2014 Lancia Delta wheel

IN AN EMERGENCY
209
4
fig. 13
L0E0113m
REFITTING THE STANDARD WHEEL
Following the procedure described previously, raise the
car and remove the space-saver wheel.
Ve r sions with steel rims
Proceed as follows:
❍make sure the contact surfaces between standard wheel
and hub are clean so that the fastening bolts will not
come loose;
❍fit the standard wheel inserting the 4 bolts into the
holes;
❍using the spanner provided, tighten the fixing bolts;
❍press-fit the hub cap, aligning the special splining (on
the cap) with the inflation valve;
❍lower the car and remove the jack;
❍using the spanner provided, fully tighten the bolts in
the sequence shown previously.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 209

210
IN AN EMERGENCY
Ve r sions with alloy rims
❍Place the wheel onto the hub and tighten the bolts us-
ing the spanner provided;
❍lower the car and remove the jack;
❍using the spanner provided, fully tighten the bolts in
the sequence shown in fig. 8;
❍refit the press-fitted hub cap, making sure that the ref-
erence hole on the wheel is aligned with the reference
pin on the cap.
IMPORTANT If it is not fitted properly, the hub cap may
detach when the vehicle is running.
At the end of the operation
❍Stow the space-saver wheel D - fig. 10 in the space pro-
vided in the luggage compartment;
❍fit the partially open jack in i
ts box forcing it lightly to
prevent it from vibrating when travelling;
❍put the tools back into place in the box;
❍stow the container, complete with tools, in the space-
saver wheel and tighten the locking device B - fig. 10;
❍reposition the luggage compartment mat correctly.IMPORTANT Do not use air chambers tubes with tube-
less tyres. Check the inflation pressure of the tyres and the
space-saver wheel periodically.
Various fixing bolts and space-saver wheels,
specific and differing in structural charac-
teristics, are used depending on the wheel rim
type (alloy or steel). Fixing bolts for alloy rims can
be identified by the presence of a permanent wash-
er and a hollow side on the bolt head.
Therefore, you will need to contact a Lancia Deal-
ership to get the correct type of fixing bolts and
space-saver wheel if you change the type of wheels
fitted (alloy rims instead of steel rims, or vice ver-
sa). Keep the bolts fitted as standard in case of re-
use of the wheels originally mounted on the car.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 210

39
39
39
39
39
39
39
39
39
228
IN AN EMERGENCY
F43
F44
F46
F47
F48
F49
F51
F52
F53
30
15
20
20
20
5
5/7.5 (*)
15
7.5
ELECTRIC DEVICES FUSE AMPERE FIGUREWindscreen wiper system on steering column stalk, bi-directional windscreen/rear window washer electrical pump system on steering column stalk
Cigar lighter/power socket on tunnel, luggage compartment power socketSun roof motorDriver’s front electric windowPassenger side front electric window
Hazard, right, left and central control panels (lighting),
steering wheel controls (lighting), controls on front roof light
(lighting), volumetric alarm system control unit,
electric sun roof system (control unit, control lighting),
rain/dusk sensor, electro-chromic mirror, front seat heating controls, AUX socket (lighting)
Cigar lighter (lighting), radio setup,
Cruise Control system control, Blue&Me
TMnode, parking sensor node,
AQS sensor, climate control system, electric door mirror
adjustment, tyre pressure monitoring control unit, Lane assistance
node, Controlled damping suspension node, Eco button
(versions with automatic transmission), automatic transmission control
light guide, control unit on right-hand gas discharge headlightRear window wiper system on steering column stalkInstrument panel, rear direction indicators
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 228

232
IN AN EMERGENCY
When towing, remember that without the help
of the brake servo and electric power steer-
ing, a greater effort is required on the pedal
and steering wheel. Do not use flexible cables when
towing and avoid jerky movements. During towing,
make sure that the trailer hitch does not damage any
components it is touching. When towing the car, it
is compulsory to respect specific highway code reg-
ulations relating to the tow hook and procedures for
towing on the road. Do not start the engine while
towing the car. Before tightening the ring clean the
threaded housing thoroughly. Make sure that the
ring is securely fastened before towing the car.
The front and rear tow hooks must only be
used for emergency situations on the road.
The car may be towed for short distances
when a dedicated device is used in compliance with
the Highway Code (rigid bar), and in order to move
the vehicle on the road in preparation for towing
or transport via a breakdown vehicle. Tow hooks
MUST NOT be used to tow vehicles off the road or
where there are obstacles and/or for towing oper-
ations using cables or other non-rigid devices. Re-
specting the above conditions, towing must take
place with two vehicles (one towing, the other towed)
aligned as much as possible along the same centre
line.
Before towing, turn the ignition key to MAR
and then to STOP without removing it. The
steering column will automatically lock when
the key is removed and the wheels cannot be steered.
195-232 Delta GB 1ed 02/09/13 09.35 Pagina 232

