2014.5 Citroen C4 ESP

255
Charging the battery using
a battery charger
F Disconnect   the   battery   from   the   vehicle.
F  F ollow   the   instructions   for   use   provided   by  
t

he   manufacturer   of   the   charger.
F
 
C
onnect   the   battery   starting   with   the  
n

egative   terminal   (-).
F
 
C
heck   that   the   terminals   and   connectors  
a

re   clean.   If   they   are   covered  
w
ith
 s
ulphate
 (

whitish   or   greenish   deposit),   remove   them  
a

nd   clean   them.
Reinitialisation after
reconnection
after any reconnection of the battery, switch on
the  ignition   and   wait   at   least   one   minute   before  
s

tarting,   to   allow   time   for   the   initialisation   of   the  
e

lectronic   systems.
By
  referring   to   the   corresponding   sections,   you  
s

hould   set   or   initialise   the   following   systems  
y

ourself:
-
 
o
ne-touch   electric   windows,
-
 
t
ime   and   date,
-
 
a
udio   and   navigation   system   settings.
Check
  that   no   alert   message   or   warning   lamp  
c

omes   on   after   switching   on   the   ignition.
However,
  if   minor   problems   persist   after  
c

arrying   out   these   operations,   contact   a  
C

ITROËN   dealer   or   a   qualified   workshop.
Reconnecting the (+) cable
F Position  the   open   clamp   E of the cable on
the   positive   post   (+)   of   the   battery.
F
 
P
ress   vertically   on   the   clamp   E to position
it
  correctly   on   the   battery.
F
 
L
ock   the   clamp   by   spreading   the  
p

ositioning   lug   and   then   lowering   the   tab   D.
Disconnecting the (+) cable
F Raise   the   locking   tab   D fully to release the
cable t erminal c lamp E.
D
o   not   apply   excessive   force   on   the  
t

ab   as   locking   will   not   be   possible   if   the  
c

lamp   is   not   positioned   correctly;   start  
t

he   procedure   again. With
  Stop   &   Start,   the   battery   does   not  
h

ave   to   be   disconnected   for   charging.
11
Practical information

256
Load reduction modeE nergy ec onomy m ode
Switching to economy mode
Once this period has elapsed, a message a
ppears   in   the   screen   indicating   that   the  
v

ehicle   has   switched   to   economy   mode   and   the  
a

ctive   functions   are   put   on   standby.
Exiting economy mode
These functions are reactivated automatically the   next   time   the   vehicle   is   driven.
F
 
I
n   order   to   resume   the   use   of   these  
f

unctions   immediately,   start   the   engine   and  
l

et   it   run   for   a   few   minutes.
The
  time   available   to   you   will   then   be   double  
t

