2014 AUDI A5 CABRIOLET spare wheel

24 4 What do I do no w?
There are some restrictions on the use of the
compact spare tire. The compact spare tire
has been des igned specifically for your type of
vehicle.
It must not be swapped with a com­
pact spare tire from another type of vehicle.
Sno w cha in s
For technical reasons, the use of snow chains
on the compact spare tire is
n ot permitted .
If you do have to dr ive with snow cha ins and a
front tire fails, mount the spare wheel w ith
tire instead of a rear tire. Install the snow
chains on the rear tire and use it to rep lace
the defective front tire.
A WARNING
- Never use the spare tire if it is damaged
or if it is worn down to the tread wear in­
dicators.
- If the spare tire is more than 6 years o ld,
use it only in an emergency and w ith ex­
t reme caution and careful driving.
- The spare tire is intended only for tem­
porary and short-term use. It should be
replaced as soon as possib le w ith the
normal wheel and t ire.
- After mounting the compact spare tire, the tire pressu re must be checked as
soon as poss ible. The tire pressure of the
c ompac t spare tire must be 4.2 bar; oth­
erwise, you risk hav ing an accident.
- Do not drive faster than 50 mph (80 km/
h). You risk having an acc ident.
- Avoid full-throttle acce le rat ion, heavy
braking, and fast corner ing . Yo u risk hav­
ing an acc iden t.
- Never drive us ing more than one spare
wheel and tire. You risk having an acci­
dent.
- No rma l summer or winte r tires m ust not
be mounted on the compact spare whee l
rim.
- F or te chni cal reasons, the use of ti re
chains on the spare tire is not permitte d.
If it is necessary to drive with tire chains,
the spare whee l must be mounted on the
front axle in the event o f a f lat in a rear tire. The new
ly available front wheel
must then be installed in place of the
rear whee l with the flat tire. Installing
the t ire cha in before mounting the whee l
and tire is recommended .
- Loose items in the passenger compart­
ment can cause serious personal injury
during hard brak ing or in an accident.
Never store the spa re tire or jack and
too ls in the passenger compa rtment.
Changing a wheel
Before changing a wheel
Observe the following precautions for your
own and your passenger's safety when chang­
ing a wheel .
"'After you expe rience a tire failure, pull the
car we ll away from moving traffic and try to
reach
le vel ground before you stop ¢ ,&.
"'All passengers should leave the car and
move to a safe location (for instance, behind
the guardrail)¢ &,.
"' Engage the
parking brake to p revent your
veh icle from rolling unintentionally¢&, .
"' Move the
selec tor lever to the P positi on.
"'I f you are towing a t railer : unhitch t he trai l­
er from you r vehicle.
"' Take the
jack ¢ page 243 and the spare tire
¢ page 243 out of the luggage compart­
ment .
A WARNING
=
You or your passengers could be injured
while changing a wheel if you do not fo l­
l ow these safety precaut ions :
- If you have a flat tire, move a safe dis­
tance off the road . Turn off the engine ,
turn the eme rgency flashers on and use
other warning devices to a le rt other mo­
torists.
- Make sure that passengers wait in a safe
place away from th e vehicle and well
away from the road and traffi c.
- To help prevent the vehicle from moving
-
suddenly a nd possib ly slipping off the ..,_

jack, always fully set the parking brake
and block the wheel diagonally opposite
the wheel being changed with the fold­
ing chocks o r other objects. When one
front wheel is lifted off the ground, plac­
ing the Automat ic Transm iss ion in "P"
(Park) wi ll
not prevent the vehicle from
moving.
- Before you change a wheel, be sure the
ground is level and firm. If necessary,
use a st urdy board under the jack.
- Always store the vehicle tool kit, the
jack* and the repla ced ti re in the l uggage
compartment
¢ page 12 7.
(D Note
If you are chang ing the wheel on a steep
incline, use a rock or similar object to
block the opposite wheel to prevent the
ve hicl e from mov ing.
(l) Tips
Obey a ll laws.
Changing a wheel
When you change a wheel, follow these­
quence described below step-by-step and in
exactly tha t order .
1. Remove the dec orative whe el co ver* or
the
wh eel b olt cap s* . Fo r mor e details see
a lso
¢ page 245, Decorative wheel cov­
ers
or¢ page 246, Wheels with wheel
bolt caps.
2 . Loosen the wheel bo lts ¢ page 246.
3. Locate the proper mounting po int for the
jack and align the jack below that point
c::> page247.
4. Lift the car with the jack c::> page 247 .
5. Remove the wheel with th e flat tire and
then install the
s pare tir e c::> page 248 .
6. Tighten all wh eel bo lts light ly .
7.
Low er the ve hicle wit h the ja ck.
8. Use the wheel bolt wrenc h and
firmly
tighten a ll whee l bolts in a cr isscross pa t­
tern ¢
page 246.
What do I do now ? 245
9. Replace the decorative wheel co ver* or
the
wheel bolt caps*.
A WARNING
Always read and fo llow all WARNINGS and
i n format ion
c::> .&. in Raising the vehicle on
page 247
and c::> page 249.
After changing a wheel
A wheel change is not complete without the
doing the following.
.,. Always store the vehicle tool kit, the jack*,
and the replaced tire in the luggage com­
partment
c::> page 12 7 .
.,. Check the tire pressu re of the spare tire as
soon as possible .
.,. As soon as poss ib le, have the
t ightening
torqu es
on all wheel bolts checked with a
t orque wrench. The co rrect tighte ning tor­
que is
90 ft lbs. (120 Nm).
.,. Have the fla t tire
repl ace d as soon as possi­
b le.
(D Tips
- If you not ice tha t the wheel bo lts a re
c orroded and difficult to turn while
chang ing a tire, they shou ld be replaced
before you c heck the tightening torque.
- Drive at reduced speed until you have the tightening torques checked .
Decorative wheel covers
Applies to vehicles: wit h deco rat ive w hee l covers
The decorative wheel covers must be removed
first to access the wheel bolts .
Fig. 19 0 C ha ngi ng a w heel : re moving the w hee l cove r ...

