2014 BMW ACTIVE HYBRID 5 headlight bulb

Malfunction
In the event of a failure or malfunction of the
parking brake, secure the vehicle against roll‐
ing using a wheel chock, e.g., when leaving it.
After a power failure
Putting the parking brake into
operation1.Switch on the ignition.2. Press the reel while stepping on the
brake pedal or selector lever position P is
set.
It may take several seconds for the brake to be
put into operation. Any sounds associated with
this are normal.
The indicator lamp in the instrument
cluster goes out as soon as the parking
brake is ready for operation.
Turn signal, high beams,
headlight flasher
Turn signal
Hints Do not adjust the exterior mirrors
Do not adjust the exterior mirror while
driving and when blinker/hazards are on, or
else the additional blinker lights in the exterior
mirror are out of position and can't be seen.◀
Using turn signals
Press the lever beyond the resistance point.
To reel off manually, press the lever to the re‐
sistance point.
Unusually rapid flashing of the indicator lamp
indicates that a turn signal bulb has failed.
Triple turn signal activation Press the lever to the resistance point.
The turn signal flashes three times.
The function can be activated or deactivated.
On the Control Display:
1."Settings"2."Lighting"3."Triple turn signal"
Settings are stored for the profile currently in
use.
Signaling briefly
Press the lever to the resistance point and hold
it there for as long as you want the turn signal
to flash.
Seite 78ControlsDriving78
Online Edition for Part no. 01 40 2 956 272 - X/14

Reduce your speed and stop cautiously. Avoid
sudden braking and steering maneuvers.
For more information, see Flat Tire Monitor, re‐
fer to page 114.
Tire Pressure Monitor TPM Illuminated: the Tire Pressure Monitor
signals a loss of tire inflation pressure
in a tire.
Reduce your speed and stop cautiously. Avoid
sudden braking and steering maneuvers.
Flashing and then continuously illuminated: no
flat tire or loss of tire inflation pressure can be
detected.▷Interference through systems or devices
with the same radio frequency: after leav‐
ing the area of the interference, the system
automatically becomes active again.▷RDC could not conclude the reset: perform
the reset of the system again.▷A wheel without TPM electronics is fitted:
have the service center check it if needed.▷Malfunction: have the system checked by
your service center.
For more information, see Tire Pressure Moni‐
tor, refer to page 110.
Steering system Steering system in some cases defec‐
tive.
Have the steering system checked by
the service center.
Engine functions Have the vehicle checked by the serv‐ice center.
For additional information, refer to On-
board Diagnostics socket, refer to page 213.
Lane departure warning
System is switched on and under cer‐
tain circumstances warns if a detected
lane is left without flashing beforehand.
For additional information, refer to Lane depar‐
ture warning, refer to page 128.
Green lights Turn signal Turn signal on.
Unusually rapid flashing of the indicator
lamp indicates that a turn signal bulb
has failed.
For additional information, refer to Turn signal,
refer to page 78.
Parking lights, headlight control Parking lights or headlights are acti‐
vated.
For additional information, refer to
Parking lights/low beams, headlight control, re‐
fer to page 102.
Front fog lights Front fog lights are activated.
For additional information, refer to
Front fog lights, refer to page 105.
High-beam Assistant High-beam Assistant is switched on.
High beams are activated and off auto‐
matically as a function of the traffic sit‐
uation.
For additional information, refer to High-beam
Assistant, refer to page 104.Seite 90ControlsDisplays90
Online Edition for Part no. 01 40 2 956 272 - X/14

