2014 Citroen C4 CACTUS RHD Owner's Manual

55
Boot
Opening
F After unlocking the boot (see the "Remote control key" section), press the opening
control and raise the tailgate. F
L ower the tailgate using the interior grab
handle.
Closing Boot release
Unlocking
F Fold the rear seat backrest to gain access
to the lock from inside the boot.
F

I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
System for mechanical unlocking of the boot
in the event of a battery or central locking
malfunction.
If the tailgate is not fully closed:
-
e
ngine running
, a message appears in
the screen,
-

v

ehicle moving , a message appears in
the screen, accompanied by an audible
signal.
2
Access

56
Front electric window controls
The electric window switches
remain operational for approximately
45 seconds after the ignition is
switched off or until a front door
is opened. If, during this period of
45
seconds, you open a door while
operating a window, the window stops.
The window switch will then only be
operative after the ignition is switched
on again.
1.
F

ront left electric window switch.
2.
F

ront right electric window switch.
F

P

ress the switch to open the window.
F

P

ull the switch to close the window.
The window stops when you release the switch. Always remove the key from the ignition
when leaving the vehicle, even for a
short time.
In the event of contact during operation
of the windows, reverse the movement
of the window. To do this, press the
corresponding switch.
When the driver operates the
passenger electric window switch, they
should ensure that no one is preventing
correct closing of the window.
The driver should ensure that the
passenger uses the electric window
c o r r e c t l y.
Be particularly aware of children when
operating the windows.
Access

57
Rear door windows
OpeningClosing
F Tilt the lever outwards.
F
P ush it fully to secure the window in the
open position. F

P
ull the lever to release the window.
F
T
ilt the lever fully inwards to secure the
window in the closed position.
Each window can be hinged open to provide ventilation at the rear seats.
2
Access

58
Front seats
F Raise the control A and slide the seat forwards or backwards. F
P ull the control C upwards to raise the seat
or push it downwards to lower it, as many
times as required, to obtain the desired
position.
F
T urn the knob B to adjust the backrest.
Forwards-backwards
Height
Seat backrest angle
Adjustments
(driver only)
As a safety measure, adjustments to the driver's seat must only be done when stationary.
Comfort

59
F To raise the head restraint, pull it upwards.
F T o remove the head restraint, press the
lug
A and pull the head restraint upwards.
F

T
o put the head restraint back in place,
engage the head restraint stems in the
openings keeping them in line with the seat
back.
F

T
o lower the head restraint, press the lug A
and the head restraint at the same time. The head restraint has a frame with
notches which prevents it from lowering;
this is a safety device in case of impact.
The adjustment is correct when the
upper edge of the head restraint is
level with the top of the head.
Never drive with the head restraints
removed; they must be in place and
adjusted correctly.
Head restraint height
3
Comfort

60
Folding the backrestRepositioning the seat backrest
F Straighten the seat backrest 2 and secure it.
F

U
nfasten and return the seat belts to the
sides of the backrest.
F
M
ove the front seats for ward if necessary.
F
P
osition the seat belts on the backrest and
buckle them.
F

P

lace the head restraints in the low
position. F
P
ress both controls 1 simultaneously to
release the seat backrest 2 .
F

F

old the seat backrest 2 on to the cushion.
When repositioning the backrest,
ensure that the seat belts are not
trapped and the red indicator, located
next to the controls 1, is no longer
visible.
Rear seatsBench seat with fixed one-piece cushion and folding one-piece backrest.
When folding the seat, the centre seat
belt should not be buckled but laid out
flat on the seat.
Comfort

61
Rear head restraints
They can be removed and are interchangeable
side to side.
To remove a head restraint:
F
P
ull the head restraint upwards to the stop.
F

T
hen, press the lug A . Never drive with the head restraints
removed; they must be in place and
adjusted to the normal position (up).
These have one position for use (up) and a
stowed position (down).
To refit a head restraint:
F

E
ngage the head restraint rods in the
apertures, keeping the head restraint in line
with the seat backrest.
To lower a head restraint:
F

P
ress down on the head restraint and on
lug A at the same time.
3
Comfort

62
Mirrors
Each fitted with an adjustable mirror glass
providing the lateral rear ward vision necessary
for overtaking or parking. They can also be
folded for parking in confined spaces.
Door mirrors
Demisting - Defrosting
F Move control A to the right or to the left to select the corresponding mirror.
F

M
ove control in all four directions to adjust.
F

R
eturn control to the central position. Demisting-defrosting of the door
mirrors operates with the engine
running, by switching on the heated
rear screen.
Electric adjustment
The objects observed are, in reality,
closer than they appear.
Take this into account in order to
correctly judge the distance of vehicles
approaching from behind.
Manual folding
You can fold the mirrors manually (tight parking
space, narrow garage...).
F

T
urn the mirror towards the vehicle.
As a safety measure, the mirrors should
be adjusted to reduce the "blind spots". For more information on demisting and
defrosting the rear screen, refer to the
corresponding section.
Comfort