2014 Lexus GS250 mirror

1903-3. Adjusting the seats
GS350_250_OM_OM30E16E_(EE)
While pressing the recalled
button, press and hold the
door lock switch (either lock or
unlock) until the buzzer
sounds.
If the button could not be regis-
tered, the buzzer sounds continu-
ously for approximately 3 seconds.
■Recall procedureCarry the electronic key that has been registered to the driving posi-
tion, and then unlock and open the driver’s door using the smart
entry & start system or wireless remote control.
The driving position will move to the recorded position (not including the
steering wheel). However, the seat will move to a position slightly behind the
recorded position in order to make entering the vehicle easier.
If the driving position is in a position that has already been recorded, the seat
and outside rear view mirrors will not move.
Turn the engine switch to ACCESSORY mode or IGNITION ON
mode, or fasten a seat belt.
The seat and steering wheel will move to the recorded position.
4
1
2
GS350_250_OM_OM30E16E_(EE).book Page 190 Tuesday, July 8, 201 4 7:11 PM

195
3
3-4. Adjusting the steering wheel and mirrors
Operation of each component
GS350_250_OM_OM30E16E_(EE)
Steering wheel
Operating the switch moves the steering wheel in the following directions:
Up
Down
Toward the driver
Away from the driver
■The steering wheel can be adjusted when
The engine switch is in ACCESSORY or IGNITION ON mode
*.
*: If the driver’s seat belt is fastened, the steering wheel can be adjusted regardless ofengine switch mode.
■Automatic adjustment of the steering position
A desired steering position can be entered to memory and recalled automatically by
the driving position memory system. ( →P. 1 8 6 )
■Power easy access system
The steering wheel and driver’s seat move in accordance with engine switch mode
and the driver’s seat belt condition. ( →P. 1 8 6 )
Adjustment procedure
1
2
3
4
CAUTION
Do not adjust the steering wheel while driving.
Doing so may cause the driver to mishandle the vehicle and cause an accident,
resulting in death or serious injury.
GS350_250_OM_OM30E16E_(EE).book Page 195 Tuesday, July 8, 201 4 7:11 PM

1963-4. Adjusting the steering wheel and mirrors
GS350_250_OM_OM30E16E_(EE)
Inside rear view mirror
The height of the rear view mirror can be adjusted to suit your driving pos-
ture.
Adjust the height of the rear view
mirror by moving it up and down.
XManual anti-glare inside rear view mirror
Reflected light from the headlights of vehicles behind can be reduced by
operating the lever.
Normal position
Anti-glare position
The rear view mirror’s position can be adjusted to enable sufficient
confirmation of the rear view.
Adjusting the height of rear view mirror
Anti-glare function
1
2
GS350_250_OM_OM30E16E_(EE).book Page 196 Tuesday, July 8, 201 4 7:11 PM

1973-4. Adjusting the steering wheel and mirrors
3
Operation of each component
GS350_250_OM_OM30E16E_(EE)
XAuto anti-glare inside rear view mirror
Responding to the level of brightness of the headlights of vehicles behind,
the reflected light is automatically reduced.
Changing automatic anti-glare
function mode
ON/OFF
When the automatic anti-glare func-
tion is in ON mode, the indicator illu-
minates.
The function will set to ON mode
each time the engine switch is turned
to IGNITION ON mode.
Pressing the button turns the function
to OFF mode. (The indicator also
turns off.)
■To prevent sensor error (vehicles with auto anti-glare inside rear view mirror)
Indicator
To ensure that the sensors operate properly,
do not touch or cover them.
GS350_250_OM_OM30E16E_(EE).book Page 197 Tuesday, July 8, 201 4 7:11 PM

1983-4. Adjusting the steering wheel and mirrors
GS350_250_OM_OM30E16E_(EE)
CAUTION
Do not adjust the position of the mirror while driving.
Doing so may lead to mishandling of the vehicle and cause an accident, resulting in
death or serious injury.
NOTICE
■Rear view mirror adjustment (vehicles with LKA [Lane-Keeping Assist])
To ensure that the LKA operates properly,
make sure that it does not block the LKA
camera sensor.
GS350_250_OM_OM30E16E_(EE).book Page 198 Tuesday, July 8, 2014 7:11 PM

199
3
3-4. Adjusting the steering wheel and mirrors
Operation of each component
GS350_250_OM_OM30E16E_(EE)
Outside rear view mirrors
To select a mirror to adjust, press
the switch.
Left
Right
Pressing the same switch again will
put the switch in neutral.
To adjust the mirror, press the
switch.
Up
Right
Down
Left
Push the mirror back in the direc-
tion of the vehicle’s rear.
Adjustment procedure
1
1
2
2
1
2
3
4
Manually folding and extending the mirrors
GS350_250_OM_OM30E16E_(EE).book Page 199 Tuesday, July 8, 201 4 7:11 PM

2003-4. Adjusting the steering wheel and mirrors
GS350_250_OM_OM30E16E_(EE)
■Using the switch
Press the switch to fold the mir-
rors.
Press it again to extend them to the
original position.
■Setting automatic mode
Automatic mode allows the folding or extending of the mirrors to be
linked to locking/unlocking of the doors.
Press the “AUTO” switch to set
automatic mode.
The indicator will come on.
Pressing the switch once more will
return to manual mode.
Automatically folding and extending the mirrors (if equipped)
Indicator
GS350_250_OM_OM30E16E_(EE).book Page 200 Tuesday, July 8, 2014 7:11 PM

2013-4. Adjusting the steering wheel and mirrors
3
Operation of each component
GS350_250_OM_OM30E16E_(EE)
When either “L” or “R” of the mirror select switch is selected, the outside
rear view mirrors will automatically angle downwards when the vehicle is
reversing in order to give a better view of the ground. To disable this func-
tion, select neither “L” nor “R”.
■Adjusting the mirror angle when the vehicle is reversing
With the shift lever in R, adjust the mirror angle at a desired position.
The adjusted angle will be memorized and the mirror will automatically
tilt to the memorized angle whenever the shift lever is shifted to R from
next time.
The memorized downward tilt position of the mirror is linked to the normal
position (angle adjusted with the shift lever in other than R). Therefore, if the
normal position is changed after adjustme nt, the tilt position will also change.
When the normal position is changed, readjust the angle in reversing.
Linked mirror function when reversing
GS350_250_OM_OM30E16E_(EE).book Page 201 Tuesday, July 8, 201 4 7:11 PM