the service center if you are unfamiliar those or
if they have not been described here.
You can obtain a selection of replacement
bulbs at the service center.
Danger of burns
Only change bulbs when they are cool;
otherwise, there is a danger of getting
burned.◀
Working on the lighting system
When working on the lighting system,
you should always reel off the lights affected to
prevent short circuits.
To avoid possible injury or equipment damage
when replacing bulbs, observe any instructions
provided by the bulb manufacturer.◀
Do not perform work/bulb replacement
on xenon headlights
Have any work on the xenon lighting system,
including bulb replacement, performed only by
a service center. Due to the high voltage
present in the system, there is a danger of fatal
injuries if work is carried out improperly.◀
Do not touch the bulbs
Do not touch the glass of new bulbs with
your bare hands, as even minute amounts of
contamination will burn into the bulb's surface
and reduce its service life.
Use a clean tissue, cloth or something similar,
or hold the bulb by its base.◀
Light-emitting diodes (LEDs)
Some items of equipment use light-emitting
diodes installed behind a cover as a light
source.
These light-emitting diodes, which are related
to conventional lasers, are officially designated as Class 1 light-emitting diodes.Do not remove the covers
Do not remove the covers, and never
stare into the unfiltered light for several hours;
otherwise, irritation of the retina could result.◀
Headlight glass
Condensation can form on the inside of the ex‐
ternal lights in cool or humid weather. When
driving with the light switched on, the conden‐
sation evaporates after a short time. The head‐
light glass does not need to be changed.
If the headlights do not dim despite driving
with the light switched on, increasing humidity
forms, e. g. water droplets in the light, have the service center check this.
Headlight setting The headlight adjustments can be affected by
changing lights and bulbs. Have the head‐
lights' settings checked and corrected by serv‐
ice after a replacement.
Front lights, bulb replacement
Xenon headlights
At a glance1Corner-illuminating lights2Parking lamp, daytime running lights3Low beams/high beams4Turn signalSeite 216MobilityReplacing components216
Online Edition for Part no. 01 40 2 956 272 - X/14

Hints
Because of the long life of these bulbs, the
likelihood of failure is very low. Switching the
lights on and off frequently shortens their life.
If a bulb fails, reel on the front fog lights and
continue the trip with great care. Comply with
local regulations.
Do not perform work/bulb replacement
on xenon headlights
Have any work on the xenon lighting system,
including bulb replacement, performed only by
a service center. Due to the high voltage
present in the system, there is a danger of fatal
injuries if work is carried out improperly.◀
For checking and adjusting headlamp aim,
please contact your BMW center.
Parking lights and roadside parking lamp
Follow general instructions, refer to page 215.
These lights feature LED technology.
Contact your service center in the event of a
malfunction.
Accessing the bulbs
Remove the screws and fold down the lid.
Turn signal
Follow general instructions, refer to page 215.
The illustration shows the left side of the en‐
gine compartment.
24-watt bulb, PY.
Unscrew the lid, remove it, and change the
bulb.
Corner-illuminating lights
Follow general instructions, refer to page 215.
The illustration shows the left side of the en‐
gine compartment.
55-watt bulb, H7.
1.Fold open the cover in the engine compart‐
ment.2.Unscrew the lid and remove it.Seite 217Replacing componentsMobility217
Online Edition for Part no. 01 40 2 956 272 - X/14

3.Unscrew the bulb holder counterclockwise.4.Remove the bulb and replace it.5.Insert the new bulb and attach the cover in
the reverse order.
LED headlights
At a glance
1Corner-illuminating lights2Low beams/high beams3Parking lamp, daytime running lights4Turn signal5Side marker lights
Light-emitting diodes (LEDs)
With LED headlights, all front lights and side
indicators are designed with LED technology.
If an LED fails, reel on the front fog lights and
continue the trip with great care. Comply with
local regulations.
Contact your service center in the event of a
malfunction.
LED front fog lights
These front fog lights are made using LED
technology. Contact your service center in the
event of a malfunction.
Turn signal in exterior mirror The turn signals in the exterior mirrors feature
LED technology. Contact your service center in the event of a malfunction.
Tail lights, bulb replacement
At a glance1Turn signal2Reversing lamp3Inside brake lamp4Rear lamp5Outside brake lamp6Rear reflector
Turn signal, outer brake, tail, and
license plate lights
Follow general instructions, refer to page 215.
These lights feature LED technology.
Contact your service center in the event of a
malfunction.
Seite 218MobilityReplacing components218
Online Edition for Part no. 01 40 2 956 272 - X/14

