Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
168
cHAnGInG A BuLB
type A
All glass bulb: pull gently
as
it is fitted by pressure.
High pressure washing
Open the bonnet. T o access the bulbs, reach
behind the headlamp unit.
Carry out the operations in reverse
order
to refit each bulb and check that
the
bonnet is closed securely.type c
Halogen
bulb: release the
retaining
spring from its
housing.
type B
Bayonet
bulb: press
on the bulb then turn it
anticlockwise.
Halogen
bulbs must be changed with
the headlamp off. Wait a few
minutes
(risk of serious burns).
d
o not touch the bulb directly with your
fingers,
use lint-free cloths.
It
is normal for condensation to form
inside
the headlamps. Regular use of
the
vehicle eliminates this misting.The
bulbs must be changed with
the ignition of
f or with the battery
disconnected. Wait approximately
3 minutes
after changing the bulb
before
reconnecting the battery.
Check that the lamps operate correctly
after
each operation.
When using this type of washing
on stubborn dirt, do not persist on
the headlamps, the lamps and their
edges
to avoid damaging their coating
and
seals.
types of bulb
Various types of bulb are fitted to your vehicle.
T o remove them:
type
d
Light
emitting diode
(LED):
for replacement
of
the daytime running
lamps,
contact a
CITR
o Ë n dealer or a
qualified
workshop.
Changing a bulb
Berlingo_2_VP_en_Chap08_aide-rapide_ed02-2014
170
4. Foglamps type
c , H1 - 55W
-
Remove
the three clips and the
screw securing the wheelarch liner
,
located
below the bumper.
-
Move
the wheelarch liner upwards.
-
Remove
the foglamp by removing
the screw
, which can be accessed
via the hole provided for this
purpose
in the bumper, using a
T
orx
© 30 screwdriver.
-
Unclip the foglamp by squeezing
the
clip to release it.
-
Remove the foglamp from the outside.- Turn the yellow cover a 1/4 turn to open.- Separate the clips which secure
the base of bulb on each side to
release the bulb.
-
Remove
the bulb by pulling,
keeping
it straight.
-
Insert the new bulb, reposition the
clips around the base of the bulb
and carry out the operations in
reverse
order to put the lamp unit
and
the bumper back in position.
SIdE rEPEAtE r
type A, WY5W - 5W (amber)
-
Push the repeater towards the rear
and disengage it by pullin
g the
front.
-
Contact a CITR
o Ë n dealer to
obtain a new repeater which is a
sealed
component.
-
T
o refit, engage the repeater
towards the rear and bring it
towards
the front.
cOurtESY LAMPS
type A, 12V5W - 5W
-
Unclip the lens by sliding a
screwdriver in the slots on each
side
of the courtesy lamp.
-
Pull
the bulb out and change it.
-
Clip the lens in its housing and
ensure
that it is secured correctly.
Front /
r ear
Changing a bulb
