
231
DS3_en_Chap10_info-pratiques_ed01-2014
batteryProcedure for charging your battery when it is flat or for starting the engine using another battery.T he battery is located under the bonnet.
To
gain access to it:
F
o
pen the bonnet using the interior release
l
ever, then the exterior safety catch,
F
s
ecure the bonnet stay,
F
l
ift the plastic cover on the (+) terminal.
Access to the batteryAfter refitting the battery by a CITRoË N dealer or a qualified
workshop,
the Stop & Start system
w
ill only be active after a continuous
period
of immobilisation of the vehicle,
a
period which depends on the climatic
c
onditions and the state of charge of
t
he battery (up to about 8 hours).
The presence of this label, in particular
with
the
Stop
&
Start
system,
indicates
t
he use of a 12 V lead-acid battery with
special
t
echnology
a
nd
s
pecification;
t
he
involvement
of
a
CITROËN
dealer
o
r
a
qualified
workshop
is
essential
w
hen
replacing
or
disconnecting
the
b
attery.
Failure
t
o
o
bserve
t
his
r
ecommendation
m
ay
cause
premature
wear
of
the
b
attery.
Practical information

DS3_en_Chap10_info-pratiques_ed01-2014
Energy economy modeSystem which manages the period of use of certain functions to conserve a sufficient level of charge in the battery.
A fter the engine has stopped, you can still use functions such as the audio equipment, windscreen wipers, dipped beam headlamps, courtesy lamps,
e
tc. for a maximum combined period of thirty minutes.
This
period may be greatly reduced if
t
he battery is not fully charged.
A
flat battery prevents the engine from
s
tarting (refer to the corresponding
par
agraph).
If
the telephone is being used at the
s
ame time on the eMyWay audio
n
avigation system, it will be interrupted
a
fter 10 minutes.
Switching to economy mode
Once this period has elapsed, a message appears on the multifunction screen indicating
t
hat the vehicle has switched to economy mode
a
nd the active functions are put on standby.
Exiting economy mode
These functions are reactivated automatically the next time the vehicle is driven.
F
I
n order to resume the use of these
f
unctions immediately, start the engine and
l
et it run for a few minutes.
The
time available to you will then be double
t
he period for which the engine is left running.
H
owever, this period will always be between
five
and thirty minutes.

DS3_en_Chap10_info-pratiques_ed01-2014
Towing the vehicleProcedure for having your vehicle towed or for towing another vehicle using a removable towing eye.
T he towing eye is installed in the boot under
t
he floor.
To
gain access to it:
F
o
pen the boot,
F
r
aise the floor,
F
r
emove the polystyrene storage box,
F
r
emove the towing eye from the holder.
Access to the tools General recommendations
Observe the legislation in force in your country.
E nsure that the weight of the towing vehicle is higher than that of the towed vehicle.
The
driver must remain at the wheel of the towed vehicle and must have a valid driving licence.
When
towing a vehicle with all four wheels on the ground, always use an approved towing
a
rm; rope and straps are prohibited.
The
towing vehicle must move off gently.
When
towing a vehicle with the engine off, there is no longer any power assistance for
b
raking or steering.
In
the following cases, you must always call on a professional recovery service:
-
v
ehicle broken down on a motor way or fast road,
-
f
our-wheel drive vehicle,
-
w
hen it is not possible to put the gearbox into neutral, unlock the steering, or release
t
he parking brake,
-
t
owing with only two wheels on the ground,
-
w
here there is no approved towing arm available...

DS3_en_Chap10_info-pratiques_ed01-2014
Towing a trailer
Towbar suitable for the attachment of a trailer with a dditional l ighting an d s ignalling. We
recommend the use of genuine
C
ITR
oË
N towbars and their harnesses
that have been tested and approved
from the design stage of your vehicle,
a
nd that the fitting of the towbar is
e
ntrusted to a CITR
oË
N dealer or a
qualified
w
orkshop.
If the towbar is not fitted by a CITR
oË
N
dealer, it is imperative that it is
f
itted in accordance with the vehicle
manufacturer's
i
nstructions.
Driving with a trailer places greater demands
o
n the towing vehicle and the driver must take
par
ticular
c
are.
driving advice
distribution of loads
F Distribute the load in the trailer so that the heaviest items are as close as possible to t
he axle and the nose weight approaches the
m
aximum permitted without exceeding it.
ai
r density decreases with altitude, thus
reducing
engine per formance. Above
1
000 metres, the maximum towed load must
b
e reduced by 10 % for every 1 000 metres of
al
titude.
Side wind
F Take into account the increased sensitivity t
o side wind.
Your
vehicle
is
primarily
designed
for
t
ransporting
people
and
luggage,
but
it
may
a
lso
be
used
for
towing
a
trailer. Refer to the "Technical Data" section for details
of the weights and towed loads which apply to
y
our vehicle.