he   period   for   which   the   engine   is   left   running.  
H

owever,   this   period   will   always   be   between  
f

ive   and   thirty   minutes.
System
 
which
 
manages
 
the
 
use
 
of
 
certain
 
f

unctions
 
according
 
to
 
the
 
level
 
of
 
charge
 
r

emaining
 
in
 
the
 
battery.
When
 
the
 
vehicle
 
is
 
being
 
driven,
 
the
 
load
 
r

eduction
 
function
 
temporarily
 
deactivates
 
c

ertain
 
functions,
 
such
 
as
 
the
 
air
 
conditioning,
 
t

he
 
heated
 
rear
 
screen...
The
 
deactivated
 
functions
 
are
 
reactivated
 
a

utomatically
 
as
 
soon
 
as
 
conditions
 
permit. System
 
which
 
manages
 
the
 
period
 
of
 
use
 
of
 
certain
  functions   to   conserve   a   sufficient   level   of  
c

harge
 
in
 
the
 
battery.
After
 
the
 
engine
 
has
 
stopped,
 
you
 
can
 
still
 
use
 
functions   such   as   the   audio   equipment,   windscreen  
w

ipers,
 
dipped
 
beam
 
headlamps,
 
courtesy
 
lamps,
 
etc.   for
 a m
aximum
 c
ombined
 p
eriod
 o
f  
t

hirty minutes.
A  flat   battery   prevents   the   engine   from  
s

tarting   (refer   to   the   corresponding  
par

agraph).
This
 
period
 
may
 
be
 
greatly
 
reduced
 
if
 
t

he
 
battery
 
is
 
not
 
fully
 
charged.
If
 
the
 
telephone
 
is
 
being
 
used
 
at
 
the
 
s

ame
 
time
 
on
 
the
 
navigation
 
system,
 i

t
 
w

ill
 
be
 
interrupted
 
after
 
1

0
 m

inutes.
Practical information

257
Changing a wiper blade
Before removing a front
wiper blade
F Within  one   minute   after   switching   off  t
he   ignition,   operate   the   wiper   stalk   to  
p

osition   the   wiper   blades   vertically   on   the  
w

indscreen.
Removing
F Raise   the   corresponding   wiper   arm.
F  U nclip   the   wiper   blade   and   remove   it.
Fitting
F Put  the   corresponding   new   wiper   blade   in  p
lace   and   clip   it.
F
 
F
old   down   the   wiper   arm   carefully.
After fitting a front wiper
blade
F Switch  on   the   ignition.
F  O perate   the   wiper   stalk   again   to   park   the  
w

iper   blades.
11
Practical information

271
*  The  maximum   power   corresponds   to   the   value   type-approved   on   a   test   bed,   under   conditions   defined   in   European   legislation  
(Directive 1 999/99/EC).
Petrol engines and gearboxes
.../1: model   fitted   with   low   rolling   resistance   tyres.
.../2:  model
  fitted   with   very   low   rolling   resistance   tyres.
Petrol engine
VTi 95Puretech 110 V Ti 120
Gearbox Manual

(5 - speed) Manual
(5 - speed) Manual

(5 - speed) Automatic

(4 - speed)
Model code:
NC... 8FR0HNZ6
HNZ6/1
HNZ6/2 5FS0
5FS9

5FS9/D
Cubic capacity (cc) 1   397
1   199
1   598
Bore   x   stroke   (mm)
77   x   72.5
75   x   90.5
77   x   85.8
Max   power*:   EU   standard   (kW)
7081 88
Max   power   engine   speed   (rpm)
6   000
5   500
6   000
Max   torque:   EU   standard   (Nm)
13 5205 160
Max   torque   engine   speed   (rpm)
4   000
1   500
4   250
Fuel UnleadedUnleaded Unleaded
Catalytic converter Ye sYe s Ye s
Engine oil capacity (in litres) 4.253.5 4.25
12
Technical data

272
*  The  maximum   power   corresponds   to   the   value   type-approved   on   a   test   bed,   under   conditions   defined   in   European   legislation  
(Directive 1 999/99/EC).
.../S:
 

model   fitted   with   Stop   &   Start.
.../1:  model
  fitted   with   low   rolling   resistance   tyres.
.../2:
 

model   fitted   with   very   low   rolling   resistance   tyres.
Petrol engine
Puretech 130 S&STHP 155
Gearbox Manual

(6- speed) EAT6 Automatic
(6- speed) ETG6 Electronic

(6- speed)
Model code:
NC... HNYM/S
HNYM/1S HNY T/S
HNY T/1S
HNY T/2S 5FV8/P
Cubic capacity (cc) 1   199
1   598
Bore   x   stroke   (mm)
70   x   90.5
77   x   85.8
Max   power*:   EU   standard   (kW)
96115
Max   power   engine   speed   (rpm)
5   500
6   000
Max   torque:   EU   standard   (Nm)
230240
Max   torque   engine   speed   (rpm)
1   750
1   400
Fuel UnleadedUnleaded
Catalytic converter Ye sYe s
Engine oil capacity (in litres) 3.54,25
Technical data

