2014 FORD FOCUS lock

Engine Information
Item Description
ConfigurationTransverse mounted I4, cast
aluminum cylinder block and
cylinder heads
Bore x Stroke87.5 mm bore x 83.1 mm stroke
(3.44 in. x 3.27 in.)
Displacement1999 cubic centimeters
(122 cubic inches)
Compression ratio9.3:1
Horsepower252 hp @ 5500 RPM on 93 octane
243 hp @ 5500 RPM on 87 octane
Torque270 lb-ft @ 2500 RPM on
93 octane
270 lb-ft @ 2500 RPM on
87 octane
Redline6500 RPM continuous
6800 RPM 3-second overspeed
Specific output126 horsepower per liter
ValvetrainTwin independent variable cam
timing
IgnitionCoil-on-plug
Fuel system150 bar fuel pump
Throttle body57 mm (2.2 in.)
PistonsCast aluminum
CrankshaftCast iron
Connecting rodsForged steel
TurboSingle scroll / 21 psi max boost*
Exhaust system63 mm (2.5 in.) diameter
* SAE Certified Performance ratings are achieved with 19.5 psi, but up
to 21 psi can be delivered to maximize power depending on fuel quality
and atmospheric conditions.
Focus ST Unique Features
8
2014 Focus ST(stf)
Supplement, 1st Printing, June 2013
USA(fus)

MANUAL 6-SPEED TRANSMISSION OPERATION
Using the Clutch
Note:During each shift, the clutch pedal must be fully pressed to the
floor and the accelerator fully released. Failure to follow this may cause
increased shift efforts, prematurely wear transmission components, or
cause gear clash or damage to the transmission. Make sure the floor mat
is properly positioned so it does not interfere with the full extension of
the clutch pedal.
Note:If you attempt to shift when the drive wheels are spinning with a
loss of traction, it is possible to cause damage to the transmission. Do
not attempt to shift when the drive wheels do not have traction.
Note:Do not drive with your foot resting on the clutch pedal or use the
clutch pedal to hold your vehicle at a standstill while waiting on a hill.
These actions will reduce the life of the clutch and could nullify a clutch
warranty claim.
Your vehicle is equipped with a twin disc clutch. Due to the high
performance of the powertrain, a certain amount of noise from the
transmission is normal.
The manual transmission has a starter interlock that prevents cranking
the engine unless the clutch pedal is fully pressed.
To start the vehicle:
1. Make sure the parking brake is fully set.
2. Press the clutch pedal to the floor, then put the transmission selector
lever in positionN.
3. Start the engine, then press the brake pedal and release the parking
brake.
4. Move the transmission selector lever to position1, then slowly release
the clutch pedal while slowly pressing on the accelerator.
Driving Your Focus ST
10
2014 Focus ST(stf)
Supplement, 1st Printing, June 2013
USA(fus)

5. To engage reverse, lift up on the reverse lockout ring located under
the shift knob and move the transmission selector lever fully to the left
and forward.
Recommended Shift Speeds for Maximum Fuel Economy
When accelerating, upshift according to the following chart:
Shift from:
1 - 2 12 mph (19 km/h)
2 - 3 23 mph (37 km/h)
3 - 4 32 mph (51 km/h)
4 - 5 41 mph (66 km/h)
5 - 6 42 mph (67 km/h)
Operating at High Speeds
Your ST vehicle is capable of high speeds and is equipped with tires
rated for the vehicle’s maximum speed. Remember to drive safely, obey
all traffic laws and only operate your ST vehicle at high speeds at
locations equipped and designed to do so safely. Before operating your
vehicle at high speeds:
•Verify correct tire pressures (seeTiresin this supplement).
•Inspect wheels and tires for wear and damage. Replace any damaged
wheels or tires.
•Do not operate your vehicle at high speeds with more than two
passengers or while carrying cargo.
ADVANCETRAC® STABILITY ENHANCEMENT SYSTEM
The AdvanceTrac® system includes traction control and electronic
stability control. See theTraction ControlandStability Control
chapters of theOwner’s Manualfor more information
AdvanceTrac® provides three
modes of operation specially
calibrated for the Focus ST. These
are controlled through the
AdvanceTrac® button on the center
console.
ESC OFF
Driving Your Focus ST
11
2014 Focus ST(stf)
Supplement, 1st Printing, June 2013
USA(fus)

WRECKER TOWING
If you need to have your vehicle towed, contact your roadside assistance
center or a professional towing service.
It is recommended that your vehicle be towed with a wheel lift and
dollies or with flatbed equipment. When towing with a flatbed,4x4
blocks may help prevent damage when loading or unloading your vehicle.
Do not tow with a slingbelt. Ford Motor Company has not approved a
slingbelt towing procedure.
Note:If the vehicle is towed by other means or incorrectly, vehicle
damage may occur.
Roadside Emergencies
18
2014 Focus ST(stf)
Supplement, 1st Printing, June 2013
USA(fus)