2014 MITSUBISHI MIRAGE display

5-20 Comfort controls
5
Refer to “Personalizing the air selection (Changing the func-
tion setting)” on page5-22.
MODE switch
N00737100208
To change the amount of air flowing from the vents, press the
MODE switch. Each time the MODE switch is pressed, the
mode changes to the next one in the following sequence: “ ”
→ “” → “” → “” → “ ”. The selected mode is
shown in the display (A). Refer to “Changing the mode selec-
tion” on page 5-3.
BK0162600US.book 20 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-21
5
Defogger switch
N00703400015
When this switch is pressed, the mode changes to the “ ”
mode. The indicator light (A) will come on. The selected mode
is shown in the display (B). Refer to “Changing the mode
selection” on page 5-3.NOTE
When the defogger switch is pressed, the air conditioning
system automatically operates and outside air (as opposed
to recirculated air) is selected.
Refer to “Defrosting or defogging (windshield, door win-
dows)” on page 5-26.
Air selection switch
N00737200368
Normally, use the outside air position to keep the windshield
and side windows clear and to quickly remove fog or frost
from the windshield.
To change the air selection, simply press the air selection
switch.
The selected position will be shown in the display (A).

Outside air: “ ” indicator is ON
Outside air is introduced into the passenger compartment.

Recirculated air: “ ” indicator is ON
Air is recirculated inside the passenger compartment.
BK0162600US.book 21 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-23
5
NOTE
The factory setting is “Enable automatic air control”.

When the defogger switch is pressed, the air selection will
automatically change to the outside air position, even if
the system is set to “Disable automatic air control”, in
order to prevent windows from fogging up.
Air conditioning switch
N00737300343
Push the switch, and the air conditioning compressor will turn
on. The “ ” indicator will be shown in the display (A).
Push the switch again and the air conditioning compressor will
stop and the indicator goes off.
CAUTION
!
Using the air conditioning slightly increases the
engine idle speed. Therefore, make sure your foot is
firmly on the brake pedal when shifting the
transaxle into drive.
BK0162600US.book 23 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-25
5
AUTO switch
N00703500016
When the AUTO switch is pressed, the mode selection, blower
speed adjustment, recirculated/outside air selection, tempera-
ture adjustment, and air conditioner ON/OFF status are all con-
trolled automatically.
The “AUTO” indicator will be shown in the display (A).
OFF switch
N00703600017
Push the switch to turn off the air conditioning system.
BK0162600US.book 25 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-30 Comfort controls
5AM/FM electronically tuned radio with CD
player
(if so equipped)
N00734301075
The audio system can only be used when the ignition switch or
the operation mode is in ON or ACC.NOTE
To listen to the audio system while the engine is not run-
ning, turn the ignition switch to the “ACC” position or put
the operation mode in ACC.

If a cellular phone is used inside the vehicle, it may create
noise in the audio equipment. This does not mean that
anything is wrong with your audio equipment. In such a
case, use the cellular phone at a place as far away as possi-
ble from the audio equipment.

If foreign objects or water get into the audio equipment, or
if smoke or a strange odor comes from it, immediately
turn off the audio system and have it checked at an autho-
rized Mitsubishi Motors dealer or a repair facility of your
choice. Never try to repair it yourself. Avoid using the
audio system until it is inspected by a qualified person.

If the audio system is damaged by foreign objects, water,
or fire, have the system checked by a qualified Mitsubishi
Motors technician.
Volume and tone control panel
N00711900729
To adjust the volume
N00712000411
Turn the VOL knob clockwise to increase the volume; counter-
clockwise to decrease the volume.
The status will be displayed in the display.1- PWR (On-Off) switch
2- VOL (Volume control) knob
3- Display
4-
/MENU (Mode change) button
5- Sound control button
BK0162600US.book 30 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-31
5
To adjust the tone
N00712100685
Press the /MENU button to select BASS → TREBLE →
FA D E R → BALANCE → Sound control mode off.BASS (Bass tone control)Press the sound control button either or to select the
desired bass level.TREBLE (Treble tone control)Press the sound control button either or to select the
desired treble level.FADER (Front/Rear balance control) (if equipped with
rear speakers)Press the sound control button either or to balance the
volume of sound from the front and the rear speakers.BALANCE (Left/Right balance control)Press the sound control button either or to balance the
volume of sound from the left and the right speakers.NOTE
The sound control mode will be canceled when the
another mode is selected or no adjustment is performed
for more than 10 seconds.