275
*  The  maximum   power   corresponds   to   the   value   type-approved   on   a   test   bed,   under   conditions   defined   in   European   legislation  
(Directive 1 999/99/EC).
Diesel engines and gearboxes
.../S: model   fitted   with   Stop   &   Start.
.../1:  model   fitted   with   low   rolling   resistance   tyres   (for   example:   MICHELIN   Energy   Saver).
.../2:
 

model   fitted   with   very   low   rolling   resistance   tyres.
Diesel engine
HDi 90HDi 90 FAP BlueHDi 100 e-HDi 115
Gearbox Manual
(5 - speed) Manual
(5 - speed) Manual
(5 - speed) Manual
(6- speed) ETG6
Electronic (6- speed)
Model code:
NC... 9HJC

9HJC/1 9HP0BHY6
BHY6/1
BHY6/2S 9HD8/S

9HD8/1S
9HD8/2S 9HD8/1PS

9HD8/ 2PS
Cubic capacity (cc) 1   560
1   560
1   560
1   560
Bore   x   stroke   (mm)
75   x   88.3 75   x   88.3 75   x   88.3
75   x   88.3
Max   power*:   EU   standard   (kW)
6868 73 84
Max   power   engine   speed   (rpm)
4   000
4   000
3   750
3   600
Max   torque:   EU   standard   (Nm)
230230254 270
Max   torque   engine   speed   (rpm)
1   750
1   750
1   750
1   750
Fuel
die
sel
die
sel
die
sel
die
sel
Catalytic converter Ye sYe sYe s Ye s
Particle filter (F
aP
)
n
o
Ye s Ye s Ye s
Engine oil capacity (in litres) 3.753.753.75 3.75
12
Technical data

276
*  The  maximum   power   corresponds   to   the   value   type-approved   on   a   test   bed,   under   conditions   defined   in   European   legislation  
(Directive 1 999/99/EC).
.../S:
 

model   fitted   with   Stop   &   Start.
.../1:
 

model   fitted   with   low   rolling   resistance   tyres   (for   example:   MICHELIN   Energy   Saver).
.../2:
 

model   fitted   with   very   low   rolling   resistance   tyres.
Diesel engine
BlueHDi 115BlueHDi 120HDi 150 FAPBlueHDi 150
Gearbox Manual
(6- speed) E AT 6
Automatic (6- speed) Manual
(6- speed) E AT 6
Automatic (6- speed) Manual
(6- speed) E AT 6
Automatic (6- speed)
Model code:
NC... BHXM/S
BHXM/1S
BHXM/2S BHX T/S
BHX T/1S
BHX T/2S BHZM/S
BHZM/1S
BHZM/2S BHZT/S
BHZ T/1S
BHZT/2S RHE8

RHE8/1 AHRM/S
AHRM/1S
AHRM/2S
Cubic capacity (cc) 1   560
1   560
1   997
1   997
Bore   x   stroke   (mm)
75   x   88.3
75   x   88.3
85   x   88 85   x   88
Max   power*:   EU   standard   (kW)
858811 011 0
Max   power   engine   speed   (rpm)
3   500
3   500
3   750
4   000
Max   torque:   EU   standard   (Nm)
300300340370
Max   torque   engine   speed   (rpm)
1   750
1   750
2   000 2   000
Fuel
die
sel
die
sel
die
sel
die
sel
Catalytic converter Ye sYe sYe sYe s
Particle filter (F
aP
)
Ye sYe sYe sYe s
Engine oil capacity (in litres) 3.753.755.256 .1
Technical data

04
Preset a station
Press on "Preset".
Select   a   radio   station   or   frequency
(refer   to   the   corresponding   section).
Select   a   number   in   the   list   to   preset   the  
previously

  chosen   radio   station.
A
 

long   press   on   a   number   presets   (memorises)  
the

  station.
o

r
a press on this button presets all of the stations
one

  after   the   other.
Recall pre-set stations
Press on Media
  to   display   the   primary   page  
then select "

Save".
RADIO
298