MAINTENANCE AND CARE
233
Scheduled servicing ..................................................................234
Scheduled servicing plan ..........................................................235
Periodic checks.........................................................................237
Demanding use of the car..........................................................237
Checking levels ........................................................................239
Air cleaner/Pollen filter/Diesel filter..........................................243
Battery .....................................................................................244
Wheels and tyres ......................................................................247
Rubber hoses ............................................................................249
Windscreen/rear window wiper .................................................249
Bodywork ................................................................................252
Interiors ...................................................................................256
233-256 Delta GB 1ed 26/08/13 13.12 Pagina 233

REPLACING THE BATTERY
If required, replace the battery with a genuine spare part
with the same specifications.
If a battery with different specifications is fitted, the ser-
vice intervals given in the “Scheduled Servicing Plan” will
no longer be valid.
Follow the battery manufacturer’s instructions for main-
tenance.
Advanced ESP system
If the battery is disconnected, the áwarning light will
switch on (together with a message in the display) to in-
dicate that the system must be realigned. To s witch thewarning light off, carry out the following initialisation pro-
cedure:
❍turn the ignition key to MAR:
❍turn the steering wheel fully both clockwise and anti-
clockwise (to move from the position with the wheels
straight);
❍turn the ignition key to STOP and then to MAR.
If the áwarning light does not go out after a few seconds,
go to a Lancia Dealership. 244
MAINTENANCE AND CARE
Battery fluid is poisonous and corrosive.
Avoid contact with skin and eyes. Keep naked
flames or possible sources of sparks away
from the battery: risk of explosion or fire.Using the battery when the fluid is too low
can damage it irreparably and generate a
risk of explosion.
BATTERYThe car is fitted with a low-maintenance battery F - fig.
1: no electrolyte top-ups with distilled water are needed
in standard conditions of use.
It does need to be checked regularly at a Lancia Dealer-
ship or by specialised personnel to make sure that it is
working properly.
233-256 Delta GB 1ed 26/08/13 13.13 Pagina 244

WHEELS AND TYRESCheck the pressure of each tyre, including the space-saver
wheel, approximately every two weeks and before long
journeys: the pressure should be checked with the tyre rest-
ed and cold.
It is normal for the pressure to increase as the car is used;
see the “Wheels” paragraph in chapter “6” for the correct
tyre inflation pressure.
Incorrect pressure causes abnormal tyre wear fig. 2:
A normal pressure: tread evenly worn.
B low pressure: tread particularly worn at the edges.
Chigh pressure: tread particularly worn in the centre.
The tyres must be replaced when the tread is less than 1.6
mm thick. In any case, follow the laws in force in the coun-
try you are in.
fig. 2
L0E0096m
IMPORTANT
❍Where possible, avoid braking suddenly, wheel-spin-
ning and crashing into curbs, potholes or other ob-
stacles. Driving for long stretches over bumpy roads
can damage the tyres;
❍check the tyres regularly for cuts on the sides, swellings
or irregular tread wear. Go to a Lancia Dealership if
required.
❍avoid overloading the car when travelling: this may
cause serious damage to the wheels and tyres;
❍if a tyre is punctured, stop immediately and change it
to avoid damage to the tyre, wheel rim, suspension and
steering system;
❍the tyre ages even if rarely used. Cracks in the tread and
on the side walls are a sign of ageing
. Have the tyres
checked by specialised personnel if they have been fit-
ted for longer than 6 years. Remember to check the
space-saver wheel very carefully;
❍when replacing the tyres, always fit new tyres, avoid-
ing those of dubious origin;
MAINTENANCE AND CARE
247
233-256 Delta GB 1ed 26/08/13 13.13 Pagina 247

248
MAINTENANCE AND CARE
❍if a tyre is replaced, you should also change the infla-
tion valve;
❍to allow even wear between the front and rear tyres,
it is advisable to change them over every 10-15 thou-
sand kilometres, keeping them on the same side of the
car so as not to reverse the direction of rotation.
Remember that the road holding qualities of
your car also depend on the correct inflation
pressure of the tyres. If the pressure is too low the tyre will get
overheated, with the risk of serious damage
to the tyre.
Avoid moving the tyres from the right side of
the vehicle to the left side and vice versa.Do not repaint alloy wheel rims at temper-
atures higher than 150°C. The mechanical
specifications of the wheels might be ad-
versely affected.
233-256 Delta GB 1ed 26/08/13 13.13 Pagina 248