Language on Control Dis‐play 99
Lashing eyes, securing cargo 186
LATCH child restraint sys‐ tem 68
Leather, care 229
LED front fog lights, bulb re‐ placement 218
LED headlights, Bulb replace‐ ment 218
LED light 218
LEDs, light-emitting di‐ odes 216
Length, vehicle 234
Letters and numbers, enter‐ ing 24
License plate lamp, bulb re‐ placement 218
Light alloy wheels, care 230
Light control 103
Light-emitting diodes, LEDs 216
Lighter, front 170
Lighter, rear 171
Lighting 102
Lighting, speaker 106
Lighting via remote con‐ trol 40
Light reel 102
Lights 102
Lights and bulbs 215
Load 186
Loading 185
Lock, door 41
Locking/unlocking via door lock 41
Locking/unlocking with re‐ mote control 39
Locking, automatic 48
Locking, settings 48
Locking via trunk lid 42
Lock, power window 51
Locks, doors, and win‐ dows 70
Low beams 102 Low beams, automatic, refer
to High-beam Assistant 104
Lower back support 57
Luggage rack, see Roof- mounted luggage rack 186
Lumbar support 57
M
Maintenance 213
Maintenance require‐ ments 213
Maintenance, service require‐ ments 93
Maintenance system, BMW 213
Make-up mirror 170
Malfunction displays, see Check Control 88
Manual air distribution 161
Manual air flow 161
Manual brake, refer to Parking brake 75
Manual mode, Steptronic transmission 83
Manual operation, door lock 41
Manual operation, exterior mirrors 64
Manual operation, fuel filler flap 194
Manual operation, Park Dis‐ tance Control PDC 149
Manual operation, rearview camera 151
Manual operation, Side View 154
Manual operation, Top View 155
Marking on approved tires 203
Marking, run-flat tires 204
Massage seat, front 58
Master key, refer to Remote control 36
Maximum cooling 162 Maximum speed, display 94
Maximum speed, winter tires 204
Measure, units of 100
Medical kit 223
Memory for seat, mirrors, steering wheel 63
Menu in instrument clus‐ ter 96
Menus, operating, iDrive 18
Menus, refer to iDrive operat‐ ing concept 19
Messages, see Check Con‐ trol 88
Microfilter 163
Minimum tread, tires 202
Mirror 64
Mirror memory 63
Mobile communication devi‐ ces in the vehicle 182
Modifications, technical, refer to Safety 7
Moisture in headlight 216
Monitor, refer to Control Dis‐ play 18
Mounting of child restraint systems 67
Multifunction steering wheel, buttons 14
N Navigation, see user's manual for Navigation, Entertain‐
ment and Communication
Neck restraints, front, refer to Head restraints 60
Neck restraints, rear, refer to Head restraints 62
Neutral cleaner, see wheel cleaner 230
New wheels and tires 203
Night Vision 124
Night Vision device, see Night Vision 124 Seite 241Everything from A to ZReference241
Online Edition for Part no. 01 40 2 956 272 - X/14

V
Vanity mirror 170
Vehicle battery 220
Vehicle battery, replac‐ ing 220
Vehicle, break-in 180
Vehicle care 229
Vehicle features and op‐ tions 6
Vehicle identification num‐ ber 10
Vehicle jack 220
Vehicle paint 229
Vehicle storage 231
Vehicle wash 228
Ventilation 163
Venting, see ventilation 163
Vent, see ventilation 163
VIN, see vehicle identification number 10
Voice activation system 26
W Warning and indicator lamps, see Check Control 88
Warning displays, see Check Control 88
Warning messages, see Check Control 88
Warning triangle 223
Washer fluid 81
Washer fluid reservoir, ca‐ pacity 235
Washer nozzles, wind‐ shield 80
Washer system 79
Washing, vehicle 228
Water, hybrid system 227
Water on roads 183
Weights 235
Welcome lights 102
What to do after an acci‐ dent 227
Wheel base, vehicle 234 Wheel cleaner 230
Wheels, changing 203
Wheels, everything on wheels and tires 198
Wheels, Flat Tire Monitor FTM 114
Wheels, Tire Pressure Moni‐ tor TPM 110
Width, vehicle 234
Window defroster, rear 162
Windows, powered 50
Windshield, climate con‐ trol 182
Windshield washer fluid 81
Windshield washer noz‐ zles 80
Windshield washer sys‐ tem 79
Windshield wiper 79
Winter storage, care 231
Winter tires, suitable tires 204
Winter tires, tread 202
Wiper 79
Wiper blades, replacing 215
Wiper fluid 81
Wiper, fold-out position 80
Wiper system 79
Wood, care 230
Word match concept, naviga‐ tion 24
Working on the hybrid sys‐ tem 226
Wrench, see Onboard vehicle tool kit 215
X
Xenon headlights, bulb re‐ placement 216 Seite 245Everything from A to ZReference245
Online Edition for Part no. 01 40 2 956 272 - X/14