Page 180 of 326
178
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does not block traffic: the ground must be level,
s
table and not slippery.
Apply
the parking brake, switch off the
i
gnition and engage first gear to block
t
he wheels.
Check
that the parking brake warning
l
amps in the instrument panel come on.
The
occupants must get out of the
v
ehicle and wait where they are safe.
Ensure
that the jack is correctly
p
ositioned at one of the vehicle's
j
acking points.
Incorrect
use of the jack could cause
t
he vehicle to drop.
Never
go underneath a vehicle raised
u
sing a jack; use an axle stand.
List of operations
F Remove the bolt cover(s) using the tool 3
(depending o n v ersion).
F
S
lacken the bolts using the wheelbrace 1
o n l y. Do
not use:
-
t
he jack for any other purpose than
l
ifting the vehicle,
-
a
jack other than the one supplied
b
y the manufacturer.
Practical information
Page 181 of 326
179
F Position the foot of the jack 2 on the ground a
nd ensure that it is directly below the
f
ront A or rear B jacking point provided on
t
he underbody, whichever is closest to the
w
heel to be changed. F
E xtend the jack 2 until its head comes into contact with the jacking point A or B used; t
he vehicle's contact area A or B must engage with the central part of the head of the jack.
F
R
aise the vehicle until there is sufficient space between the wheel and the ground to admit the
s
pare (not punctured) wheel easily.
Ensure
that the jack is stable. If the ground is slippery or loose, the jack may slip or drop -
R
isk of injury!
Ensure
that the jack is positioned only at one of the jacking points A or B under the vehicle,
m
aking sure that the vehicle's contact sur face is centred on the head of the jack. Other wise
t
here is a risk of damage to the vehicle and/or of the jack dropping - Risk of injury!
9
Practical information
Page 182 of 326
180
Fitting a wheel
Fitting the spare wheel
If your vehicle is fitted with alloy wheels, when tightening the bolts on fitting, it is
n
ormal
t
o
n
otice
t
hat
t
he
w
ashers
d
o
n
ot
c
ome into contact with the spare wheel.
T
he wheel is secured by the conical
s
ur face of each bolt.
After changing a wheel
Have the tightening of the bolts and the pressure of the spare wheel checked
b
y a CITROËN dealer or a qualified
w
orkshop without delay.
Have
the punctured wheel repaired
a
nd refitted to the vehicle as soon as
p
ossible.
F
R
emove
the
bolts
and
store
them
in
a
clean
p
lace.
F
R
emove
the
wheel.
Practical information
Page 183 of 326
181
List of operations
F Put the wheel in place on the hub.
F S crew in the bolts fully by hand.
F
P
re-tighten the bolts using the
w
heelbrace
1
o
n l y. F
L ower the vehicle fully.
F F old the jack 2 and detach it.F
T ighten the bolts using the wheelbrace 1
o n l y.
F
R
efit the bolt cover(s) (depending on
v
e r s i o n).
9
Practical information
Page 184 of 326

