Seat Adjustments
To slide the seat forward or backward, push the
control switch
01 forward or backward.
To recline the seatback, push the switch
02
forward or backward.
SEAT LIFTER
To adjust the angle of the front seat cushion or height
of the seat, push the front or rear end of the switch
01 up or down.
POWER LUMBAR SUPPORT (driver’s seat)
To adjust the seat lumbar support, push the front or back end of the swi\
tch 03 .
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (se\
ction 1)” of your
Owner’s Manual.
01
02
010203
Trunk Lid Release
Use one of the following methods to open the trunk:
Push the trunk open request switch
01 for more
than one second while carrying the INFINITI
Intelligent Key with you.
Press the trunk button hOLD on the Intelligent Key for
more than one second.
Push down on the trunk lid
release switch
02
located on the instrument panel to the left of the
steering wheel.
For more information, refer to the “Pre-driving checks and adjustments
(section 3)” of your Owner’s Manual.
5
1276473_14a_Q60_Convertible_QRG_062113.indd 56/21/13 3:31 PM
6
first drive features
Seat Belt Guide (Convertible models)
Unsnap the seat belt guide 01 to allow rear seat passengers easier access.
Before fastening the seat belt, ensure the seat belt is
inserted into the seat belt guide and the snaps are
securely fastened.
When using the seat belt guide, do not allow the seat
belt to twist so that it will retract correctly.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)”\
of your Owner’s Manual.
Automatic Drive Positioner (if so equipped)
Two positions for the driver’s seat, steering column
and outside mirrors can be stored in the automatic
drive positioner memory.
Follow these procedures to set the memory positions:
•
Confirm the shift lever is in the
P (PA rk ) position
(automatic transmissions) or the parking brake is applied (manual tra\
nsmissions).
•
Push the ignition switch to the
ON position.
•
Adjust the driver’s seat, steering column and outside mirrors to the \
desired positions using
the adjusting switches for each feature.
•
Push the SE
t switch and within 5 seconds, push the memory switch (1 or 2) for at least 1 second.
•
The indicator light on the memory switch you select will illuminate for \
approximately 5 seconds.
•
The driver’s seat, steering column and outside mirror positions are n\
ow set to your preference.
These memorized positions can also be linked to your INFINITI Intelligen\
t Key.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Passenger Rear Seat Entry/Exit
For ease in entering and exiting the rear passenger
areas of the vehicle, perform the following steps:
1.
Release the front seatbelt guide and seat belt.
(Convertible models)
2.
Pull the seatback lever 01 upward to fold the
front seatback forward. Make sure that the front
seatback is completely folded.
3.
To slide the front seat forward, firmly push
the seatback button
02. The front seat will
move forward.
To stop the front seat from sliding, press the seatback button 02 again. To return the front seat to its original position:
1.
Push or pull the seatback backward until it locks in place.
2.
Press the seatback button 02 to slide the front seat backward.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (se\
ction 1)” of your
Owner’s Manual.
Coupe
Convertible
01
01
02
02
01
1276473_14a_Q60_Convertible_QRG_062113.indd 66/21/13 3:31 PM