239
DS3_en_Chap10_info-pratiques_ed01-2014
RAcING towbar
Your vehicle cannot be fitted with a
towbar. The space occupied by the
s
port diffuser prevents this.
Ty r e s
F Check the tyre pressures of the towing v
ehicle and of the trailer, observing the
re
commended
p
ressures.
cooling
Towing a trailer on a slope increases the temperature of the coolant.
As
the fan is electrically controlled, its cooling
c
apacity is not dependent on the engine speed.
F
T
o lower the engine speed, reduce your
s
peed.
The
maximum towed load on a long incline
d
epends on the gradient and the ambient
t
emperature.
In
all cases, keep a check on the coolant
t
emperature.
Braking
Towing a trailer increases the braking distance.
T o avoid overheating of the brakes on a long
m
ountain type of descent, the use of engine
b
raking is recommended.
Lighting
F Check the electrical lighting and signalling o
n the trailer.
The
rear parking sensors will be
d
eactivated automatically if a genuine
C
ITROËN towbar is used.
F
I
f
the
warning
lamp
and
the
S
TOP
warning
lamp
come
on,
s
top the vehicle and switch off
the
engine
as
soon
as
possible.
Practical information

DS3_en_Chap10_info-pratiques_ed01-2014
Matt paintWe recommend the use of a high pressure jet wash, or at least a water hose with a high
o
utput.
We
recommend that the vehicle be rinsed using
d
e-ionised
w
ater.
Use
only a microfibre cloth to dry the vehicle.
I
t must be clean and used without heavy
p
ressure.
Lightly
wipe off any fuel stains present on the
b
odywork using a soft cloth, then leave to dry.
From
the range of cleaning and maintenance
p
roducts in the "TECHNATURE" range
r
ecommended and approved by CITROËN,
u
se only the insect remover and car shampoo,
w
hich are the only products to be used on the
bodywork.
The
insect remover can also be used to remove
m
inor marks (for example: finger marks...).
al
ways have paint repairs done by a CITR
oË
N
dealer
or a qualified workshop.
Recommendations
on
the
care
and
maintenance
your
vehicle
are
given
in
the
maintenance
and
warranty guide.
Never
clean
the
vehicle
without
water.
Never wash your vehicle in an
automatic
roller
brush
car
wash.
Never polish the vehicle body, nor the
alloy
wheels.
Doing
this
will
make
the
pa
intwork
sh
iny.
Do not use paint cleaners, abrasive
products
or
paint
polishing
or
p
reserving
products
(such
as
wax,
f
or
example)
on
the
paintwork.
These
p
roducts
are
only
suitable
for
bright
f
inishes.
Application
of
these
products
o
n
vehicles
with
a
matt
finish
will
s
eriously
damage
the
paint
sur face
of
t
he
vehicle,
giving
rise
to
irreversible
s
hiny
or
stained
areas.
Never
use
a
high
pressure
jet
wash
w
ith a lance fitted with a brush, this
may
scratch
the
paintwork.
Never
select
a
wash
programme
that
f
inishes
with
a
hot
wax
cycle.
Advice on care and maintenance
If you vehicle is finished with a clear matt l acquer, please observe the following
r
ecommendations to avoid damaging the
p
aintwork by the use of an inappropriate
c
leaning
pro
cedures.
These
recommendations are also valid for alloy
r
oad wheels finished with clear matt lacquer.

241
DS3_en_Chap10_info-pratiques_ed01-2014
Leather
Leather is a natural product. Appropriate regular care and cleaning is essential for its
du
rability.
Refer
to your vehicle's maintenance
a
nd warranty guide for information on
t
he special precautions to observe.
care of the expressive
stickers
These styling stickers are treated to give good resistance to ageing and tearing.
They
have been designed to allow you to
c
ustomise your vehicle's bodywork.
Available
also as accessories, we recommend
t
hat you have them fitted by a CITROËN dealer
o
r a qualified workshop.
When
using a high pressure jet wash, keep the
e
nd of the lance at least 30 centimetres from
t
he stickers
Practical information

DS3_en_Chap10_info-pratiques_ed01-2014
A wide range of accessories and genuine parts is available from the CITROËN dealer network.
T hese accessories and parts are all suitable for your vehicle and benefit from CITROËN's recommendation and warranty.
accessories
"comfort":
sun blinds, air deflectors, isotherm module, ashtray, fragrance cartridges, coat hanger fixed
t
o head restraint, front centre armrest, movable
m
irror, reading lamp, front and rear parking
s
ensors...
"Transport solutions":
boot liner, boot spacers, boot carpet, boot net,
transverse roof bars, bicycle carrier, ski carrier,
r
oof boxes, towbars, towbar wiring harnesses...
"Styling":
full grain leather steering wheel, coloured and carbotech dashboards, coloured and leather
gear
lever knobs, aluminium footrest, spoiler,
a
lloy wheels, coloured wheel trims, coloured
w
heel caps, exterior expressive stickers,
e
xterior chrome kit, LED rear lamps kit...
*
T
o avoid any risk of jamming of the pedals:
-
e
nsure that the mat is positioned and
s
ecured correctly,
-
n
ever fit one mat on top of another.
"Security and safety":
anti-intrusion alarm, wheel security devices, vehicle tracking system, breathalyser, first aid
k
it, warning triangle, high visibility safety vest,
c
hild seats, snow chains, non-skid covers, fire
e
xtinguisher, pet seat belt, ...
"Protection":
mats*, mudflaps, seat covers, vehicle covers, bumper p rotectors...
When
fitting
a
towbar
outside
the
C
ITROËN
dealer
network,
the
i
nstallation
must
be
done
using
the
v
ehicle's
electrical
pre-equipment
and
f
ollowing
the
vehicle
manufacturer's
r
ecommendations.