Page 44 of 956

441-2. Opening, closing and locking the doors
LX570_OM_OM60L21U_(U) Alarm Situation Correction procedure
Interior alarm pings
continuously The “ENGINE START
STOP” switch was turned to
ACCESSORY mode while
the driver’s door was open
(or the driver’s door was
opened while the “ENGINE
START STOP” switch was in
ACCESSORY mode) Tu r n t h e “ E N G I N E
START STOP” switch
OFF and close the
driver’s door
The “ENGINE START
STOP” switch was turned
OFF while the driver’s door
was open Close the driver’s door
Interior alarm
sounds continu-
ously
* 1
When the “ENGINE START
STOP” switch is in IGNI-
TION ON or ACCESSORY
mode, an attempt was made
to open the door and exit the
vehicle, and the shift lever
was not in “P” Shift the shift lever to “P”
and turn the “ENGINE
START STOP” switch
OFF
Interior and exte-
rior alarms sound
continuously
* 1
When the “ENGINE START
STOP” switch is in IGNI-
TION ON or ACCESSORY
mode, the driver’s door was
closed after the key was car-
ried outside the vehicle, and
the shift lever not in “P” Shift the shift lever to
“P”, turn the “ENGINE
START STOP” switch
OFF and close the
driver’s door again
Page 45 of 956

451-2. Opening, closing and locking the doors
1
Before driving
LX570_OM_OM60L21U_(U) * 1
: A message will be shown on the multi-information display in the instrument
cluster.
* 2
: If the engine does not start when the electronic key is inside the vehicle, the
electronic key battery may be depleted or there may be difficulties receiving
signal from the key. ( P. 3 9 )■
If the smart access system with push-button start does not operate properly ●
Locking and unlocking the doors: Use the mechanical key. ( P. 8 6 7 )●
Starting the engine: P. 8 6 8■
When the electronic key battery is fully depleted
P. 7 8 0■
Customization
Settings (e.g. smart access system with push-button start) can be changed.
(Customizable features P. 9 0 6 )Alarm Situation Correction procedure
Interior alarm pings
once
* 1
The electronic key has a low
battery Replace the electronic
key battery
An attempt was made to start
the engine without the elec-
tronic key being present, or
the electronic key was not
functioning normally Start the engine with the
electronic key
present
* 2
Interior alarm pings
once and exterior
alarm sounds 3
times
* 1
The driver’s door was closed
after the key was carried out-
side the vehicle, and the
“ENGINE START STOP”
switch was not turned OFF Tu r n t h e “ E N G I N E
START STOP” switch
OFF and close the
driver’s door again
An occupant carried the
electronic key outside the
vehicle and closed the door
while the “ENGINE START
STOP” switch was not OFF Bring the electronic key
back into the vehicle
Page 49 of 956

