2014 LEXUS RX270 display

39
1-2. Opening, closing and locking the doors
1
Before driving
RX350/270_EE
■Notes for locking the doors
●Touching the door lock sensor while wearing gloves may delay or prevent lock
operation. Remove the gloves and touch the lock sensor again.
●If the door handle becomes wet while the electronic key is within the effective
range, the door may lock and unlock repeatedly. Place the key in a position 2 m
(6 ft.) or more separate from the vehicle while the vehicle is being washed. (Take
care to ensure that the key is not stolen.)
●If the electronic key is inside the vehicle and a door handle becomes wet during
a car wash, a message may be shown on the multi-information display and a
buzzer will sound outside the vehicle. To turn off the alarm, lock all the doors.
●The lock sensor may not work properly if it comes into contact with ice, snow,
mud, etc. Clean the lock sensor and attempt to operate it again, or use the lock
sensor on the lower part of the door handle.
●Fingernails may scrape against the door during operation of the door handle.
Be careful not to injure fingernails or damage the surface of the door.
■Notes for the unlocking function
●Gripping the door handle when wearing a glove may not unlock the door.
●A sudden approach to the effective range or door handle may prevent the
doors from being unlocked. In this case, return the door handle to the original
position and check that the doors unlock before pulling the door handle again.
●If there is another electronic key in the detection area, it may take slightly longer
to unlock the doors after the door handle is gripped.
■When the vehicle is not driven for extended periods
●To prevent theft of the vehicle, do not leave the electronic key within 2 m (6 ft.)
of the vehicle.
●The smart entry & start system can be deactivated in advance. (→P. 622)
■To operate the system properly
Make sure to carry the electronic key when operating the system. Do not get the
electronic key too close to the vehicle when operating the system from the outside
of the vehicle.
Depending on the position and holding condition of the electronic key, the key may
not be detected correctly and the system may not operate properly. (The alarm may
go off accidentally, or the door lock prevention function may not operate.)
RX350_270_EE_48D77E.book 39 ページ ２０１４年１月２４日　金曜日　午前１０時４分

103
1-4. Opening and closing the windows and moon roof
1
Before driving
RX350/270_EE
■Door lock linked window operation
●The power windows can be opened and closed using the mechanical key.
(→P. 5 9 1 )
●The power windows can be opened and closed using the wireless remote con-
trol if customized at any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional. (→P. 5 3 )
■Window close suggestion mode
If the “ENGINE START STOP” switch is turned off with the windows open, a sug-
gestion to close all the windows is shown on the multi-information display.
(→P. 2 0 8 )
■When the battery is disconnected
The window lock switch is disabled. If necessary, press the window lock switch after
reconnecting the battery.
■Customization
Settings (e.g. linked door lock operation) can be changed.
(Customizable features →P. 6 2 2 )
CAUTION
■Closing the windows
Observe the following precautions.
Failing to do so may result in death or serious injury.
●Check to make sure that all passengers do not have any part of their body in a
position where it could be caught when a window is being operated.
●Do not allow children to operate the power windows.
Closing a power window on someone can cause death or serious injury.
The driver is responsible for instructing children not to operate the power win-
dows.
■Jam protection function
●Never use any part of your body to intentionally activate the jam protection func-
tion.
●The jam protection function may not work if something gets caught just before
the window fully closes. Also, the jam protection does not operate when the
power window switch is pulled up continually to close the windows.
RX350_270_EE_48D77E.book 103 ページ ２０１４年１月２４日　金曜日　午前１０時４分

124
1-6. Theft deterrent system
RX350/270_EE
Canceling the intrusion sensor and tilt sensor
Turn the “ENGINE START STOP”
switch off and press the intrusion
sensor and tilt sensor cancel
switch.
A message will be shown on the
multi-information display in the
instrument cluster.
The intrusion sensor and tilt sensor
will revert to on each time the
“ENGINE START STOP” switch is
turned to IGNITION ON mode.
■System maintenance
The vehicle has a maintenance-free type alarm system.
■Items to check before locking the vehicle
To prevent unexpected triggering of the alarm and vehicle theft, make sure of the
following:
●Nobody is in the vehicle.
●The windows and moon roof are closed before the alarm is set.
●No valuables or other personal items are left in the vehicle.
RX350_270_EE_48D77E.book 124 ページ ２０１４年１月２４日　金曜日　午前１０時４分

