2014 Peugeot 508 RXH 4WD

19
508RXH_en_Chap00c_systeme-hybride_ed01-2014
Ready lamp
With the gear selector in position N, press the
brake pedal and start the hybrid system.
th

is lamp comes on when the vehicle is ready
to move off ("Auto" mode is on by default) and
so the driver can press the accelerator.
th

is lamp comes on more or less instantly
but may take a few seconds in some cases
(in particular, the time needed for pre-heating
the Diesel engine in cold weather or in energy
economy mode, for example, ...).
HYbrid4 mode selector
"AutO" mode, for everyday use and optimised
fuel consumption.
"Z
eV

" mode, to force electric running. "SPORt" m
ode, to make use of the maximum
performance of the vehicle.
"4WD" mode, to force the vehicle into 4x4 mode.
When stationary, switch off the hybrid
system and check that the Ready


lamp
is off when you leave the vehicle,
otherwise the hybrid system will remain
active.
us
ing the selector, the driver can choose one of the four drive modes for the vehicle.
tu

rn the dial to the right or left; the mode selected is confirmed by illumination of the corresponding
i n d i c a t o r.
For more information, refer to the
"
un

derbonnet precautions / warnings"
section.
.
Hybrid system

21
508RXH_en_Chap00c_systeme-hybride_ed01-2014
"SPORT" mode
(Diesel and
electric)
this mode allows more dynamic driving by
providing additional performance.
Vehicle acceleration and pick-up are
maximised by using the capacity of the electric
motor, supplementing the power of the Diesel
engine.
th

is mode manages the response of the
accelerator, the electronic gearbox and the use
of the electric motor.
In "SPOR
t" m

ode:
-
t
h
e electric motor can be used up to
75 mph (120 km/h).
"4WD" mode*
(Diesel and
electric)
this mode provides additional traction ** at
low speed by driving all 4 wheels of the vehicle
continuously: the Diesel engine (front wheel
drive) and the electric motor (rear wheel drive)
operate simultaneously and permanently.
th

eir coupling is managed electronically to
optimise traction when grip is poor.
In 4WD mode:
-

P
ower for the electric motor is provided, if
necessary, by the alternator-starter motor
of the front engine.
t
h
e Diesel engine
operates continuously.
-
t
h
e additional traction from the electric
motor is available up to 75 mph (120 km/h).th is mode should be used on snow
covered roads or difficult ground
(mud, sand, ...).
In this mode, in severe conditions
and if the circumstances allow, it is
recommended that you accelerate
strongly to facilitate moving off and
reduce the risk of getting stuck.
th

e addition of "4WD" traction is
available whatever:
-

t
he state of charge of the traction
battery,
-

t
he altitude.
Be aware of the ground clearance of
your vehicle: around 184 mm (with the
vehicle in working order: driver only and
the fuel tank full) in ideal conditions.
th

is value will vary with vehicle load,
the nature of the ground sur face and
the surroundings.
If the driver considers that the vehicle
can traverse an obstacle, they assume
entire responsibility for this.
* "4WD": 4 Wheel Drive.
**
t
h
is mode will be even more effective if tyres
more suitable for the conditions are fitted
("winter" tyres in particular). When driving on flooded roads or when
crossing a ford, drive at walking pace.
.
Hybrid system

240
508RXH_en_Chap10_caracteristiques-techniques_ed01-2014
Identification markingsVarious visible markings for the identification and tracing of your vehicle.
A.
V
ehicle Identification Number (VIN)
under the bonnet.


t
h
is number is engraved on the bodywork
near the damper support.
th

e tyre pressures must be checked
when the tyres are cold, at least once
a month.
Low tyre pressures increase fuel
consumption.
B.
V

ehicle identification Number (VIN) on
the windscreen lower crossmember.


t
h
is number is indicated on a self-
adhesive label which is visible through the
windscreen. C.
M

anufacturer's label.


t
h
e VIN is indicated on a self-destroying
label affixed to the door aperture, on the
driver's side.
D.
T

yre/paint label.


t
h
is label is fitted to the middle pillar, on
the driver's side. It bears the following information:
-

t
he tyre inflation pressures with and without
load,
-

t
he tyre sizes,
-

t
he inflation pressure of the spare wheel,
-

t
he paint colour code.
th

e use of snow chains is only
authorised on the front wheels.
th

e selector must be in 4WD mode.
technical data