Page 205 of 368
203
7
Practical information
Removing a front or rear
wiper blade
)
Raise the corresponding wiper arm.
)
Remove the wiper blade, sliding it towards
the outside.
Changing a wiper
blade
Fitting a front or rear wiper
blade
)
At the front, check the size of the wiper
blade as the shorter blade is fitted on the
right-hand side of the vehicle.
)
Put the corresponding new wiper blade in
place and fix it.
)
Fold down the wiper arm carefully.
Automatic power cut-off to accessories
After the engine has stopped, when the
ignition switch is in the "ACC" position
(or the vehicle in "ACC" mode)
you
can still use functions such as the audio
equipment, windscreen wipers, dipped beam
headlamps, courtesy lamps, etc. for about
thirty minutes.
Cutting off
Once the thirty minutes have expired, the
power supply to the accessories will be
automatically cut off.
Restoring power
The power supply will be restored the next time
the ignition is switched on.
Page 220 of 368
218
Checks
Running out of fuel (Diesel)
On vehicles fitted with the 1.6 litre HDi 110
engine, the fuel system must be manually
primed if you run out of fuel; refer to the
corresponding Diesel engine compartment
view.
1.6 litre HDi engine
)
Fill the fuel tank with at least five litres of
diesel.
)
Open the bonnet.
)
If necessary, unclip the styling cover for
access to the priming pump.
)
Squeeze and release the priming pump
repeatedly until resistance is felt (there
may be resistance at the first press).
)
Operate the starter until the engine starts
(if the engine does not start at the first
attempt, wait around 15 seconds before
trying again).
)
If the engine does not start after a few
attempts, operate the priming pump again
then start the engine.
)
Clip the styling cover back in place.
)
Close the bonnet.
Page 221 of 368
219
8
Checks
Checking levels
Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns) and the cooling fan could start at
any time (even with the ignition off).
Oil level
The check of the the level is done
out with the dipstick, located under
the bonnet. Refer to the description
of your engine compartment for the
position of the dipstick.
Engine oil change
Refer to the maintenance and warranty guide
for details of the inter val for this operation.
In order to maintain the reliability of the engine
and emission control system, the use of
additives in the engine oil is prohibited.
Oil specifi cation
The oil must be the correct grade for your
engine and conform to the manufacturer's
recommendations.
Check all of these levels regularly, in line with the maintenance and warranty guide. Top them up if necessary, unless other wise indicated.
If a level drops significantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.
Dipstick
There are two marks on the dipstick:
A
= maximum
If the level is above this
mark, contact a CITROËN
dealer or a qualified
workshop.
B
= minimum
Top up the level through the
oil filler orifice, using the
correct grade of oil for your
engine. The level must never
be below this mark.
This check will only be correct if the vehicle is
on level ground and the engine has been off for
more than 30 minutes.
It is normal to top up the oil level between
two ser vices (or oil changes). CITROËN
recommends that you check the level, and top
up if necessary, every 3 000 miles (5 000 km).
After topping up the oil, the check when
switching on the ignition with the oil level
indicator in the instrument panel is not valid
during the 30 minutes after topping up.
Page 227 of 368
9
225
Te c h n i c a l d a t a
*
The maximum power corresponds to the value type-approved on a test bed, under conditions defined in European legislation (Directive 1999/99/EC).
Engines and gearboxes
.../S
: model fitted with the Stop & Start (AS&G) function.
PETROL ENGINES
1.6 litre 115
2.0 litre 150
Model codes
:
BU
...
NKZ7
NKZ7/S
NKZ0
NKZ0/S
AFYR
AFZ7
AFYV
AFZM
AFYT
AFZH
AFYW
AFZP
Tr a n s m i s s i o n m o d e
2WD
2WD
4WD
2WD
4WD
Cubic capacity (cc)
1 590
1 998
Bore x stroke (mm)
75 x 90
86 x 86
Max power * : EU standard (kW)
86
113
Max power engine speed (rpm)
6 000
6 000
Max torque: EU standard (Nm)
15 4
19 9
Max torque engine speed (rpm)
4 000
4 200
Fuel
Unleaded
Unleaded
Catalytic conver ter
Ye s
Ye s
GEARBOXES
Manual
(5-speed)
Manual
(5-speed)
CVT
(6-speed)
OIL CAPACITY (in litres)
Engine (with filter replacement)
4.2
4.3
Page 234 of 368
232
Te c h n i c a l d a t a
*
The maximum power corresponds to the value type-approved on a test bed, under conditions defined in European legislation (Directive 1999/99/EC).