491-2. Opening, closing and locking the doors
1
Before driving
LX570_OM_OM60L21U_(U) ■
Operation signals ●
Doors: A buzzer sounds and the emergency flashers flash to indicate that the
doors have been locked/unlocked. (Locked: Once; Unlocked: Twice)●
Windows and moon roof: A buzzer sounds to indicate that the windows and
moon roof are opening.■
Operating conditions
The wireless remote control will not operate when the “ENGINE START STOP”
switch is in any position other than OFF. ■
Door lock buzzer
If a door is not fully closed, a buzzer soun ds continuously for 5 seconds if an attempt
to lock the door is made. Fully close the do or to stop the buzzer, and lock the vehi-
cle once more. ■
Power back door operation
The power back door can be opened while the vehicle is locked. (one motion) ■
Alarm
Using the wireless remote control to lock the door will set the alarm system. ■
Electronic key battery depletion
P. 4 1■
Security feature
P. 4 3■
If the wireless remote control does not operate properly ●
Locking and unlocking the doors: Use the mechanical key. ( P. 8 6 7 )●
Starting the engine: P. 8 6 8■
When the electronic key battery is fully depleted
P. 7 8 0■
Conditions affecting operation
P. 3 9■
Customization
Settings (e.g. unlocking function) can be changed.
(Customizable features P. 9 0 6 )
Page 52 of 956
521-2. Opening, closing and locking the doors
LX570_OM_OM60L21U_(U) Locking the driver’s door from the outside without a key
Move the inside lock button to the lock position.
Close the door.
The door cannot be locked if the “ENGINE START STOP” switch is in
ACCESSORY or IGNITION ON mode, or the electronic key is left
inside the vehicle. Depending on the position of the electronic key, the key may not be
detected correctly and the door may be locked.
Rear door child-protector lock
The door cannot be opened from
inside the vehicle when the locks
are set.
Unlock
Lock These locks can be set to prevent
children from opening the rear
doors. Push down on each rear
door switch to lock both rear
doors.STEP 1
STEP 2
Page 54 of 956
541-2. Opening, closing and locking the doors
LX570_OM_OM60L21U_(U) When the setting or canceling operat ion is complete, al l doors are locked
and then unlocked. Function Shift lever position Driver’s door lock
switch position
Shift position linked door locking
function
“P”
Shift position linked door unlocking
function
Speed linked door locking function
“N”
Driver’s door linked door unlocking
function
■
Impact detection door lock release system
In the event that the vehicle is subject to a strong impact, all the doors are unlocked.
Depending on the force of the impact or the type of accident, however, the system
may not operate. ■
Using the mechanical key
The doors can also be locked and unlocked with the mechanical key. ( P. 8 6 7 )■
Customization
Settings (e.g. unlocking function using a key) can be changed.
(Customizable features P. 9 0 6 )
Page 85 of 956

851-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L21U_(U) Using the door lock switch
Carry only the key (including the ca rd key) to which you want to link
the driving position. If 2 or more keys are in the vehicle, the driving
position cannot be linked properly.
Turn the “ENGINE START STOP” switch to OFF after closing the
driver’s door.
While pressing the desired button
(“1”, “2” or “3”), press the lock or
unlock side on the door lock
switch (either the driver or passen-
ger side) until the signal beeps. The driving position is recalled
when the driver’s door is unlocked
using the enter function or wireless
remote control and the driver’s
door is opened.STEP 1
STEP 2
■
Canceling the linked do or unlock operation
Turn the “ENGINE START STOP” switch to OFF after closing the driver’s
door.
Using the wireless remote control: While pressing “SET” button, press
button on the wireless remote control until the signal beeps.
Using the door lock switch: While pressing “SET” button, press the lock or
unlock side on the door lock switch until the signal beeps.STEP 1
STEP 2
Page 93 of 956
931-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L21U_(U) ■ Releasing and storing the third center seat belt
Push the release button on
buckle A
Push either the mechanical key
or tab A into buckle B When releasing and storing the
seat belt, hold the belt while
winding it back gently.
Put tabs A and B together and
stow them in the holder To reattach the seat belt, reverse
the above procedure, pulling
out the tabs and inserting tab B
into buckle B.STEP 1
Buckle A
Buckle BBuckle B
Ta b ASTEP 2
Ta b A Ta b BSTEP 3
Page 107 of 956
1071
Before driving
LX570_OM_OM60L21U_(U) 1-4. Opening and closing th e windows and moon roof
Power windows
Lock switch
Press the switch down to lock pas-
senger window switches. Use this switch to prevent children
from accidentally opening or clos-
ing a passenger window.The power windows can be opened and closed using the following
switches.
Closing
One-touch closing
*Opening
One-touch opening
*
*: To s t o p t h e w i n d o w p a r t w a y ,
operate the switch in the oppo-
site direction.
■
The power windows can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode. ■
Door lock linked window operation
The following functions can be used if customized at your Lexus dealer. ●
The power windows can be opened and closed using the mechanical key.
( P. 8 6 7 )●
The power windows can be opened using the wireless remote control.
( P. 4 8 )●
The power windows can be closed using the entry function. ( P. 3 6 )