In a two-speakers vehicle, keep the FADER setting in the
middle position. Since no rear speakers are connected,
adjusting the FADER setting toward the “REAR” side
will result in a loss of sound output.
Radio control panel and display
N00734900915
1- RADIO (AM/FM selection) button
2- PWR (On-Off) switch
3- Display
4- Seek (Down-seek) button
5- Seek (Up-seek) button
6- Memory select buttons
BK0162600US.book 31 ページ ２０１３年３月２２日　金曜日　午後２時４１分

5-32 Comfort controls
5
To listen to the radio
N00735000926
1. Press the PWR switch or the RADIO button to turn on the
radio.
Press and hold the PWR switch for 2 seconds or longer to
turn off the radio.
2. Press the RADIO button to select the desired band
(AM/FM1/FM2).
3. Press the seek button to tune to a station, or press one of
the memory select buttons to tune in to a station memo-
rized for that button.
Refer to “Automatic tuning”, “Manual tuning” or “To
enter frequencies into the memory”.To tune the radioManual tuning
The frequency changes every time the seek button is pressed.
Press the button to select the desired station.
Automatic tuning
After keeping the seek button depressed until it beeps, release
the button, and the selected station reception will start.
To enter frequencies into the memoryAs many as 6 AM and 12 FM stations can be entered into the
memory.
To store a frequency in the memory, follow these steps:
1. Press the seek button to tune to the frequency you wish to
keep in the memory.
2. Press one of the memory select buttons until it beeps.
The sound will be momentarily interrupted while the fre-
quency is being entered into the memory. The number of
the button matching the entry in the memory as well as the
frequency is displayed.
3. The preset memory setting is retrieved by pressing the
button and then releasing it within 1 second.
BK0162600US.book 32 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Comfort controls
5-33
5
CD control panel and display
N00735300756
To listen to a CD
N00735501087
To s e t a d i s c1. Insert the disc with the label facing up.
When a disc is inserted, the CD indicator will come on
and the CD player will begin playing even if the radio is
being used. The CD player will also start playback when
the CD button is pressed with a disc in the player or with a
disc set in the Disc-loading slot, even if the radio is being
used.
2. To stop the CD, turn off the power by pressing the PWR
switch for 2 seconds or longer, or change over to the radio
mode by pressing the RADIO button, or eject the disc by
pressing the eject button.NOTE
For information on adjusting the volume and tone, refer to
“To adjust the volume” on page 5-30 and “To adjust the
tone” on page 5-31.

3 inches (8 cm) compact disc cannot be played on this CD
player.

For information concerning the handling of compact
discs, refer to “Handling of compact discs” on page 5-62.
1- CD (CD mode changeover) button
2- RADIO button
3- DISP (Display)/ (Return) button
4- CD eject button
5- CD indicator
6- Disc-loading slot
7- FOLDER indicator
8- TRACK indicator
9- Display
10- RPT (Repeat)/F-RPT (Folder repeat mode) indicator
11- RDM (Random mode)/F-RDM (Folder random mode) indi-
cator
12- SEL (Select) indicator
13- PAGE (Title scroll) button
14- (Fast-reverse/Track down) button
15- (Fast-forward/Track up) button
16- PWR (On-Off)/SEL (Select) switch
17- RPT (Repeat) button
18- RDM (Random) button
BK0162600US.book 33 ページ ２０１３年３月２２日　金曜日　午後２時４１分