Page 69 of 688

691-1. For safe use
1
For safety and security
GS350_250_OM_OM30E16E_(EE)
CAUTION
■When children are in the vehicle
Do not allow children to play with the seat belt. If the seat belt becomes twisted
around a child’s neck, it may lead to choking or other serious injuries that could
result in death.
If this occurs and the buckle cannot be unfastened, scissors should be used to cut
the belt.
■When the child restraint system is not in use
●Keep the child restraint system properly secured on the seat even if it is not in use.
Do not store the child restraint system unsecured in the passenger compartment.
●If it is necessary to detach the child restraint system, remove it from the vehicle or
store it securely in the trunk. If a head restraint was removed when installing a
child restraint system, always install the head restraint before driving. This will pre-
vent it from injuring passengers in the event of a sudden stop, sudden swerve or
accident.
GS350_250_OM_OM30E16E_(EE).book Page 69 Tuesday, July 8, 2014 7:11 PM
Page 70 of 688
701-1. For safe use
GS350_250_OM_OM30E16E_(EE)
Installing child restraints
Seat belts (An ELR belt requires a
locking clip)
ISOFIX rigid anchors
Lower anchors are provided for the
outboard rear seats. (Buttons display-
ing the location of the anchors are
attached to the seats.)
Anchor brackets (for top strap)
An anchor bracket is provided for
each rear seat.
Follow the child restraint system manufacturer’s instructions. Firmly
secure child restraints to the seats using a seat belt or ISOFIX rigid
anchors. Attach the top strap wh en installing a child restraint.
GS350_250_OM_OM30E16E_(EE).book Page 70 Tuesday, July 8, 2014 7:11 PM
Page 71 of 688
711-1. For safe use
1
For safety and security
GS350_250_OM_OM30E16E_(EE)
■Rear-facing Baby seat/child seat
Place the child restraint system
on the rear seat facing the rear
of the vehicle.
Run the seat belt through the
child restraint system and
insert the plate into the buckle.
Make sure that the belt is not
twisted.
Install a locking clip near the
tab of the lap and shoulder belt
by inserting the lap and shoul-
der webbing through the
recesses of the locking clip.
Buckle the belt again. If the
belt has any slack, release the
buckle and reinstall the locking
clip.
Installing child restraints using a seat belt
1
2
3
GS350_250_OM_OM30E16E_(EE).book Page 71 Tuesday, July 8, 2014 7:11 PM
Page 73 of 688
731-1. For safe use
1
For safety and security
GS350_250_OM_OM30E16E_(EE)
■Junior seatRemove the head restraint if it
interferes with your child
restraint system.
Place the child restraint system
on the seat facing the front of
the vehicle.
Sit the child in the child
restraint system. Fit the seat
belt to the child restraint sys-
tem according to the manufac-
turer’s instructions and insert
the plate into the buckle. Make
sure that the belt is not twisted.
Check that the shoulder belt is cor-
rectly positioned over the child’s
shoulder and that the lap belt is as
low as possible. ( →P. 3 8 )
1
2
3
GS350_250_OM_OM30E16E_(EE).book Page 73 Tuesday, July 8, 2014 7:11 PM
Page 75 of 688
751-1. For safe use
1
For safety and security
GS350_250_OM_OM30E16E_(EE)
Remove the head restraint.
Secure the child restraint system
using the seat belt or ISOFIX
rigid anchors.
Open the anchor bracket cover,
latch the hook onto the anchor
bracket and tighten the top strap.
Make sure the top strap is securely
latched.
■When installing a child restraint system
You need a locking clip to install the child restraint system. Follow the instructions
provided by the manufacturer of the system. If your child restraint system does not
provide a locking clip, you can purchase the following item from any authorized
Lexus dealer or repairer, or another duly qualified and equipped professional:
Locking clip for child restraint system
(Part No. 73119-22010)
Child restraint systems with a top strap
1
2
3
GS350_250_OM_OM30E16E_(EE).book Page 75 Tuesday, July 8, 2014 7:11 PM
Page 76 of 688

761-1. For safe use
GS350_250_OM_OM30E16E_(EE)
CAUTION
■When installing a child restraint system
Follow the directions given in the child restraint system installation manual and fix
the child restraint system securely in place.
If the child restraint system is not correctly fixed in place, the child or other passen-
gers may be seriously injured or even killed in the event of sudden braking, sudden
swerving or an accident.
●If the driver’s seat interferes with the child
restraint system and prevents it from being
attached correctly, attach the child restraint
system to the right-hand rear seat (left-
hand drive vehicles) or the left-hand rear
seat (right-hand drive vehicles).
●Adjust the front passenger seat so that it
does not interfere with the child restraint
system.
●Only put a forward-facing child restraint
system on the front seat when unavoidable.
When installing a forward-facing child
restraint system on the front passenger
seat, move the seat as far back as possible.
Failure to do so may result in death or seri-
ous injury if the airbags deploy (inflate).
GS350_250_OM_OM30E16E_(EE).book Page 76 Tuesday, July 8, 2014 7:11 PM
Page 77 of 688
771-1. For safe use
1
For safety and security
GS350_250_OM_OM30E16E_(EE)
CAUTION
■When installing a child restraint system
●Never use a rear-facing child restraint sys-
tem on the front passenger seat when the
airbag manual on-off switch is on.
(→ P. 5 6 )
The force of the rapid inflation of the front
passenger airbag can cause death or seri-
ous injury to children in the event of an
accident.
●There is a label(s) on the passenger side
sun visor, indicating it is forbidden to attach
a rear-facing child restraint system to the
front passenger seat.
Details of the label(s) are shown in the illus-
tration below.
GS350_250_OM_OM30E16E_(EE).book Page 77 Tuesday, July 8, 2014 7:11 PM
Page 78 of 688

781-1. For safe use
GS350_250_OM_OM30E16E_(EE)
CAUTION
■When installing a child restraint system
●If child restraint system regulations exist in the country where you reside, please
contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional for the child restraint system installation.
●When a junior seat is installed, always ensure that the shoulder belt is positioned
across the center of the child’s shoulder. The belt should be kept away from the
child’s neck, but not so that it could fall off the child’s shoulder. Failing to do so may
result in death or serious injury in the event of sudden braking, sudden swerving
or an accident.
●Ensure that the belt and plate are securely locked and the seat belt is not twisted.
●Shake the child restraint system left and right, and forward and backward to
ensure that it has been securely installed.
●After securing a child restraint system, never adjust the seat.
●Follow all installation instructions provided by the child restraint system manufac-
turer.
■To correctly attach a child restraint system to the anchors
When using the lower anchors, be sure that there are no foreign objects around
the anchors and that the seat belt is not caught behind the child restraint system.
Make sure the child restraint system is securely attached, or it may cause death or
serious injury to the child or other passengers in the event of sudden braking, sud-
den swerving or an accident.
GS350_250_OM_OM30E16E_(EE).book Page 78 Tuesday, July 8, 2014 7:11 PM