2014 JEEP GRAND CHEROKEE display

NOTE:You can insert the double-sided emergency key
into the lock cylinders with either side up.
Ignition Or Accessory On Message
Opening the driver’s door when the ignition is in ACC or
ON (engine not running), a chime will sound to remind
you to cycle the ignition to OFF. In addition to the chime,
the ignition or accessory on message will display in the
cluster.
NOTE: With the Uconnect® system, the power window
switches, radio, power sunroof (if equipped), and power
outlets will remain active for up to 10 minutes after the
ignition is cycled to the OFF position. Opening either
front door will cancel this feature. The time for this
feature is programmable. Refer to “Uconnect® Settings”
in “Understanding Your Instrument Panel” for further
information.
WARNING!
• When leaving the vehicle, always remove the Key
Fob from the vehicle and lock your vehicle.
• Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
• Allowing children to be in a vehicle unattended is
dangerous for a number of reasons. A child or
others could be seriously or fatally injured. Chil-
dren should be warned not to touch the parking
brake, brake pedal or the shift lever.
• Do not leave the Key Fob in or near the vehicle, or
in a location accessible to children, and do not
leave the ignition of a vehicle equipped with
Keyless Enter-N-Go™ in the ACC or ON/RUN
mode. A child could operate power windows, other
controls, or move the vehicle.
(Continued)
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

•System not disabled from previous remote start event
• Vehicle security alarm not active
WARNING!
•Do not start or run an engine in a closed garage or
confined area. Exhaust gas contains Carbon Mon-
oxide (CO) which is odorless and colorless. Carbon
Monoxide is poisonous and can cause serious in-
jury or death when inhaled.
• Keep Remote Keyless Entry (RKE) transmitters
away from children. Operation of the Remote Start
System, windows, door locks or other controls
could cause serious injury or death.
Remote Start Abort Message On Electronic Vehicle
Information Center (EVIC) — If Equipped
The following messages will display in the EVIC if the
vehicle fails to remote start or exits remote start prema-
turely:
• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood Ajar
• Remote Start Aborted — Fuel Low
• Remote Start Aborted — System Fault
• Remote Start Disabled — Start Vehicle to Reset
The EVIC message stays active until the ignition is turned
to the ON/RUN position.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29

To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release
the UNLOCK button on the RKE transmitter to unlock
the doors and disarm the Vehicle Security Alarm System
(if equipped). Then, prior to the end of the 15 minute
cycle, press and release the START/STOP button.
NOTE:“Remote Start Active — Push Start Button” will
display in the EVIC until you press the start button. Refer
to “Electronic Vehicle Information Center (EVIC)” for
further information.
Remote Start Comfort Systems — If Equipped
When remote start is activated, the heated steering wheel
and driver heated seat features will automatically turn on
in cold weather. In warm weather, the driver vented seat
feature will automatically turn on when the remote start
is activated. These features will stay on through the
duration of remote start or until the ignition switch is
turned to the ON/RUN position.
The Remote Start Comfort System can be activated and
deactivated through the Uconnect® System. For more
information on Remote Start Comfort System operation
refer to “Uconnect® Settings” in “Understanding Your
Instrument Panel”.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 31

▫Overtake Aid ....................... .210
▫ ACC Operation at Stop .................210
▫ Adaptive Cruise Control (ACC) Menu .......211
▫ Display Warnings And Maintenance ........212
▫ Precautions While Driving With ACC .......215
▫ General Information ...................219
▫ Normal (Fixed Speed) Cruise Control Mode . . .219
 FORWARD COLLISION WARNING (FCW)
WITH MITIGATION — IF EQUIPPED .......223
▫ Forward Collision Warning (FCW) With
Mitigation Operation ...................223
▫ Turning FCW ON Or OFF ...............225
▫ Changing FCW And Active Braking Status. . . .226
▫ FCW Limited Warning ..................227 ▫
Service FCW Warning ..................228
 PARKSENSE® REAR PARK ASSIST —
IF EQUIPPED ........................ .228
▫ ParkSense® Sensors ....................228
▫ ParkSense® Warning Display .............229
▫ ParkSense® Display ....................229
▫ Enabling And Disabling ParkSense® ........233
▫ Service The ParkSense® Rear Park Assist
System ............................ .233
▫ Cleaning The ParkSense® System ..........234
▫ ParkSense® System Usage Precautions .......234
 PARKSENSE® FRONT AND REAR PARK
ASSIST — IF EQUIPPED .................237
▫ ParkSense® Sensors ....................237
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 121