152
1-7. Safety information
RX350/270_EE
Installing child restraints
Follow the child restraint system manufacturer's instructions. Firmly
secure child restraints to the seats using a seat belt or ISOFIX rigid
anchors. Attach the top strap when installing a child restraint.
Installation with a seat belt
(→P. 153)
ISOFIX rigid anchors (ISOFIX
child restraint system)
(→P. 157)
Lower anchors are provided for
the outer rear seats. (Buttons
displaying the location of the
anchors are attached to the
seats.)
Anchor brackets
(for the top strap) (→P. 1 5 8 )
An anchor bracket is provided
for each rear seat.
RX350_270_EE_48D77E.book 152 ページ ２０１４年１月２４日　金曜日　午前１０時４分

2When driving
167
RX350/270_EE
2-1. Driving procedures
Driving the vehicle ................. 168
Engine (ignition) switch ........ 180
Automatic transmission........ 186
Turn signal lever ...................... 193
Parking brake ........................... 194
Horn ........................................... 195
2-2. Instrument cluster
Gauges and meters ................ 196
Indicators and warning
lights......................................... 198
Multi-information
display .................................... 203
Head-up display ...................... 212
2-3. Operating the lights and
windshield wipers
Headlight switch ...................... 217
Fog light switch ....................... 222
Windshield wipers and
washer .................................... 223
Rear window wiper and
washer ..................................... 227
Headlight cleaner
switch...................................... 2292-4. Using other driving
systems
Cruise control ........................ 230
Dynamic radar cruise
control.................................... 234
Lexus parking
assist-sensor.......................... 248
Electronically modulated
air suspension ....................... 256
Rear view monitor
system ..................................... 263
Driving assist systems ............ 271
All-wheel drive lock
switch ...................................... 277
Hill-start assist control.......... 278
Pre-Crash Safety
system .................................... 280
2-5. Driving information
Utility vehicle
precautions .......................... 289
Cargo and luggage................ 293
Winter driving tips ................. 296
Trailer towing (RX350)....... 300
Trailer towing (RX270) .......... 311
RX350_270_EE_48D77E.book 167 ページ ２０１４年１月２４日　金曜日　午前１０時４分

183
2-1. Driving procedures
2
When driving
RX350/270_EE
■If the engine does not start
The engine immobilizer system may not have been deactivated. (→P. 1 1 5 )
Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional immediately.
■Steering lock
After turning the “ENGINE START STOP” switch off and opening and closing the
doors, the steering wheel will be locked due to the steering lock function. Operat-
ing the “ENGINE START STOP” switch again automatically cancels the steering
lock.
■When the steering lock cannot be released
■Steering lock motor overheating prevention
To prevent the steering lock motor from overheating, the motor may be suspended
if the engine is turned on and off repeatedly in a short period of time. In this case,
refrain from operating the engine. After about 2 seconds, the steering lock motor
will resume functioning.
■When the “ENGINE START STOP” switch indicator flashes in amber
The system may be malfunctioning. Have the vehicle inspected by any authorized
Lexus dealer or repairer, or another duly qualified and equipped professional,
immediately.
■If the electronic key battery is depleted
→P. 5 0 1The green indicator light on the “ENGINE
START STOP” switch will flash and a mes-
sage will be shown on the multi-information
display. Press the “ENGINE START STOP”
switch again while turning the steering wheel
left and right.
RX350_270_EE_48D77E.book 183 ページ ２０１４年１月２４日　金曜日　午前１０時４分

188
2-1. Driving procedures
RX350/270_EE
■Selecting snow mode
Use snow mode for accelerating and driving on slippery road sur-
faces such as snow.
Press the menu switch.
The multi-information display
will change modes to electronic
features control mode.
Press the “∧” or “∨” switch
until “ECT SNOW” appears.
Press the “ENTER” switch to
change to “ON”.
The “ECT SNOW” indicator will
be displayed.
Each pressing of the switch
turns snow mode on and off.
Press the menu switch to
change to the normal display.
STEP1
STEP2
RX350_270_EE_48D77E.book 188 ページ ２０１４年１月２４日　金曜日　午前１０時４分

196
RX350/270_EE
2-2. Instrument cluster
Gauges and meters
Tachometer
Displays the engine speed in revolutions per minute
Multi-information display
Presents the driver with a variety of driving-related data (→P. 2 0 3 )
Speedometer
Displays the vehicle speed
Fuel gauge
Displays the quantity of fuel remaining in the tank
Odometer and trip meter
Odometer: Displays the total distance the vehicle has been driven
Trip meter: Displays the distance the vehicle has been driven since the
meter was last reset. Trip meters “A” and “B” can be used to
record and display different distances independently.
Shift position and shift range display
Displays the selected shift position or selected shift range (→P. 1 8 6 )
Engine coolant temperature gauge
Displays the engine coolant temperature
RX350_270_EE_48D77E.book 196 ページ ２０１４年１月２４日　金曜日　午前１０時４分