2014 MITSUBISHI MIRAGE lock

Vehicle care and maintenance
7-49
7
Parking lights
N00917300567
1. Turn the socket (A) counterclockwise to remove it.2. Pull the bulb out of the socket.
3. To install the bulb, perform the removal steps in reverse.*- Front of the vehicle
BK0162600US.book 49 ページ ２０１３年３月２２日　金曜日　午後２時４１分

7-50 Vehicle care and maintenance
7
Front fog lights
(if so equipped)
N00943600763
1. To create enough work space, turn the steering wheel all
the way in the direction opposite to the side you wish to
replace.
2. Remove the clips/bolts (A) to turn up the cover (B).3. While pressing the tab (C), pull out the connector (D).
4. Turn the bulb (E) counterclockwise to remove it.
BK0162600US.book 50 ページ ２０１３年３月２２日　金曜日　午後２時４１分

7-52 Vehicle care and maintenance
7
3. Move the light unit toward the rear of the vehicle to unfix
the notch (B) and pin (C).4. Turn the socket counterclockwise to remove it.
D- Back-up light
E- Rear turn signal light
F- Rear side-marker light, and tail and stop light
BK0162600US.book 52 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Vehicle care and maintenance
7-53
7
5. Remove the bulb from the socket by turning it counter-
clockwise while pressing in.6. To install the bulb, perform the removal steps in reverse.
NOTE
When mounting the lamp unit, align the notch (G) and pin
(H) on the lamp unit with the clip (I) and hole (J) in the
body.
BK0162600US.book 53 ページ ２０１３年３月２２日　金曜日　午後２時４１分

7-54 Vehicle care and maintenance
7
License plate light
N00944000403
1. Remove the screws (A) that hold the light unit and remove
the light unit.2. Turn the socket counterclockwise to remove it.
BK0162600US.book 54 ページ ２０１３年３月２２日　金曜日　午後２時４１分

7-56 Vehicle care and maintenance
7
These can all be dangerous, and they all can damage your vehi-
cle.
Cleaning the inside of your vehicle
N00945200095
After washing the inside of your vehicle with any cleaner, wipe
it dry in a shady, well ventilated area.NOTE
Always read the instructions on the cleaner label.Plastic, vinyl leather, fabric and flocked parts
N00945300142
1. Lightly wipe these off with a soft cloth soaked in a 3%
solution of gentle soap and water.
2. To rinse, dip the cloth in fresh water, wring it out well, and
wipe off all the soap.
CAUTION
!
Do not use organic substances (solvents, benzine,
kerosene, alcohol, gasoline, etc.) or alkaline or acidic
solutions.
These chemicals can cause discoloring, staining or
cracking of the surface.
If you use cleaners or polishing agents, make sure
their ingredients do not include the substances men-
tioned above.
BK0162600US.book 56 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Specifications
9-3
9
Chassis numberThe chassis number is stamped on the bulkhead as shown in
the illustration.
Engine serial numberThe engine serial number is stamped on the cylinder block as
shown in the illustration.*- Front of the vehicle
BK0162600US.book 3 ページ ２０１３年３月２２日　金曜日　午後２時４１分

Specifications
9-9
9 Capacity
N01148001061
*: similar high quality ethylene glycol based non-silicate, non-amine, non-nitrate and non-borate coolant with long life hybrid
organic acid technology
Item
Capacity
Lubricants
Fuel
(approximate)9.2 gal (35 L) Refer to “Fuel selection” on page 1-2Engine oil
Oil pan 2.9 qt (2.8 L) Engine oils displaying the ILSAC certification mark (“star-
burst” symbol) on the container.
If these oils are not available, an API classification SN or
higher can be used.Oil filter .21 qt (0.2 L)
Manual transaxle 1.7 qt (1.6 L)Mitsubishi Motors Genuine NEW MULTI GEAR OIL ECO
API classification GL-4 SAE 75W-80Continuously variable transmission (CVT) 7.4 qt (7.0 L) Mitsubishi Motors Genuine CVTF - J4Brake As required Conforming to Brake fluid DOT3 or DOT4Hood lock release mechanism and safety catch As required Multipurpose type grease NLGI Grade 2Engine coolant
{Includes .53 qt (0.5 L) in reserve
tank}
M/T 4.2 qt (4.0 L)
Mitsubishi Motors Genuine Super Long Life Coolant Pre-
mium or equivalent*CVT 4.8 qt (4.6 L)
Washer fluid 2.6 qt (2.5 L) —Refrigerant (air conditioning)Refer to the “Air
conditioning label”
on page 9-2.HFC-134a
BK0162600US.book 9 ページ ２０１３年３月２２日　金曜日　午後２時４１分