▫ParkSense® Warning Display .............238
▫ ParkSense® Display ....................238
▫ Enabling And Disabling ParkSense® ........242
▫ Service The ParkSense® Park Assist System . . .243
▫ Cleaning The ParkSense® System ..........244
▫ ParkSense® System Usage Precautions .......244
 PARKVIEW® REAR BACK UP CAMERA —
IF EQUIPPED ........................ .247
▫ Turning ParkView® On Or Off —
With Uconnect® 5.0 ....................249
▫ Turning ParkView® On Or Off —
With Uconnect® 8.4A/8.4AN .............249
 OVERHEAD CONSOLE ..................250
▫ Front Map/Reading Lights ..............250▫
Courtesy Lights ...................... .251
▫ Sunglasses Bin Door ...................252
 GARAGE DOOR OPENER — IF EQUIPPED . . .252
▫ Before You Begin Programming HomeLink® . .254
▫ Programming A Rolling Code .............254
▫ Programming A Non-Rolling Code .........257
▫ Canadian/Gate Operator Programming ......258
▫ Using HomeLink® ....................259
▫ Security ........................... .259
▫ Troubleshooting Tips ...................260
▫ General Information ....................261
 POWER SUNROOF — IF EQUIPPED ........262
▫ Opening Sunroof — Express ..............263
122 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

WARNING!(Continued)
•The 9-1-1 Call system is embedded into the vehi-
cle’s electrical system. Do not add aftermarket
electrical equipment to the vehicle’s electrical sys-
tem. This may prevent your vehicle from sending a
signal to initiate an emergency call. To avoid inter-
ference that can cause the 9-1-1 Call system to fail,
never add aftermarket equipment (e.g., two-way
mobile radio, CB radio, data recorder, etc.) to your
vehicle’s electrical system or modify the antennas
on your vehicle.
• Modifications to any part of the 9-1-1 Call system
could cause the air bag system to fail when you
need it. You could be injured if the air bag system
is not there to help protect you. 9-1-1 Call System Limitations
Vehicles sold in Canada and Mexico
DO NOThave 9-1-1
Call system capabilities.
9-1-1 or other emergency line operators in Canada and
Mexico may not answer or respond to 9-1-1 system calls.
If the 9-1-1 Call system detects a malfunction, any of the
following may occur at the time the malfunction is
detected, and at the beginning of each ignition cycle:
•
The Rearview Mirror light located between the Assist
and 9-1-1 buttons will continuously be illuminated red.
• The Phone Screen will display the following message
“Vehicle phone requires service. Please contact your
dealer.”
• An In-Vehicle Audio message will state “Vehicle phone
requires service. Please contact your dealer.”
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 129

NOTE:The engine must be running for the heated seats
to operate.
Vehicles Equipped with Remote Start
On models that are equipped with remote start, the
driver ’s heated seat and heated steering wheel can be
programmed to come on during a remote start. Refer to
“Remote Starting System — If Equipped” in “Things To
Know Before Starting Your Vehicle” for further informa-
tion.
Front Heated Seats With Uconnect® 5.0 —
If Equipped
There are two heated seat switches that allow the driver
and passenger to operate the seats independently. The
controls for each heater are located in the Uconnect®
system screen.
You can choose from HIGH, LOW or OFF heat settings. Press the “Climate” hard-key located on the right side of
the Uconnect® display.
Touch the “Driver” or “Passenger” seat soft-key once to
select HI-level heating. Touch the soft-key a second time
to select LO-level heating. Touch the soft-key a third time
to shut the heating elements OFF.
Heated Seats Soft-Keys
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 153

NOTE:Once a heat setting is selected, heat will be felt
within two to five minutes.
When the HI-level setting is selected, the heater will
provide a boosted heat level during the first four minutes
of operation. Then, the heat output will drop to the
normal HI-level. If the HI-level setting is selected, the
system will automatically switch to LO-level after ap-
proximately 60 minutes of continuous operation. At that
time, the display will change from HI to LO, indicating
the change. The LO-level setting will turn OFF automati-
cally after approximately 45 minutes.
Front Heated Seats With Uconnect® 8.4A/8.4AN —
If Equipped
There are two heated seat soft-keys that allow the driver
and passenger to operate the seats independently. The
controls for each heater are located in the Uconnect®
system screen. Touch the “Controls” soft-key located on the bottom of
the Uconnect® display.
Touch the “Driver” or “Passenger” seat soft-key once to
select HI-level heating. Touch the soft-key a second time
to select LO-level heating. Touch the soft-key a third time
to shut the heating elements OFF.
Heated Seats Soft-Keys
154 UNDERSTANDING THE FEATURES OF YOUR VEHICLE