2014 MITSUBISHI OUTLANDER Vehicle

Other Settings 217
INFO/SETTINGS SETTINGS
Others
Item Settings content
Horn Answerback with Remote Engine Start
*Enables/disables the function that sounds the horn when the
engine is started with the remote controller.
Accessor y Power Timeout Sets the duration ACC stays ON when the ignition switch is
ACC.
Reset the Vehicle Settings
1Execute up to Step 2 in “Vehicle
Settings”(P213)
.
▼
2Touch Reset all .
3Touch Ye s .
▼
The resetting of equipment setting is
complete.

Troubleshooting 219
Other
Other
Troubleshooting
Please check these items if a message appears on the screen, or if you t\
hink something is not working properly.
If This Message Appears...
A message is displayed on the screen of this product according to the sit\
uation.
Navigation Functions
Message CauseResponse
End of map coverage area. The map was scrolled to an area for which there is no
map data.Scroll the map back to where there is data.
Scale will be changed. The centre of your car and cursor was moved from a
location with a scale being set to a location without it.
Or returned to a location where the scale is set.-
No POI found. A POI search was performed, but there is no POI in
this product that matches the specified information.Search using different conditions.
The programme cannot be written to the map card.
Check the map card that is in the map slot. The map card is in the “Lock” state and cannot be
written.Take out the map card and unlock the “Lock”.
Map data cannot be read.
Check the map card that is in the map slot. Map data cannot be read from the map card.
If the system does not recover after a few minutes, stop
your vehicle in a safe location, then check if the MAP
card is properly inserted.
→“SD Cards”(P14)If this does not fix the problem, consult with your dealer.
Restore the map card system program using the
program disc. Consult with your dealer.
→“If This Product Does Not Start Up”(P224)
No map card is inserted into the map slot.Insert the map card.→“Insert an SD Card”(P15)
The map card has malfunctioned for some reason.Consult with your dealer.

220 Troubleshooting
Audio Functions
Message CauseResponse
Play is impossible due to a mechanism error. The drive has malfunctioned for some reason.Check that there is no problem with the disc, and insert
the disc again. If the problem persists, consult with your
dealer.
The disc is damaged or warped. Do not insert a damaged or warped disc.
Play is impossible due to low battery voltage. The vehicle's battery voltage has dropped.Check the battery.
Cannot be played.
Check the disk. A disc is inserted that cannot be played.
Insert a disc that can be played.
→“Types of Disc That Can Be Played Back” (P84)
The disc is inserted upside down.Insert with the label side up.
The disc has condensation on it. Wait a while before inserting again.
The disc is dirty. Clean the read surface of the disc.
Play is impossible due to high temperatures. The temperature inside the product is high.Remove the disc, and wait for the internal temperature
to return to normal.
This iPod cannot be played. Authentication failed.Reconnect your iPod.
The connected iPod has an unsupported format and
cannot be recognized. Use an iPod that supports this product.
(P8)
This iPod software version is not correct.
Please use the latest version software.
This USB memory cannot be played. Authentication failed.Reconnect the USB device.
No data that can be played. There are no audio files that can be played back.Add audio files that can be played.
→“Audio Files(MP3/WMA/AAC/WAV)”(P85)
An iPod not containing any tracks has been
connected.Connect an iPod containing tracks.
Cannot be played. Unsupported audio files have been played.Confirm audio files that can be played.
→“Audio Files(MP3/WMA/AAC/WAV)”(P85)
Copyright protected files have been played.Copyright protected files cannot be played.
Use files that are not copyright protected.
The audio file is corrupted. Add uncorrupted audio files.
The SD card in the USER slot could not be written.
Check the SD card. The SD card in the user slot is in the “Lock” state and
cannot be written.Take out the SD card from the user slot and unlock the
“Lock”.

Troubleshooting 221
Other
If You Think Something Is Not Working Properly...
Here is a list of symptoms, causes and responses if you think something \
is not working properly.
Common
Symptoms CauseResponse
The operation sound is not made. The operation sound is set to [OFF].Set the [Navi Voice/Others] “Beep Sound Volume” to [1]
to [3].
→“Navi Voice/Others”(P202)
Nothing is displayed on the screen. The screen is turned OFF.Stop the vehicle in a safe location, apply the parking
brakes, then perform the operation to turn the screen
back ON
(P213).
The vehicle's battery voltage has dropped. Charge or replace the battery.
The temperature inside the product is high. Please wait for the temperature to drop.
The monitor screen is dark. The monitor brightness is not correctly adjusted.Adjust the monitor brightness.
→ “Picture Control”(P213)
The vehicle's lights are ON.The factory default setting is that when the vehicle's
lights are ON, the screen becomes dark. Press the
key and change this setting. → “Main Unit
Panel”(P12)
Day & night colors setting is “Set Night”. Press the key and change this setting. →“Main
Unit Panel”(P12)

