2014 CHRYSLER 200 CONVERTIBLE headlight bulb

Turn Signals
Move the multifunction lever up or down and the arrows
on each side of the instrument cluster flash to show
proper operation of the front and rear turn signal lights.NOTE:
If either light remains on and does not flash, or
there is a very fast flash rate, check for a defective outside
light bulb. If an indicator fails to light when the lever is
moved, it would suggest that the indicator bulb is
defective.
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off.
High/Low Beam Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
toward you to switch the headlights back to low beam.
Turn Signal Control
180 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

18. Park/Headlight ON Indicator — If EquippedThis indicator will illuminate when the park
lights or headlights are turned on.
19. Electronic Stability Control (ESC) OFF Indicator
Light — If Equipped This light indicates the Electronic Stability Con-
trol system (ESC) has been turned off by the
driver.
20. Turn Signal Indicators
The left or right arrow will flash with the corre-
sponding exterior turn signal lights when the turn
signal lever is operated. A chime will sound if the vehicle is
driven more than 1 mile (1.6 km) with either turn signal on.
NOTE: If either indicator flashes at a rapid rate, check
for a defective outside light bulb. 21. Front Fog Light Indicator — If Equipped
This indicator will illuminate when the front fog
lights are on.
22. Vehicle Security Light — If Equipped
This light will flash rapidly for approximately
16 seconds when the alarm system is arming.
The light will begin to flash slowly indicating
that the system is armed. The light will stop
flashing when the vehicle is disarmed.
23. Anti-Lock Brake (ABS) Light — If Equipped
This light monitors the ABS. This light will
come on when the ignition key is turned to the
ON/RUN position and may stay on for ap-
proximately three seconds.
If the ABS light remains on or comes on during driving,
it indicates that the Anti-Lock portion of the brake system
is not functioning and that service is required, however,
4
UNDERSTANDING YOUR INSTRUMENT PANEL 227

Introduction..............................4
Jacking Instructions ....................... .402
Jack Location ........................... .400
Jack Operation .......................... .400
Jump Starting ............................411
Key-In Reminder ..........................15
Keyless Entry System .......................21
Key, Programming .........................17
Key, Replacement ..........................16
Keys ...................................12
Key, Sentry (Immobilizer) ....................15
Knee Bolster ..............................57
Lane Change and Turn Signals ................227
Lane Change Assist ....................... .180
Lap/Shoulder Belts .........................44
Latches .................................96 Hood
............................... .175
Latch Plate ...............................45
Lead Free Gasoline ....................... .370
Leaks, Fluid ..............................96
Life of Tires ............................ .358
Light Bulbs ..............................96
Lights ..................................96
Airbag ................................63
Back-Up ............................. .475
Battery Saver ......................... .184
Brake Assist Warning ....................336
Brake Warning ........................ .221
Bulb Replacement ...................... .471
Courtesy/Reading ..................... .183
Daytime Running ...................... .182
Dimmer Switch, Headlight .................180
Electronic Stability Program (ESP) Indicator .....336
Engine Temperature Warning ...............220
Exterior ...............................96
508 INDEX