182
Snow chains
In wintry conditions, snow chains improve traction as well as the behaviour of the vehicle when braking.
Use
only the chains designed to be fitted to the
t
ype of wheel fitted to your vehicle:
Original
t
yre
s
izeMaximum
link
size.
195/65
R159
mm
205/55
R16
205/50
R17
cannot be fitted with chains
For more information on snow chains, contact a CITROËN dealer or a qualified workshop.
Advice on installation
F If you have to fit the chains during a j
ourney, stop the vehicle on a flat sur face
o
n the side of the road.
F
A
pply the parking brake and position any
w
heel chocks to prevent movement of your
v
ehicle.
F
F
it the chains following the instructions
p
rovided by the manufacturer.
F
M
ove off gently and drive for a few
m
oments, without exceeding 30 mph
(
50 km/h).
F
S
top your vehicle and check that the snow
c
hains are correctly tightened.
Take
account
of
the
legislation
in
force
i
n your country on the use of snow
chains
and
the
maximum
running
speed
a
uthorised.
The
snow
chains
must
be
fitted
only
t
o
the
front
wheels.
They
must
never
b
e
fitted
to
"space-saver"
type
spare
w
heels.
Avoid
driving with snow chains on roads
t
hat have been cleared of snow, to
a
void damaging your vehicle's tyres and
t
he road sur face. If your vehicle is fitted
w
ith alloy wheels, check that no part of
t
he chain or its fixings is in contact with
t
he wheel rim.
It
is
strongly
recommended
that
before
y
ou
leave,
you
practise
fitting
the
snow
c
hains
on
a
level
and
dry
sur face.
Practical information
Page 188 of 326
186
Front foglamps
You can also contact a CITRoËn
dealer or a qualified workshop for the
r
eplacement of these bulbs.
F
B
elow
the
front
bumper,
unscrew
the
3
wheel
arch
liner
fixing
screws.
F
M
ove
the
wheel
arch
liner
aside
to
allow
a
ccess
to
the
front
foglamp.
F
D
isconnect
the
connector
from
the
bulb
h
older
by
pressing
on
its
tab,
located
at
the
top. F
R
emove
the
bulb
holder
by
squeezing
the
two
clips
(top
and
bottom)
with
thumb
a
nd
f
inger.
F
R
eplace
the
module
(bulb
holder
and
bulb).
To
reassemble,
carry
out
these
operations
in
r
everse
o
rder.
Practical information
Page 206 of 326

204
To w i n g
General recommendations
Observe the legislation in force in your country.
E nsure that the weight of the towing vehicle is higher than that of the towed vehicle.
The
driver must remain at the wheel of the towed vehicle and must have a valid driving licence.
When
towing a vehicle with all four wheels on the ground, always use an approved towing arm;
r
ope and straps are prohibited.
The
towing vehicle must move off gently.
When
towing a vehicle with the engine off, there is no longer any power assistance for braking
o
r steering.
In
the following cases, you must always call on a professional recovery service:
-
v
ehicle broken down on a motor way or fast road,
-
f
our-wheel drive vehicle,
-
w
hen it is not possible to put the gearbox into neutral, unlock the steering, or release the
par
king
b
rake,
-
t
owing with only two wheels on the ground,
-
w
here there is no approved towing arm available...
Procedure
for
having
your
vehicle
towed
or
for
towing
another vehicle using a removable towing eye.
The towing eye
is
stowed
under
the
boot
floor,
o
r
may
be
located
under
the
front
passenger
sea
t, d
epending o
n v
ersion.
Practical information
Page 214 of 326

212
accessories
A wide range of accessories and genuine parts is available from the CITROËN dealer network.
T hese accessories and parts are all suitable for your vehicle and benefit from CITROËN's recommendation and warranty.
"Comfort"
Door deflectors, side sun blinds, insulated module, coat hanger fixed to head restraint,
m
obile reading lamp, front and rear parking
s
ensors, portable ashtray, scented air
f
reshener, blind for sunroof...
"Transport systems"
boot carpet, boot liner, boot net, boot spacers,
transverse roof bars, ski carrier, roof box,
t
owbar, towbar wiring harness, bicycle carrier...
"Styling"
Leather gear lever knob, aluminium foot rest, alloy wheels, front spoiler, rear diffuser, exterior
e
xpressive
s
tickers...
"Security and safety":
Anti-intrusion alarm, vehicle tracking system, first aid kit, fire extinguisher, warning triangle,
h
igh visibility vest, wheel security bolts, snow
c
hains, non-slip covers, front foglamp kit, dog
g
uard, pet seat belt, seat belt cutter/glass
h
ammer...
"Protection"
Mats*, seat covers, mud flaps, vehicle cover, b oot...
If
a
towbar
and
wiring
harness
are
f
itted
outside
the
CITROËN
dealer
n
etwork,
the
installation
must
be
done
s
trictly
in
line
with
the
manufacturer's
r
ecommendations. *
T
o avoid any risk of jamming the pedals:
-
e
nsure that mats are correctly positioned
a
nd secured,
-
n
ever fit one mat on top of another.
Practical information