222 Troubleshooting
Navigation Functions
Symptoms CauseResponse
The navigation function does not start. No map card is inserted.Insert the map card.
→“Insert an SD Card”(P15)
The wrong SD card is inserted.Insert the special map card.
There is a problem with the radio signals from the
GPS satellite. Please go on for a little while in the GPS receiving
state.
The vehicle moved by ferry or the like.
The vehicle's direction was changed by a turntable in
a parking garage or the like.
The speed learning level is low.
When this product is used for the first time, it takes a
while to calculate the position of your car. Wait in a location with a good view for a while.
When this product has not been used for long time, it
takes a while to calculate the position of your car.
A mirror type film or shade film that contains carbon is
pasted onto the windshield near the GPS antenna.
Some other antenna is near the GPS antenna. Check the position of the GPS antenna
(P26) and if
another antenna may be the cause of the problem,
move that other antenna.
There is something on the GPS antenna. Check the position of the GPS antenna
(P26) and if
something on the GPS antenna may be the cause of
the problem, remove it.
Immediately after the ignition switch is turned to ACC
or ON, some functions cannot be used immediately
after the map screen is displayed because data is
being read in. Please wait until the reading is completed.
Menu operation is not possible. Immediately after the ignition switch is turned to ACC
or ON, some functions cannot be used immediately
after the map screen is displayed because data is
being read in.Please wait until the reading is completed.
There is no audio guidance. The audio guidance volume is “OFF”.Set the [Navi Voice/Others] “Guidance Voice Volume” to
[1] to [7].
→“Navi Voice/Others”(P202)
RTT messages cannot be received. No RTT message has been received yet.Wait in a location with a good view for a while.

224 Troubleshooting
After the Car Batter y Has
Been Replaced
When the car battery is replaced, some of the
memory contents are deleted.
Example: the set route
(The set destination and any waypoints are
retained.)
If This Product Does Not
Start Up
If the map card program is damaged, use the
program disc to use functions other than the
navigation system.
NOTE
• The program disc for updating is
required. For details, please consult your
Mitsubishi Motors Dealer.
• Unlock the MAP card and audio SD card
locks beforehand.
• Do not use the Loading.kwi in the
“Program for Europe,Russia,Australia”
folder inside the program disc.
1Take the map card out of this
product.
ƒ
„
MAP Card
→“Remove the SD Card”(P16)
2Copy the “Loading.kwi” file
in the “Program for North
America” folder inside the
program disc onto an audio SD
card.
Copy from your home computer to the
audio SD card.
3Insert the audio SD card onto
which you copied the extracted
files into the map slot.
Audio SD Card
Map slot
→“Insert an SD Card”(P15)
4Switch the vehicle's engine
switch key to “OFF” first, then
switch to “ACC” or “ON”.
▼
The product starts up.

END USER LICENSE AGREEMENT OF THE NAVTEQ DATABASE 225
Other
END USER LICENSE AGREEMENT OF THE NAVTEQ DATABASE
END-USER TERMS
The data (“Data”) is provided for your personal, internal use on\
ly and not for
resale. It is protected by copyright, and is subject to the following t\
erms and
conditions which are agreed to by you, on the one hand, and NAVTEQ North
America, LLC (“NT”) and its licensors (including their licensor\
s and suppliers) on
the other hand.
© 2012 NAVTEQ. All rights reserved.
This data includes information taken with permission from Canadian autho\
rities,
including © Her Majesty the Queen in Right of Canada, © Queen's Pr\
inter for
Ontario, © Canada Post Corporation, GeoBase.®, © The Department of Natural
Resources Canada. All rights reserved.
NAVTEQ holds a non-exclusive license from the United States Postal Service\
®
to publish and sell ZIP+4® information.
©United States Postal Service® 2012. Prices are not established, \
controlled or
approved by the United States Postal Service®. The following trademarks and
registrations are owned by the USPS: United States Postal Service, USPS\
, and
ZIP+4.
TERMS AND CONDITIONS
Personal Use Only.
You agree to use this Data for the solely personal, non-commercial purpos\
es for
which you were licensed, and not for service bureau, time-sharing or oth\
er similar
purposes. Accordingly, but subject to the restrictions set forth in the following
paragraphs, you may copy this Data only as necessary for your personal u\
se to
(i) view it, and (ii) save it, provided that you do not remove any c\
opyright notices
that appear and do not modify the Data in any way. You agree not to otherwise
reproduce, copy, modify, decompile, disassemble or reverse engineer any portion
of this Data, and may not transfer or distribute it in any form, for any\
purpose,
except to the extent permitted by mandatory laws. Multi-disc sets may o\
nly be
transferred or sold as a complete set as provided by NT and not as a subset
thereof.
Restrictions.
Except where you have been specifically licensed to do so by NT, and without
limiting the preceding paragraph, you may not (a) use this Data with a\
ny
products, systems, or applications installed or otherwise connected to o\
r
in communication with vehicles, capable of vehicle navigation, positioni\
ng,
dispatch, real time route guidance, fleet management or similar applications;
or (b) with or in communication with any positioning devices or any mo\
bile or
wireless-connected electronic or computer devices, including without lim\
itation
cellular phones, palmtop and handheld computers, pagers, and personal di\
gital
assistants or PDAs.
Warning.
The Data may contain inaccurate or incomplete information due to the pas\
sage
of time, changing circumstances, sources used and the nature of collecti\
ng
comprehensive geographic data, any of which may lead to incorrect result\
s.
No Warranty.
This Data is provided to you “as is,” and you agree to use it at y\
our own risk.
NT and its licensors (and their licensors and suppliers) make no guarant\
ees,
representations or warranties of any kind, express or implied, arising b\
y law or
otherwise, including but not limited to, content, quality, accuracy, completeness,
effectiveness, reliability, fitness for a particular purpose, usefulness, use or results
to be obtained from this Data, or that the Data or server will be uninte\
rrupted or
error-free.
Continued on the next page