248 What do I do now?
(D Note
Do not lift the vehicle by the sil l. Position
the vehicle jack only at the designated lift­
ing points on the sill. Otherwise, your vehi­
cle will be damaged.
Taking the wheel off/installing the spare
tire
Follow these instructions step -by -step for
changing the wheel .
Fig. 195 Chang ing a w hee l: u sing t he screwdriver han ­
dle (with the blade removed) to turn th e bo lts
Fig . 196 Chan ging a w hee l: al ig nm en t pi n inside the
top hole
After you have loosened a ll wheel bolts and
raised the vehicle off the ground, remove and
replace the wheel as follows:
Removing the wheel
.. Remove the topmost wheel bolt completely
with the
hexagonal socket in the screwdr iv­
er hand le (vehicle tool kit)
c::>fig. 195 and
set it aside on a
clean surface.
.. Screw the threaded end of the
alignment
pin
from the tool kit hand -tight into the
empty bolt hole
c::> fig . 196.
.. Then remove the other wheel bo lts as de­
scribed above. ..
Take off the wheel leaving the alignment pin
in the bolt hole
c::> (D.
Putting on the spare tire
.. Push the spare tire over the alignment pin.
.. Screw on the wheel bolts and tighten them
slightly using the hexagonal socket .
.. Remove the alignment pin and insert and
tighten the remaining wheel bolt slightly
like the rest.
.. Turn the jack handle counter-clockwise to
lower the vehicle until the jack is fully re­
leased .
.. Use the wheel bolt wrench to tighten all
wheel bo lts firm ly
c::> page 246 . Tighten
them
in a crisscross pattern, from one bolt
to the (approximately) opposite one, to keep
the wheel centered .
.. Perform the steps required after changing
the wheel
c::> page 245, After changing a
wheel.
The hexagonal socket makes it easier to re­
move the wheel bolts from the rim. Care
should be taken when removing the reversible
blade .
(D Note
When removing or installing the wheel,
the rim cou ld hit the brake rotor and dam­
age the rotor. Work carefu lly and have a
second person to help you.
(@ Tips
- When mounting tires with
unidirectional
tread design
make sure the tread pat­
tern is po inted the right way
c::> page 249.
- The wheel bolts should be clean and easy
to turn. Check for dirt and corrosion on
the mating surfaces of both the wheel
and the hub. Remove all d irt from these
surfaces before remounting the wheel.
- Do not use the hexagonal socket in the
screwdriver handle to loosen or t ighten
the whee l bolts .

Tires with unidirectional tread design
Tires with unidirectional tread design must be
mounted with their tread pattern pointed in the right direction.
Using a sp are t ire w ith a tread p attern
int ended fo r use in a specific dir ection
When us ing a spare tire w ith a tread pattern
in tended for use in a specific direction, please
note the following:
- The direction of rotation is marked by an
a r­
ro w o n th e side o f th e tire .
-If the spare t ire has to be installed in the in­
correct direction, use the spare tire only
temporarily since the ti re will not be able to
achieve its optimum performance character­
i st ics with rega rd to aquaplaning, noise and
wear.
- We recommend that you pay particular at­
tent ion to this fact du ring wet weathe r and
that you adjust your speed to match road conditions.
- Replace the fla t tire w ith a new one and
have it installed on your veh icle as soon as
possib le to restore the handling advantages
of a unid irectiona l tire .
Notes on wheel changing
Please read the information c:> page 233, New
tires and replacing tires and wheels
i f you are
going to use a spare t ire which is different
from the tires on your veh icle.
After you change a tire :
-Check the tir e p re ss ure on the spare imme ­
di ately after in st a ll at ion.
- Have th e wheel b olt ti ghtenin g torqu e
ch ecked with a t orque wrench as soon as
possible by your autho riz ed Audi dealer o r
qu alified work shop .
- With ste el a nd all oy wh eel rims , the wheel
bolts are correc tly tighten ed at a torque of
90 ft lb s. (120 Nm ).
- If yo u n otice that the wheel bolt s are cor­
r oded a nd d ifficult to tu rn whil e changi ng
a t ire, the y should be replaced be fore you
chec k the t igh tening to rque. What do I do now? 249
- Repla ce the flat ti re w ith a new one and
h av e it i nsta lled on you r veh icle as s oon as
po ssible. Remount the whe el cov er.
Un til th en, d riv e with extr a care and at re­
duc ed sp eeds.
A WARNING
-
- If you are going to equ ip your vehicle
with tires or rims which differ from those
which were factory installed, then be
sure to read the information
c:> page 233,
New tires and replacing tires and
wheels.
- Always make sure the damaged wheel or
even a flat tire and the jack and tool kit
are properly secured in the luggage com­
pa rtment and are not loose in the pas­
senger compartment.
- In an accident or sudden maneuver they
could fly forward, injuring anyone in the
veh icle.
- Always sto re damaged wheel, jack and
too ls se curely in the luggage compa rt­
ment. Otherwise, in an accident or su d­
den maneuver they could f ly forward,
causing injury to passengers in the vehi­
cle.
([) Note
Do not use comme rcially ava ilab le tire
sea lants. Otherwise, the e lectrica l compo­
nents of the tire pressure monitoring sys­
tem* wi ll no longer work properly and the
sensor for the tire pressure monitoring
system* will have to be replaced by quali­
fied workshop. •
•