DIESEL ENGINES
1.6 HDi 110
1.8 HDi 150
Model codes :
BU...
9HD8/S
9HDB/S
6HZ8/S
6HZB
6HZB/S
Tr a n s m i s s i o n m o d e
2WD
4WD
2WD
4WD
Cubic capacity (cc)
1 560
1 798
Bore x stroke (mm)
77 x 88.3
83 x 83.1
Max power * : EU standard (kW)
84
11 0
Max power engine speed (rpm)
3 600
4 000
Max torque: EU standard (Nm)
270
300
Max torque engine speed (rpm)
1 750
2 000 to 3 000
Fuel
Diesel
Diesel
Catalytic conver ter
Ye s
Ye s
Particle emission filter (PEF)
Ye s
Ye s
GEARBOXES
Manual
(6-speed)
Manual
(6-speed)
OIL CAPACITY (in litres)
Engine (with filter replacement)
3.75
5.3
Engines and gearboxes
.../S
: model fitted with the Stop & Start (AS&G) function.
Page 252 of 368
250
BLUETOOTH ®
TELEPHONE
WITH VOICE RECOGNITION
The system has its own phone book, independent of that of the
mobile telephone.
It can contain up to 32 names for each language.
Each name in the phone book is associated with 4 locations:
HOME, WORK, MOBILE and PAGER.
The system says " Select one of the following items: New Entry,
Change, List of names, Delete or Clear all, or say Cancel to
return to the main menu
".
Say " New entry
".
The system says " HOME, WORK, MOBILE OR PAGER
".
Give the location which corresponds to the number that
you wish to record.
The system asks you to confi rm the location.
Answer " Ye s
".
Say " No
" to return to step 7.
If a telephone number has already been recorded for this location,
the system says " The current number is -number-, number
please
".
Saving a name in the system phone book
Press this button.
Say " Phone book
".
The system says " Name please
".
Give the name of your choice.
If you do not wish to change the telephone number, repeat
the original number to retain it, otherwise say the new
number.
Answer " Ye s
".
Say " No
" to return to step 11.
The system asks you to confi rm the number.
Page 253 of 368
251
BLUETOOTH ®
TELEPHONE
WITH VOICE RECOGNITION
Say " Cal
l
".
The system says " Name please
".
Using a name in the system phone book
Give the name of the person that you wish to call.
Press this button.
Give the location corresponding to the number that you
wish to call.
You must have fi rst paired a compatible Bluetooth
®
mobile
telephone with the system.
If several telephone numbers have been recorded for this person,
the system says " Do you wish to call {home}, {work},
{mobile} or {pager}?
"
The system request confi rmation of the name.
Answer " Ye s
".
Say " No
" to return to step 4.
The system says " Call to at
" and makes the
call.
Page 285 of 368
283
05
Connecting APPLE ®
players
Connect the Apple ®
player to the USB port using a suitable cable
(not supplied).
Play starts automatically.
Control is via the audio system.
The classifi cations available are those of the portable device
connected (artists / albums / genres / playlists / audiobooks /
podcasts).
The default classifi cation used is by artist. To modify the classifi cation
used, return to the fi rst level of the menu then select the desired
classifi cation (playlists for example) and confi rm to go down through
the menu to the desired track.
The "Shuffl e tracks" mode on an iPod
®
corresponds to the "Random"
mode on the audio system.
The "Shuffl e albums" mode on an iPod
®
corresponds to the "Random
all" on the audio system.
"Shuffl e tracks" is restored by default on each connection.
The version of software in the audio system may not be compatible
with the generation of your Apple
® player.
MUSIC
