, deactivated or settings adjusted.  
           " Radio "  
allows the selection of different radio sources and certain functions to be activated, deactivated or settings adjusted.  
  " Navigation "  
allows settings for the navigation system and the choice of a destination.  
  " Media "  
allows selection of different music sources and certain functions to be activated, deactivated or settings adjusted.  
 GENERAL  OPERATION 
10.2 
     
        
        Page 197 of 240
10.31
Level 1Level 2Level 3Comment
  
More
Ambient temp.     Displays the ambient temperature. 
  
More
Clock     Displays the clock. 
  
More
Compass     Displays the direction of travel. 
  
More
Trip
  Current trip Range 
 Displays the trip computer.  Make a long press on button "Trip A" or "Trip B" to reset the trip in question. 
 Current fuel consumption 
  Trip A
 Average fuel consumption 
 Average  speed 
 Distance  travelled 
 Journey  time 
  Trip B
 Average fuel consumption 
 Average  speed 
 Distance  travelled 
 Journey  time  
     
        
        Page 201 of 240
10.35
Level 1Level 2Level 3Comment
Settings
Voice commands
Voice response time
 Brief 
 Set the response time for the voice system. 
 Long 
Display command list
 Never 
 Display suggestions with the different options during a voice session.  With  help 
 Always 
Settings
Clock and Date
Set time and format Set the time. 
Display time mode
 On 
 Set the display mode for the digital clock in the status bar. 
 Off 
Sync time
 On 
 Set the automatic display of time. 
 Off 
Set date Set the date.  
     
        
        Page 207 of 240
10.41
Level 1Level 2Level 3Comment
Settings
Radio settings
DAB announcements
 On 
 Activate or deactivate options. 
 Off 
 Categories 
 Activate or deactivate option: Alarm, Event announcement, Finance fl ash, Info fl ash, Programme info, Special event, Sport info, Public transport info, Alarm info, Weather fl ash. 
Settings
Restore settings
Ye s
 Restore the default settings for the screen, clock, sounds and the radio. 
No